Page 378 of 491
377 Practical hints
What to do if …
Display symbol
Display messages
Possible cause
Possible solution
(USA only);(Canada only)3
Brake fluid
Visit workshop
There is insufficient brake fluid in the
reservoir.
Risk of accident! Stop the vehicle and
notify an authorized Mercedes-Benz
Center. Do not add brake fluid! This
will not solve the problem.
Warning!
G
Driving while these messages are displayed
can result in an accident. Have your brake
system checked immediately.
If there is a malfunction in the SBC brake
system, we recommend that the vehicle be
transported with all wheels off the ground
using flatbed or appropriate wheel lift / dolly
equipment.
A tow bar must be used if circumstances do
not permit the use of the recommended
towing methods and the vehicle requires
towing with all four wheels on the ground.
Towing the vehicle with all four wheels on
the ground is only permissible for distances
u p t o 3 0 m i l e s ( 5 0 k m ) a n d a t a s p e e d n o t t o
exceed 30 mph (50 km / h). For more infor-
mation, refer to “Towing the vehicle”
(page 430).
If the SBC brake system enters its emergen-
cy operation mode, the driver must apply
significantly greater brake pedal pressure
and depress the pedal much further than
normal to obtain braking effect. If neces-
sary, apply full pressure to the brake pedal.
Brakes may only be applied to the front
wheels. Stopping distance is increased!
Do not add brake fluid before checking the
brake system. Overfilling the brake fluid res-
ervoir can result in spilling brake fluid on hot
engine parts and the brake fluid catching
fire. You can be seriously burned.!If you find that the brake fluid in the
brake fluid reservoir has fallen to the
minimum mark or below, have the
brake system checked for brake pad
thickness and leaks.
Page 379 of 491
378 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause
Possible solution
?
(USA only)
±
(Canada only)
Visit workshop
There may be a malfunction in the:
fuel injection system
ignition system
exhaust system
fuel system
Have the measuring system checked
by an authorized Mercedes-Benz
Center.
B
Coolant
Check level
The coolant level is too low.
Add coolant (
page 303).
If you have to add coolant frequently,
have the cooling system checked by
an authorized Mercedes-Benz Center.
Warning!
G
Do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts. You can be seriously burned.
!Do not ignore the low engine coolant
level warning. Extended driving with
the message and symbol displayed
may cause serious engine damage not
covered by the Mercedes-Benz Limited
Warranty.
Do not drive without sufficient amount
of coolant in the cooling system. The
engine will overheat causing major en-
gine damage.
Page 380 of 491
379 Practical hints
What to do if …
During severe operation conditions and
stop-and-go city traffic, the coolant tem-
perature may rise close to 248°F (120°C).
Display symbol
Display messages
Possible cause
Possible solution
Ï
Coolant
Stop, engine off
The coolant is too hot.
Stop the vehicle.
Only start the engine again after the
message disappears. You could other-
wise damage the engine.
Warning!
G
Driving when your engine is badly overheat-
ed can cause some fluids which may have
leaked into the engine compartment to
catch fire. You could be seriously burned.
Steam from an overheated engine can cause
serious burns and can occur just by opening
the engine hood. Stay away from the engine
if you see or hear steam coming from it.
Turn off the engine, get out of the vehicle
and do not stand near the vehicle until the
engine has cooled down.
!The engine should not be operated with
the coolant temperature above 248°F
(120°C). Doing so may cause serious
damage which is not covered by the
Mercedes-Benz Limited Warranty.
Page 381 of 491
380 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause
Possible solution
Ï
Coolant
Stop, engine off
The poly-V-belt could be broken.
Stop immediately and check the
poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise
the engine will overheat due to an in-
operative water pump which may re-
sult in damage to the engine. Notify
an authorized Mercedes-Benz Center.
If it is intact:
Do not continue to drive the vehicle
with this message displayed. Doing so
could result in serious engine damage
that is not covered by the
Mercedes-Benz Warranty.
Drive immediately to the nearest au-
thorized Mercedes-Benz Center.
Coolant
Visit workshop
The cooling fan for the coolant is malfunc-
tioning.
Observe the coolant temperature dis-
play.
Have the fan replaced as soon as pos-
sible.
Page 382 of 491
381 Practical hints
What to do if …
Display symbol
Display messages
Possible cause
Possible solution
G
Display malfunction
Visit workshop
The displays for several systems have
malfunctioned. Some systems them-
selves may also have malfunctioned.
Continue driving with added caution.
When the display is malfunctioning,
warnings and malfunction messages
might not be displayed.
Have the electronic systems checked
by an authorized Mercedes-Benz
Center.
±
Display malfunction
Visit workshop
Certain electronic systems are unable to
relay information to the control system.
The following systems may have failed:
Coolant temperature display
Tachometer
Cruise control display
Have the electronic systems checked
by an authorized Mercedes-Benz
Center.
J
Doors open
You are attempting to drive with one or
more doors open.
Close the doors.
Page 383 of 491
382 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause
Possible solution
:
USA only:Add 1 Qt. engine oil
at next refuelingCanada only:Add 1 Liter engine oil
at next refueling
The engine oil level is too low.
Add engine oil (
page 302) and
check the engine oil level
(
page 301).
Engine oil level
Stop, engine off
There is no oil in the engine. There is a
danger of engine damage.
Carefully bring the vehicle to a halt as
soon as possible.
Turn off the engine.
Add engine oil (
page 302) and
check the engine oil level
(
page 301).
Engine oil level
Reduce oil level
You have added too much engine oil.
There is a risk of damaging:
the engine
the catalytic converter
Have oil siphoned or drained off. Ob-
serve all legal requirements with re-
spect to its disposal.
Page 384 of 491
383 Practical hints
What to do if …
When the
Engine oil - Visit workshop
message appears while the engine is run-
ning and at operating temperature, the en-
gine oil level has dropped to approximately
the minimum level.
When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further.If no oil leaks are noted, continue to drive
to the nearest service station where the
engine oil should be topped to the required
level with an approved oil specified in the
Factory Approved Service Products pam-
phlet.
Display symbol
Display messages
Possible cause
Possible solution
:
Engine oil
Visit workshop
The engine oil has dropped to a critical
level.
Check the engine oil level
(page 301) and add oil as required
(page 302).
If you must add engine oil frequently,
have the engine checked for possible
leaks.
It may be that there is water in the engine
oil.
Have the engine oil checked.
Engine oil level
Visit workshop
The measuring system is malfunctioning.
Have the measuring system checked
by an authorized Mercedes-Benz
Center.!The engine oil level warnings should
not be ignored. Extended driving with
the symbol displayed could result in
serious engine damage that is not
covered by the Mercedes-Benz Limited
Warranty.
Page 385 of 491
384 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause
Possible solution
%
Hood open
You are driving with the hood open.
Close the hood (
page 299).
F
Key
Check battery
The SmartKey with KEYLESS-GO* batter-
ies are discharged.
Change the batteries (
page 408).
Key
not recognized
The SmartKey with KEYLESS-GO* is not
recognized while the engine is running
because
the SmartKey with KEYLESS-GO* is
not in the vehicle
there is strong radio-frequency inter-
ference
Stop the vehicle as soon as it is safe
to do so.
Search for the SmartKey.
Otherwise the vehicle cannot be cen-
trally locked nor can the engine be
started again after the engine is
stopped.
Key
not recognized
The SmartKey with KEYLESS-GO* is mo-
mentarily not recognized.
Change the position of the SmartKey
in the vehicle.
Operate the vehicle with the
SmartKey in the starter switch if nec-
essary.
Key
still in vehicle
A SmartKey with KEYLESS-GO* left in the
vehicle was recognized while locking the
vehicle from the outside.
Take the SmartKey out of the vehicle.
Keyless Go
Check system
The KEYLESS-GO* system is malfunction-
ing.
Visit an authorized Mercedes-Benz
Center as soon as possible.
