Page 269 of 474

267 Operation
At the gas station
At the gas station
Refuelling
The fuel filler flap is located on the
right-hand side of the vehicle towards the
rear. Locking/unlocking the vehicle with
the SmartKey or the SmartKey with
KEYLESS-GO* automatically locks/un-
locks the fuel filler flap.
Turn off the engine
by turning the SmartKey to
position0. Remove the SmartKey
from the starter switch.
by pressing the KEYLESS-GO*
start/stop button. Open the driv-
er’s door (with the driver’s door
open, starter switch is in position 0,
same as SmartKey removed from
starter switch).
Open the fuel filler flap by pushing at
the point indicated by the arrow.
The fuel filler flap springs open.
Turn the fuel cap to the left and hold on
to it until possible pressure is released.
Take off the cap and set it in the recess
on the fuel filler flap.
Only fill your tank until the filler nozzle
unit cuts out – do not top up or over-
fill.
Warning!
G
Gasoline is highly flammable and poisonous.
It burns violently and can cause serious
injury. Whenever you are around gasoline,
avoid inhaling fumes and skin contact,
extinguish all smoking materials. Never
allow sparks, flame or smoking materials
near gasoline!
Page 275 of 474

273 Operation
Engine compartment
One of the following messages will
subsequently appear in the right multi-
function display:
Engine oil level
OK
Add 1.0 qt.to reach
max.
oil level
(Canada:
1.0 l
)
Add 1.5 qts.
to reach max.oil level
(Canada:
1.5 l
)
Add 2.0 qts.to reach
max.
oil level
(Canada:
2.0 l
)
If necessary, add engine oil.
For adding engine oil see (
page 274).
For more information on engine oil, see the
“Technical data” section (
page 431) and
(
page 433).
Other display messages
If the SmartKey or the KEYLESS-GO*
start/stop button is not in position2, the
following message will appear:
Turn ignition on to
measure engine
oil level
Switch on the ignition (
page 36).If you see the message:
Observe
waiting time
If the engine is at operating tempera-
ture, wait five minutes before repeating
the check procedure.
If the engine is not at operating temper-
ature yet, wait 30 minutes before re-
peating the check procedure.
If you see the message:
Engine oil level
Not when
engine on
Turn off the engine.
If the engine is at operating tempera-
ture, wait five minutes before checking
oil.
If the engine is at operating tempera-
ture yet, you must wait 30 minutes be-
fore checking oil.
iIf you want to interrupt the checking
procedure, press thek orj
button on the multifunction steering
wheel.
Page 330 of 474

328 Practical hintsWhat to do if …Problem
Possible cause
Suggested solution
ú
(USA only)
±
(Canada only)
The yellow engine malfunction
indicator lamp comes on while
driving.
Your fuel tank is empty.
After refuelling, start, turn off, and re-
start the engine three or four times in
succession.
The limp-home mode is canceled. You
do not need to have your vehicle
checked.
D
The red coolant warning lamp
comes on when the engine is
running.
There is insufficient coolant in the reservoir.
If this warning lamp comes on frequently,
there is a leak in the cooling system.
If the coolant level is correct, the electric ra-
diator fan may be broken.
Immediately add coolant to prevent
engine from overheating
(page 276).
Have the cooling system checked.
If the coolant temperature is below
248 °F (120 °C), you can continue
driving to the nearest authorized
Mercedes-Benz Center.
Avoid high engine loads (e.g. driving
uphill) and stop-and-go driving.
D
The red coolant warning lamp
comes on while driving and you
hear a warning sound.
The coolant temperature has exceeded
248 °F (120 °C).
Stop as soon as possible and allow
the engine and coolant to cool down.
Page 344 of 474
342 Practical hintsWhat to do if …Left display
Right display
Possible cause
Possible solution
P
Gear selector
lever to P
You have tried to start the engine with
the KEYLESS-GO* start/stop button
with the gear selector lever not in P.
Place the gear selector lever in position P.
You have tried to turn off the engine
with the KEYLESS-GO* start/stop but-
ton with the gear selector lever not in
P.You have opened the driver’s door
while engine is running with the gear
selector lever not in P.
Page 349 of 474

347 Practical hints
What to do if …
Left display
Right display
Possible cause
Possible solution
T
Reduced
braking power!
Depress brake
pedal fully!
The SBC brake system is in emer-
gency operation mode. Consider-
ably greater brake pedal force is
required and the stopping distance
is increased.
The maximum speed is limited to
55 mph (90 km/h).
Do not drive any further.
Stop the vehicle and notify an authorized
Mercedes-Benz Center.
Prevent the vehicle from rolling away by
blocking the wheels with wheel chocks or oth-
er sizable objects.
Call for roadside assistance.
USA only:;Canada only:3
Reduced
brake effect
Start engine
The battery has insufficient voltage
and cannot supply sufficient power
to the SBC brake system.
Start the engine.
The message disappears when sufficient
voltage is available
Warning!
G
Inhalation of exhaust gas is hazardous to
your health. All exhaust gas contains carbon
monoxide, and inhaling it can cause uncon-
sciousness and lead to death.
Do not run the engine in confined areas
(such as a garage) which are not properly
ventilated.
Page 354 of 474

352 Practical hintsWhat to do if …
During severe operating conditions, e.g.
stop-and-go traffic, the coolant tempera-
ture may rise close to 248°F (120°C).
Left display
Right display
Possible cause
Possible solution
•
Coolant
Stop, put engine off!
The coolant is too hot.
Stop the vehicle and turn off the engine.
Only start the engine again after the message
disappears. You could otherwise damage the
engine.
Warning!
G
Driving when your engine is badly overheat-
ed can cause some fluids which may have
leaked into the engine compartment to
catch fire. You could be seriously burned.
Steam from an overheated engine can cause
serious burns and can occur just by opening
the engine hood. Stay away from the engine
if you see or hear steam coming from it.
Turn off the engine, get out of the vehicle
and do not stand near the vehicle until the
engine has cooled down.
!The engine should not be operated with
the coolant temperature above 248°F
(120°C). Doing so may cause serious
engine damage which is not covered by
the Mercedes-Benz Limited Warranty.
Page 361 of 474

359 Practical hints
What to do if …
Left display
Right display
Possible cause
Possible solution
F
Key
not detected
The SmartKey with KEYLESS-GO* is
not recognized while the engine is
running because
the SmartKey with
KEYLESS-GO* is not in the vehi-
cle
there is strong radio-frequency
interference
Stop the vehicle as soon as it is safe to do so.
Search for the SmartKey with KEYLESS-GO*
or continue to operate the vehicle with the
SmartKey.
Otherwise the vehicle cannot be centrally
locked nor can the engine be started again af-
ter the engine is stopped.
The SmartKey with KEYLESS-GO* is
momentarily not recognized.
Change the position of the SmartKey with
KEYLESS-GO* in the vehicle.
Operate the vehicle with the SmartKey if
necessary.
Key
still
in vehicle
A SmartKey with KEYLESS-GO* left
in the vehicle was recognized while
locking the vehicle from the out-
side.
Take the SmartKey with KEYLESS-GO* out of
the vehicle.
.
3rd brake lamp
The high mounted brake lamp is
malfunctioning.
Visit an authorized Mercedes-Benz Center as
soon as possible.
Brake lamp
Left
Auxiliary
lamp on!
The left brake lamp is malfunction-
ing. An auxiliary lamp has been
brought into use.
Visit an authorized Mercedes-Benz Center as
soon as possible.
Page 365 of 474

363 Practical hints
What to do if …
Left display
Right display
Possible cause
Possible solution
.
Right turn signal
Mirror
The right turn signal in the side mir-
ror is malfunctioning. This message
will only appear if all light emitting
diodes have stopped working.
Have the LEDs replaced as soon as possible.
Tail lamp
Left
Auxiliary
lamp on!
The left tail lamp is malfunctioning.
An auxiliary lamp has been brought
into use.
Visit an authorized Mercedes-Benz Center as
soon as possible.
Tail lamp
Right
Auxiliary
lamp on!
The right tail lamp is malfunction-
ing. An auxiliary lamp has been
brought into use.
Visit an authorized Mercedes-Benz Center as
soon as possible.
Turn off
lamps
You have removed the SmartKey
from the starter switch and opened
the driver’s door or removed the
SmartKey with KEYLESS-GO* from
the vehicle and left the headlamps
on.
Turn the exterior lamp switch toM.
Turn signal
Rear left
Auxiliary
lamp on!
The left rear turn signal lamp is mal-
functioning. An auxiliary lamp has
been brought into use.
Replace the bulb as soon as possible.