2005 MERCEDES-BENZ SL55AMG parking brake

382 Practical hintsReplacing bulbs
Notes on bulb replacement

Only use 12-volt bulbs of the same type
and with the specified watt rating.


Switch the lights off before changing a
bulb to prevent short circuits.


Always use a clean lint-free cloth when
handling bulbs.


Your hands should be dry and free of oil
and grease.


If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Center.Have the LEDs and bulbs for the following
lamps replaced by an authorized
Mercedes-Benz Center:


the additional turn signals in the exteri-
or rear view mirrors


the high mounted brake lamp


the brake lamps


the parking lamps and the side marker
lamps in the tail lamp unit


the rear fog lamps


the low beam (Xenon or Bi-Xenon*)
lamps


the front fog lamps
Warning!
G
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing
a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas. A
bulb can explode if you:

touch or move it when hot


drop the bulb


scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
iHave the headlamp adjustment
checked regularly.

388 Practical hintsFlat tireYour SL 65 AMG is be equipped with a
TIREFIT kit.Preparing the vehicle
Park the vehicle as far as possible from
moving traffic on a hard surface.

Turn on the hazard warning flashers.

Turn the steering wheel so that the
front wheels are in a straight ahead po-
sition.

Set the parking brake.

Move the gear selector lever to P.
Vehicles with SmartKey:

Turn off the engine (
page 58).

Remove the SmartKey from the starter
switch.Vehicles with KEYLESS-GO*:

Turn off the engine by pressing the
KEYLESS-GO* button on the gear se-
lector lever once (
page 59).

Open the driver’s door (this puts the
starter switch in position 0, same as
with the SmartKey removed from the
starter switch). The driver’s door then
can be closed again.

Have any passenger exit the vehicle at
a safe distance from the roadway.
Sealing tires with TIREFIT
Small tire punctures, particularly those in
the tread, can be sealed with TIREFIT.
TIREFIT can be used in ambient tempera-
tures down to -4°F (-20°C).
iOpen door only when conditions are
safe to do so.
Warning!
G
Keep TIREFIT away from sparks, open flame
or heat source.
Do not smoke.

393 Practical hints
Flat tire
Mounting the spare wheel Preparing the vehicle
Prepare the vehicle as described
(
page 388).

Turn spare wheel bracket counter-
clockwise to loosen.

Take the spare wheel out of the trunk.
Lifting the vehicle

Prevent the vehicle from rolling away
by blocking wheels with wheel chocks
(not included) or other sizable objects.
When changing wheel on a level sur-
face:
Place one chock in front of and one
behind the wheel that is diagonally
opposite to the wheel being
changed.
When changing wheel on a hill:

Place chocks on the downhill side
blocking both wheels of the other
axle.

Take the vehicle tool kit and the jack
out of the storage compartment under
the trunk floor (
page 372).
Warning!
G
The dimensions of the spare wheel are dif-
ferent from those of the road wheels. As a
result, the vehicle handling characteristics
change when driving with a mounted spare
wheel. Adapt your driving style accordingly.
The spare wheel is for temporary use only.
When driving with spare wheel mounted, en-
sure proper tire inflation pressure and do
not exceed vehicle speed of 50 mph
(80 km/h).
Drive to the nearest Mercedes-Benz Center
as soon as possible to have the spare wheel
replaced with a regular road wheel.
Never operate the vehicle with more than
one spare wheel mounted.
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack tubes built into
both sides of the vehicle. To help avoid per-
sonal injury, use the jack only to lift the ve-
hicle during a wheel change. Never get
beneath the vehicle while it is supported by
the jack. Keep hands and feet away from the
area under the lifted vehicle. Always firmly
set parking brake and block wheels before
raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on level surface. Be sure that the jack arm is
fully inserted in the jack tube. Always lower
the vehicle onto sufficient capacity jack-
stands before working under the vehicle.


403 Practical hints
Batteries
Disconnecting the batteries
Make sure the gear selector lever is set
to position P.

Close the retractable hardtop
(page 196).

Turn off the engine (
page 58).

Turn off all electrical consumers.

Remove the SmartKey from the starter
switch.
or

Vehicles with KEYLESS-GO*: Open the
driver’s door.

Depress the parking brake.

Open the trunk.
Warning!
G
The brake system requires electrical power
to operate.
A malfunction in the vehicle’s power supply
or electrical system may impair brake sys-
tem operation and switch it into its emer-
gency operation mode. The same applies if
battery is disconnected. To brake, the driver
must then apply significantly greater brake
pedal pressure and depress the pedal much
further to obtain the expected braking ef-
fect. If necessary, apply full pressure to the
brake pedal. Brakes are only applied to the
front wheels. Stopping distance is in-
creased! Adjust your driving style according-
ly. For more information, see “SBC brake
system” (
page 85).
Warning!
G
With a disconnected battery

you will no longer be able to turn the
SmartKey in the starter switch and
pressing the KEYLESS-GO* start/stop
button on the gear selector lever will
have no effect


the gear selector lever will remain
locked in positionP
!Always disconnect the batteries in the
order described below, even if you only
want to charge the starter battery, for
example. Otherwise the vehicle’s
electronics can be damaged.


407 Practical hints
Jump starting
The starter battery is located on the right
side of the engine compartment.
Make sure the two vehicles do not
touch.

Turn off all electrical consumers.

Apply parking brake.

Shift gear selector lever to positionP.

Remove the red cover from positive ter-
minal on both vehicles (
page 401).1Negative terminal of charged battery
2Negative terminal of discharged
battery
3Positive terminal of discharged battery
4Positive terminal of charged battery

Connect positive terminals 3 and 4
of the batteries with the jumper cables.
Clamp cable to charged battery 4
first.

Start the engine of the vehicle with the
charged battery and run at idle speed.

Connect negative terminals 1 and 2
of the batteries with the jumper cables.
Clamp cable to charged battery 1
first.

Start the engine of the disabled vehi-
cle.
You can now turn on the electrical con-
sumers. Do not turn on the lights under
any circumstances.

Remove the jumper cables first from
negative terminals 1 and 2 and then
from positive terminals 3 and 4.
You can now turn on the lights.

Have the battery checked at the near-
est Mercedes-Benz Center.
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 277).
!Never invert the terminal connections.
!Do not tow-start the vehicle.

447 Index
B
BabySmart
TM airbag deactivation
system 76, 439
BabySmartTM compatible child
seats 439
Backrest supports
Lumbar region 116
Shoulder region 116
Backrest tilt 40
Backup lamp bulbs 381
Backup lamps 385
Bar 305
BAS 79, 81, 439
Batteries, SmartKey
Changing 377
Batteries, SmartKey with KEYLESS-GO*
Changing 378
Check lamp 105
Batteries, vehicle 277
Charging 404
Disconnecting 403
For electrical consumers 277, 373,
401For starter 277, 401
Messages in display 345, 346
Reconnecting 405
Removing 404
Service 401
Battery
For electrical consumers 373
Bead 305
Bi-Xenon* 439
Bi-Xenon* headlamps 439
Block heater 310
Brake fluid 269, 431, 433
Brake lamp bulb, high mounted 381
Brake lamp bulbs, left and right 381
Brake pads
Message in display 346
Brake system
Messages in display 350
Brakes 256
High-performance brake system (SL 65
AMG only) 258
Warning lamp 326Break-in period 254
Bulbs, replacing
Backup lamps 385
Brake lamps 381
Front lamps 380, 383
License plate lamps 385
Parking lamps 384
Rear fog lamp 385
Standing lamps 384
Tail lamp assemblies 385
Turn signal lamps, front 383
Turn signal lamps, rear 385
C
CAC see Customer Assistance Center
CAN System 440
Capacities
Fuels, coolants, lubricants etc. 431
Catalytic converter 265
CD player
Operating 141

458 IndexOperating
CD player 141
Navigation system 142
Radio 140
Telephone* 161
Overhead control panel 31
Overspeed range 132, 442
P
Panic alarm 78
Panic button on SmartKey 78
Panorama roof*
Sunshade 203
Sunshade closing 204
Sunshade opening 204
Parcel net in passenger footwell 231
Parcel net in trunk 231
Parktronic* deactivation switch 30
Parking 259
Parking assistance (Parktronic*) 223
Parking brake
Engaging 57
Releasing 50
Parking brake pedal 23Parking lamps 381
Replacing the bulbs 384
Switching on 123
Parking position
Exterior rear view mirrors 121, 158,
179
Parktronic* 30, 223, 442
Activating 226
Cleaning system sensors 318
Deactivating 226
Malfunctioning 227
Minimum distance 225
Range 224
Rear sensors 225
System sensors 318
Warning indicators 23, 225
Parts service 416
Passenger side
Front airbag 68
Head-thorax airbag 69
Parcel net in footwell 231Pedals 255
Phone book* 162
Loading 163
Quick search 163
Phone number*
Dialing 162
Redialing 163
Plastic and rubber parts
Cleaning 321
Poly-V-belt drive 442
Layout 419
Potential problems associated with under-
inflated and overinflated tires 294
Power assistance 256
Power seat
Adjusting backrest tilt 41
Adjusting head restraint height 41
Adjusting head restraint tilt 41
Adjusting seat cushion depth 41
Adjusting seat cushion tilt 41
Adjusting seat height 41