2005 MERCEDES-BENZ ML500 parking brake

284 Practical hintsFlat tireMounting the spare wheel Preparing the vehicle

Park the vehicle as far as possible from
moving traffic on a hard surface.

Turn on the hazard warning flashers.

Engage the steering wheel lock in the
straight ahead position.

Set the parking brake.

Move the gear selector lever toP.

Have any passenger exit the vehicle at
a safe distance from the roadway.

Take the spare wheel out of its carrier
(page 266).Lifting the vehicle

Prevent the vehicle from rolling away
by blocking wheels with wheel chocks
(not included) or other sizable objects.
When changing wheel on a level surface:

Place one chock in front of and one be-
hind the wheel that is diagonally oppo-
site to the wheel being changed.
When changing wheel on a hill:

Place chocks on the downhill side
blocking both wheels of the other axle.

Take the two-piece wheel wrench and
the jack out of the rear cargo compart-
ment (
page 264). Assemble wheel
wrench.
Warning!
G
The dimensions of the spare wheel are dif-
ferent from those of the road wheels. As a
result, the vehicle handling characteristics
change when driving with a mounted spare
wheel. Adapt your driving style accordingly.
The spare wheel is for temporary use only.
When driving with spare wheel mounted,
make sure proper tire pressure and do not
exceed vehicle speed of 50 mph (80 km / h).
Drive to the nearest Mercedes-Benz Light
Truck Center as soon as possible to have the
spare wheel replaced with a regular road
wheel.
Never operate the vehicle with more than
one spare wheel mounted.
iOpen door only when conditions are
safe to do so.

285 Practical hints
Flat tire

On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with
wrench).
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.1Take-up bracket
2Jack

Place jack on firm ground.

Position jack2 under the take-up
bracket1 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an in-
cline.

Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while vehi-
cle is raised.
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on level surface. Make sure that the jack
arm is fully seated in the jack take-up brack-
et. Always lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.
!Do not position the jack on the body of
the vehicle, as this may cause damage
to the vehicle.

289 Practical hints
Battery
Disconnecting the battery
Depress parking brake firmly or move
gear selector lever to positionP.

Turn off all electrical consumers.

Remove key from the steering lock.

Open the hood (
page 222).

Disconnect the battery negative lead.

Remove the cover from the positive ter-
minal.

Disconnect the battery positive lead.
Removing the battery
Remove the screw securing the
battery.

Remove the battery support and
bracket.

Take out the battery.
Charging and reinstalling the battery
Charge battery in accordance with the
instructions of the battery charger
manufacturer.

Reinstall the charged battery. Follow
the previously described steps in re-
verse order.
Reconnecting the battery
Turn off all electrical consumers.

Connect the positive lead and fasten its
cover.

Connect the negative lead.
Warning!
G
With a disconnected battery

you will no longer be able to turn the key
in the steering lock


the gear selector lever will remain
locked in positionP
Warning!
G
Never charge a battery while still installed in
the vehicle. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.
!Never invert the terminal connections!!The battery, its filler caps and the vent
tube must always be securely installed
when the vehicle is in operation.

292 Practical hintsJump startingThe battery is located on the passenger
side of the engine compartment.
Make sure the two vehicles do not
touch.

Turn off all electrical consumers.

Apply parking brake.

Shift gear selector lever to positionP.

Open the hood.1Positive terminal of charged battery
2Negative terminal of charged battery
3Negative terminal of discharged
battery
4Positive terminal of discharged battery

Connect positive terminals1 and4
of the batteries with the jumper cable.
Clamp cable to positive terminal1 of
charged battery first.

Start engine of the vehicle with the
charged battery and run at idle speed.

Connect negative terminals2 and3
of the batteries with the jumper cable.
Clamp cable to negative terminal2 of
charged battery first.

Start the engine of the disabled vehi-
cle.
Now you can turn on the electrical
consumers. Do not turn on the lights under
any circumstances.

Remove the jumper cables first from
the negative terminals3 and2 and
then from positive terminals4
and1.
You can now turn on the lights.

Have the battery checked at the
nearest authorized Mercedes-Benz
Light Truck Center.
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 228).
!Never invert the terminal connections!
!Do not tow-start the vehicle.

326 Technical termsParktronic (Parking assist)*
System which uses visual and acoustic
signals to assist the driver during park-
ing maneuvers.
Poly-V-belt drive
Drives engine-components (alternator,
AC compressor, etc.) from the engine.
Power train
Collective term designating all compo-
nents used to generate and transmit
motive power to the drive axles, includ-
ing


engine


clutch / torque converter


transmission


transfer case


drive shaft


differential


axle shafts / axlesRemote Vehicle Diagnostics
Transmission of vehicle data and cur-
rent location to the Mercedes-Benz
Customer Assistance Center for sub-
scribers to Tele Aid service.
REST
(Residual engine heat utilization)
Feature that uses the engine heat
stored in the coolant to heat the vehi-
cle interior for a short time after the en-
gine has been turned off.
Restraint system
Seat belts, belt tensioner, airbags and
child seat restraint systems. As inde-
pendent systems, their protective func-
tions complement one another.RON
(R
esearch O
ctane N
umber)
The Research Octane Number for gaso-
line as determined by a standardized
method. It is an indication of a gaso-
line's ability to resist undesired detona-
tion (knocking). The average of both
the ->MON (Motor Octane Number)
and RON (Research Octane Number) is
posted at the pump, also known as
ANTI-KNOCK INDEX.
Shift lock
When the vehicle is parked, this lock
prevents the transmission selector le-
ver from being moved out of positionP
without key turned and brake pedal de-
pressed.
SRS
(S
upplemental R
estraint S
ystem)
Seat belts, emergency tensioning de-
vice and airbags. Though independent
systems, they are closely interfaced to
provide effective occupant protection.

331 Index
Automatic headlamp mode 108
Automatic interior lighting control
Activating 114
Deactivating 114
Automatic locking when driving 93
Automatic transmission
Accelerator position 124
Emergency operation
(Limp Home Mode) 126
Gear ranges 122
Gear selector lever position 123
Gear shifting malfunctions 126
Kickdown 124
Manual shifting 121
One-touch gearshifting 121
Selector lever position 120
Towing a trailer 125
Transmission fluid 227
B
BabySmart
TM
Airbag deactivation system 70
Compatible child seats 70, 323
Self-test 70
BabySmart
TM airbag
deactivation system 323Backrest tilt 36
Backup lamps 275, 279
Bulbs 275
BAS 78, 323
Malfunction indicator lamp 251, 252,
253
Warning lamp 251
Batteries, remote control
Replacing 273
Battery discharged
Jump starting 291
Battery indicator lamp
Indicator lamp 261
Battery, vehicle 228, 272
Charging 289
Disconnecting 289
Reconnecting 289
Reinstalling 289
Removing 289
Bi-Xenon headlamps* 323
Block heater (Canada only) 236
Blocking
Rear door window operation 74
Brake assist system (BAS) 323
Brake fluid 314
Brake lamp bulbs 275Brake pad wear
Indicator lamp 261
Brakes 198
Warning lamp 250
Break-in period 196
Bulbs, replacing 274
Additional turn signals 274
Backup lamps 275
Brake lamps 275
Fog lamps 274
Front fog lamp 279
Front lamps 274
High beam 274
High mounted brake lamp 281
License plate lamps 275, 281
Low beam 274
Parking, standing lamp 274
Rear fog lamps 279
Rear side marker lamp bulbs 279
Side marker lamps 274, 275
Standing lamps 274
Tail lamp assemblies 279
Turn signal lamps 274, 275
Turn signal, side marker lamp 274

342 IndexOpening and closing
Side windows 146
Operating
Garage door opener 188
Integrated remote control 188
Radio transmitters 216
Vehicle outside the USA or
Canada 13
Operating safety 17
Operator’s Manual 10
Ornamental moldings 242
Outside temperature indicator 119
Overdue service 238
Overhead control panel 29
P
Paintwork 241
Panic alarm 75
Panic button on remote control 75
Parking 200
Parking and locking 54
Parking brake 48, 54
Engaging 54
Releasing 48
Parking lamps
Switching on 107Parking, standing lamp
Replacing bulbs 274
Parktronic (Parking assist)* 326
Parktronic system*
Switching off 159
Switching on 159
Parktronic* 156
Cleaning system sensor 243
Range of the sensors 157
Sensor cover 243
Switching off 159
Switching on 159
Warning indicators 158
Partition net* 162
Engaging 162
Removing 164
Tightening 163
Parts see Parts service
Parts service 302
Passenger compartment 215
Interior lighting 114
Passenger footwell
Fuse box in 299
Passenger safety see Occupant safety
Pedals 197Plastic and rubber parts
Cleaning 245
Poly-V-belt drive 326
Layout 305
Positions (Memory function*)
Recalling from memory 106
Storing into memory 106
Power assistance 197
Power seat*
Adjusting backrest tilt 39
Adjusting head restraint height 39
Adjusting seat cushion tilt 39
Adjusting seat height 39
Seat fore and aft adjustment 38
Power tilt/sliding sunroof* 150
Closing 271
Opening 271
Power train 326
Power washer 241
Power windows
Blocking of rear door window
operation 74
Side windows 146
Synchronizing 148

350 IndexVehicle care
Cup holder 244
Engine cleaning 242
Gear selector lever 244
Hard plastic trim items 244
Headlamps 242
Instrument cluster 244
Leather upholstery 245
Light alloy wheels 244
MB Tex upholstery 245
Ornamental moldings 242
Paintwork 241
Parktronic* system sensor 243
Plastic and rubber parts 245
Power washer 241
Seat belts 244
Steering wheel 244
Tail lamps 242
Tar stains 241
Turn signals 242
Upholstery 245
Vehicle washing 242
Window cleaning 243
Wiper blades 243Vehicle identification number (VIN) 304
Vehicle jack 265
Vehicle lighting
Checking 221
Vehicle tool kit 264
Vehicle with CD-changer* 265
Vehicle washing 242
VIN (Vehicle Identification Number) 304,
327
Voice control system* 327
W
Warning indicators
Parktronic* 158
Warning sounds
Drivers seat belts 64
Parking brake 49
Warranty coverage 303
Washer fluid see Windshield washer fluid
Washing the vehicle 240
Wear pattern (tires) 233
Weights 311
Wheel bolt wrench 265Wheel change
Tightening torque 287
Wheels
Rotating 233
Window curtain airbags 64
Windows see Side windows
Windshield
Defogging 140
Refilling washer fluid 230
Replacing wiper blades 283
Washer fluid 230, 319
Washer system 319
Windshield washer fluid 319
Mixing ratio 319
Refilling 230
Wiping with 51
Windshield washer system 319