2005 MERCEDES-BENZ CLK55AMG CABRIOLET parking brake

393 Practical hints
Where will I find...?
Vehicle jackThe vehicle jack is located in the storage
compartment underneath the trunk floor.
Storage position
Remove vehicle jack from its
compartment.

Push crank handle up.
Operational position
Turn the crank handle clockwise until it
engages (operational position).
Before storing the vehicle jack in its com-
partment:


It should be fully collapsed


The handle must be folded in (storage
position)
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on a level surface. Make sure the jack arm is
fully seated in the jack take-up bracket.
Always lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.

404 Practical hintsOpening/closing in an emergency
Engage parking brake.

Lower the side windows.

Lower rear head restraints
(page 115).

For safety reasons, remove SmartKey
from starter switch.

Open the trunk.

Remove the trunk floor cover.

Take the two straps for soft top emer-
gency operation out of vehicle tool kit
(page 391).

Take hex wrench out of its storage
location in the storage well casing.

Open the left side trim panel in the
trunk.1Locking mechanism

Pull locking mechanism1 out until it
stops and rotate it approx. one-quarter
of a turn.

Make sure the locking mechanism
does not retract again. If this happens,
pull the locking mechanism out again
and rotate it approx. one-quarter of a
turn.
iIf the rear head restraints cannot be
lowered using the rear head restraint
lowering switch, the roll bars may have
been released. For more information,
see “Operating roll bars manually”
(page 401).

415 Practical hints
Replacing bulbs
Rear lamps Notes on bulb replacement


Only use 12 volt bulbs of the same type
and with the specified watt rating.


Switch lights off before changing a bulb
to prevent short circuits.


Always use a clean lint-free cloth when
handling bulbs.


Your hands should be dry and free of oil
and grease.


If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Center.


Have the LEDs and bulbs for the follow-
ing lamps replaced by an authorized
Mercedes-Benz Center.

Additional turn signal lamps in the
exterior rear view mirrors


High mounted brake lamp


Bi-Xenon* lamps


Front fog lamps
Lamp
Type
7
High mounted brake
lamp
LED
8
Brake lamp
P 21 W
9
Turn signal lamp
P 21 W
a
Tail, parking and stand-
ing lamp, side marker
P 21/4 W
W 5 W
b
Backup lamp
P 21 W
c
License plate lamps
C 5 W
d
Rear fog lamp, driver’s
side
P 21/4 W
Warning!
G
Keep bulbs out of reach of children.
Bulbs and bulb sockets can be very hot. Al-
low the lamp to cool down before changing
a bulb.
Halogen lamps contain pressurized gas. A
bulb can explode if you:

touch or move it when hot


drop the bulb


scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.iHave the headlamp adjustment
checked regularly.

422 Practical hintsFlat tire
Preparing the vehicle
Park the vehicle as far as possible from
moving traffic on a hard surface.

Turn on the hazard warning flashers
(page 127).

Turn the steering wheel so that the
front wheels are in a straight ahead
position.

Set the parking brake (
page 55).

Move the gear selector lever toP.
Vehicles with SmartKey:

Turn off the engine (
page 56).

Remove the SmartKey from the starter
switch.Vehicles with SmartKey with
KEYLESS-GO*:

Turn off the engine by pressing the
KEYLESS-GO* start/stop button on the
gear selector lever once (
page 57).

Open the driver’s door (this puts the ig-
nition in position0, same as with the
SmartKey removed from the starter
switch). The driver’s door then can be
closed again.

Have any passenger exit the vehicle at
a safe distance from the roadway.
Warning!
G
The dimensions of the Minispare wheel are
different from those of the road wheels. As
a result, the vehicle handling characteristics
change when driving with a Minispare wheel
mounted. Adapt your driving style
accordingly.
The spare wheel is for temporary use only.
When driving with spare wheel mounted,
ensure proper tire inflation pressure and do
not exceed a vehicle speed of 50 mph
(80 km/h).
Drive to the nearest Mercedes-Benz Center
as soon as possible to have the spare wheel
replaced with a regular road wheel.
Never operate the vehicle with more than
one spare wheel mounted.
iOpen door only when conditions are
safe to do so.

423 Practical hints
Flat tire
Mounting the Minispare wheel
Preparing the vehicle
Prepare the vehicle as described on
(page 422).

Take the wheel wrench and the jack
out of the trunk (
page 394).

Take the Minispare wheel and wheel
bolts out of the trunk (
page 394).
Lifting the vehicle

Prevent the vehicle from rolling away
by blocking wheels with wheel chocks
or other sizable objects.
One wheel chock is included with the
vehicle tool kit (
page 391).
When changing wheel on a level surface:

Place the wheel chock in front of and
another sizable object behind the
wheel that is diagonally opposite to the
wheel being changed.
When changing wheel on a hill:

Place the wheel chock and another
sizable object on the downhill side
blocking both wheels of the other axle.
1Wheel wrench

On wheel to be changed, loosen but do
not yet remove the wheel bolts (ap-
proximately one full turn with wrench).
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack
on a level surface. Make sure the jack arm is
fully seated in the jack take-up bracket. Al-
ways lower the vehicle onto sufficient ca-
pacity jackstands before working under the
vehicle.

431 Practical hints
Jump starting
The battery is located on the right side of
the engine compartment. For jump start-
ing use the terminals in front of the bat-
tery.
Make sure the two vehicles do not
touch.

Turn off all electrical consumers.

Apply parking brake.

Shift gear selector lever to positionP.

Open the hood.1Positive terminal of charged battery
2Positive under hood terminal in front of
discharged battery
3Negative under hood terminal in front
of discharged battery
4Negative terminal of charged battery

Connect the positive terminal1 of the
charged battery with the positive under
hood terminal 2 in front of the dis-
charged battery with the jumper cable.
Clamp cable to charged battery1
first.

Start engine of the vehicle with the
charged battery and run at idle speed.

Connect the negative terminal4 of
the charged battery with the negative
under hood terminal 3 in front of the
discharged battery with the jumper ca-
ble. Clamp cable to charged battery4
first.

Start the engine of the disabled vehi-
cle.
You can now turn on the electrical con-
sumers. Do not turn on the lights under
any circumstances.

Remove the jumper cables first from
the negative terminals3 and4 and
then from the positive terminals2
and1.
You can now turn on the lights.

Have the battery checked at the near-
est authorized Mercedes-Benz Center.
Warning!
G
Keep flames or sparks away from battery.
Do not smoke.
Observe all safety instructions and precau-
tions when handling automotive batteries
(page 311).
!Never invert the terminal connections.
!Do not tow-start the vehicle.

470 IndexBlocking
Rear window operation 82
Bolts
For Minispare wheel 396
Brake assist system (BAS) 461
Brake fluid 456
Message in display 375
Brake lamp bulbs 415
Brake lamp, high mounted 415
Brake pads
Message in display 375
Brakes 292
Warning lamp 355
Break-in period 290Bulbs, replacing 414
Additional turn signals 414
Backup lamps 415
Brake lamps 415
Fog lamps 414
Front lamps 414
High beam (Bi-Xenon*) 414
High beam (Halogen) 414
High beam flasher (Bi-Xenon*) 414
High beam flasher (Halogen) 414
High mounted brake lamp 415
License plate lamps 415, 420
Low beam (Bi-Xenon*) 414
Low beam (Halogen) 414
Parking lamps 414, 415, 417, 419
Rear fog lamp 415, 420
Side marker lamps 414, 419
Standing lamps 414, 415, 417, 419
Tail lamp assemblies 415, 420
Turn signal lamps 414, 415
Button
Audio system 204C
CAC (Customer Assistance Center) 461
Calling up
Maintenance service indicator 343
Range (distance to empty) 159
CAN system 461
Canceling
Cruise control 257
Capacities
Fuels, coolants, lubricants, etc. 453
Catalytic converter 300
CD changer* 218
CD changer* operation 220
CD operation 218
CD player
Operating 140
Center console 27
Front passenger front
air bag off indicator lamp 361
Lower part 28
Upper part 27
Centigrade
Setting temperature units 145

480 IndexLamps, indicator and warning
ABS 354
Battery (SmartKey) 96, 102
Brakes 355
Center console 361
CHECK ENGINE 356
Coolant 357, 376
Engine diagnostics 356
ESP 358
Front passenger front
air bag off indicator lamp 66, 361
Fuel reserve 359
Instrument cluster 354–360
Maintenance service indicator 342
Parktronic system*
warning indicators 262
Roll bar 359
Seat belts 359
SRS 61, 360
Turn signals 25
Language
Multifunction display 146
Setting 146
LATCH child seat anchors 80
Folding back 81Layout of poly-V-belt drive 443
Leather upholstery
Cleaning 352
Lever
For cruise control 255
License plate lamps
Messages in display 384
Replacing bulbs 415, 420
Light alloy wheels
Cleaning 350
Technical data 446
Light sensor 384
Lighter see Cigarette lighterLighting 122
Automatic headlamp mode 123
Combination switch 126
Daytime running lamp mode 124
Door entry lamps 129
Exterior lamp switch 122
Front fog lamps 125
High beam flasher 126
High beams 126
Instrument cluster illumination 130
Interior 128
Locator lighting 124
Low beam 122
Manual headlamp mode 123
Night security illumination 124
Parking lamps 122
Rear fog lamp 125
Settings (control system) 151
Limiting the gear range 166
Limp Home Mode 175
Loading 264
Instructions 268
Ski sack* 264
Loading terminology 335
Loading the vehicle 316