Page 54 of 491

53 Getting started
Driving
Intermittent wiping
Turn the combination switch to
positionI.
Single wipe
Press switch briefly in the direction of
arrow1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
Push switch in the direction of
arrow1 past the resistance point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
page 306).
!Do not leave windshield wipers in inter-
mittent setting when the vehicle is tak-
en to an automatic car wash or during
windshield cleaning. Wipers will oper-
ate in the presence of water sprayed on
the windshield, and wipers may be
damaged as a result.
The combination switch should not be
left in intermittent setting as the wipers
will wipe the windshield once every
time the engine is started. Dust that ac-
cumulates on the windshield might
scratch the glass and / or damage the
wiper blades when wiping occurs on a
dry windshield.
iIntermittent wiping is interrupted when
the vehicle is at a standstill and a front
door is opened.
!If anything blocks the windshield wip-
ers (leaves, snow, etc.), switch them off
immediately.
For safety reasons,
turn off the engine by turning
the SmartKey to position0 and
withdraw SmartKey from starter
switch
or
turn off the engine by pressing
the KEYLESS-GO* start/stop
button and open the driver’s
door (with the driver’s door
open, starter switch is in
position0, same as with
SmartKey removed from starter
switch)
before attempting to remove any
blockage.
Page 55 of 491
54 Getting startedDriving
Rear window wiper / washer
The switch is located on the center con-
sole.
1Intermittent wipe
2Indicator lamp
3Rear window washer system
Activating intermittent wipe
Switch on the ignition (
page 34)
Press upper section1 of the switch.
Indicator lamp2 comes on.Deactivating intermittent wipe
Press upper section1 of the switch
again.
Indicator lamp2 goes out.
Wiping with window washer fluid
Press and hold lower half3 of the
switch.
The rear window is wiped for a further
five seconds after the switch is re-
leased.
Remove blockage.
Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch positionI,
set the combination switch to the
next highest wiper speed
have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center
Page 487 of 491

486 Index
Tar stains 346
Vehicle washing 346
Window cleaning 348
Wood trims 350
Vehicle level
Changing 246
Setting 246
Automatic 246
Manual 246
Vehicle level control system*
Airmatic DC* 244
Vehicle loading terminology 332
Vehicle maximum load on the tire 335
Vehicle status message memory
Calling up 161
Vehicle tool kit 403
Alignment bolt 403
Fuse extractor 403
Hex-socket wrench 403
Open-end wrench 403
Screwdriver 403
Spare fuses 403
Towing eye bolt 403
Universal pliers 403
Wheel wrench 403Vehicle tool kit, jack and spare
wheel 401
Vehicle washing 346
VIN (Vehicle Identification Number) 464
Voice control system* 464
W
Warning lamps see Lamps, indicator and
warning
Warning sounds
Distance warning function* 240
Distronic* 234
Drivers seat belts 69
Parking brake 50
Warranty coverage 439
Washing the vehicle 344
Wear pattern (tires) 336
Weights 449
Wheel change 419
Tightening torque 422
Wheels
Tires and wheels 307
Window curtain airbags 68
Windshield
Defogging 202, 203, 215
Refilling washer fluid 306
Replacing wiper blades 417Washer fluid 306
Windshield washer fluid
Message in display 399
Refilling 306
Wiping with 53
Windshield wipers 52
Fast wiper speed 52
Intermittent wiping 52
Replacing wiper blades 416, 417
Single wipe 53
Switching on 52
Wiping with windshield washer
fluid 53
Winter driving
Block heater* 338
Snow chains 338
Tires 337
Winter tires 337
Winter driving instructions 291
Winter tires 337
Wiper blades 347
Installing 417
Removing 417
Replacing 417