2005 MERCEDES-BENZ C240 remote control

256 Controls in detailUseful featuresStolen Vehicle Recovery services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered
incident report.

Pass this number on to the
Mercedes-Benz Response Center along
with your password issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is
located, the Response Center will
contact the local law enforcement and
you. The vehicle’s location will only be
provided to law enforcement.
Garage door opener*
The built-in remote control is capable of
operating up to three separately controlled
devices, for example garage door openers,
gate openers, or other devices compatible
with HomeLink
® or some other systems.
You can program the signal transmitter
buttons.
Remote control integrated into the interior
rear view mirror1Indicator lamp
2 3 4Signal transmitter button
5Hand-held transmitter button
6Hand-held remote control
transmitter (not part of the
vehicle equipment)
iWhen the anti-theft alarm or the
tow-away alarm stays on for more than
30 seconds, a call is initiated automat-
ically to the Response Center. See
anti-theft alarm system* (
page 83)
and tow-away alarm* (
page 85).

257 Controls in detail
Useful features
Warning!
G
Before programming the integrated remote
control to a garage door opener or gate
operator, make sure people and objects are
out of the way of the device to prevent po-
tential harm or damage. When programming
a garage door opener, the door moves up or
down. When programming a gate operator,
the gate opens or closes.
Do not use the integrated remote control
with any garage door opener that lacks
safety stop and reverse features as required
by U.S. federal safety standards (this
includes any garage door opener model
manufactured before April 1, 1982).
A garage door that cannot detect an object
- signaling the door to stop and reverse -
does not meet current U.S. federal safety
standards.
iCertain types of garage door openers
are incompatible with the integrated
opener. If you should experience
difficulties with programming the
transmitter, contact an authorized
Mercedes-Benz Center, or call
Mercedes-Benz Customer Assistance
Center (in the USA only) at
1-800-FOR-MERCedes, or Customer
Service (in Canada) at
1-800-387-0100.
iFor operation in the USA only:
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.

258 Controls in detailUseful featuresProgramming or reprogramming the
integrated remote control
Step 1:
Switch on ignition (
page 33).
Step 2:

If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when the indicator lamp1
begins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.Step 3:

Hold the end of the hand-held remote
control transmitter6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control
located on the interior rear view mirror,
keeping the indicator lamp1 in view.
Step 4:

Using both hands, simultaneously
press the hand-held transmitter
button5 and the desired integrated
signal transmitter button (2, 3
or4). Do not release the buttons until
completing step 5.
The indicator lamp1 on the
integrated remote control will flash,
first slowly and then rapidly.Step 5:

When the indicator lamp1 flashes
rapidly, release both buttons.
Step 6:

Press and hold the just-trained
integrated signal transmitter button
and observe the indicator lamp1.
If the indicator lamp1 stays on
constantly, programming is complete
and your device should activate when
the integrated signal transmitter
button is pressed and released.iThe indicator lamp1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after
20 seconds.

260 Controls in detailUseful featuresStep 12:
Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3
or4).
Step 13:

To program the remaining two buttons,
repeat the steps above starting with
step 3.Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:Step 4:

Continue to press and hold the
integrated signal transmitter button
(2, 3 or4) while you press and
re-press (“cycle”) your hand-held
remote control transmitter6 every
two seconds until the frequency signal
has been learned. Upon successful
training, the indicator lamp1 will
flash slowly and then rapidly after
several seconds.

Proceed with programming step 5 and
step 6 to complete.


261 Controls in detail
Useful features
Operation of integrated remote control
Switch on ignition (
page 33).

Select and press the appropriate
integrated signal transmitter button
(2, 3 or4) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.Erasing the integrated remote control
memory

Switch on ignition (
page 33).

Simultaneously hold down the signal
transmitter buttons2 and 4, for
approximately 20 seconds, until the
indicator lamp1 flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:

Press and hold the desired signal
transmitter button (2, 3 or4).
Do not release the button.

The indicator lamp will begin to flash
after 20 seconds. Without releasing
the integrated signal transmitter
button, proceed with programming
starting with step 3.
iIf you sell your vehicle, erase the codes
of all three channels.

414 Index
Releasing trunk lid from inside 95
Remote door unlock 255
Unlocking the vehicle 337
Emergency Tensioning Device see ETD
Emission control 273
Emission control information label 376
Ending
A call (telephone*) 152
Engine
Compartment 278
Starting with automatic
transmission* 47
Starting with manual
transmission 46
Starting with the SmartKey,
automatic transmission* 47
Starting with the SmartKey,
manual transmission 46
Technical data 378
Turning off with the SmartKey 56
Engine cleaning 297Engine compartment 278
Fuse box in 370
Hood 278
Engine malfunction
indicator lamp 25, 304
Engine number 376, 400
Engine oil 279
Adding 281
Additives 390
Checking level 277, 280
Consumption 279
Display messages 280, 320–321
Filler neck,
C 230 Kompressor
(all models) 282
Filler neck,
C 240 (all models),
C 320 (all models),
C 55 AMG 282
Messages in display 280, 320–321
Viscosity 400Engine oil level
Checking 277, 280
Engine oils 390
ESP 79, 400
Four wheel electronic traction
system with ESP 82
Messages in display 312–313
Switching off 80
Switching on 81
Warning lamp 25, 306
ETD 67, 400
Safety guidelines 62
Ethanol fuel
At the gas station 275
Requirements 392
Switching fuels 393
Exterior lamp switch 49, 109
Exterior lamps
Delayed shut-off 143
Exterior rear view mirrors
Adjusting 41
Parking position* for 148

419 Index
Key, SmartKey
Battery check lamp 89
Checking the batteries 91
Factory setting 89
Global locking 89
Global unlocking 89
Loss of 91
Messages in display 322
Positions in starter switch 33
Remote control 88
Restoring to factory setting 90
Selective setting 89
Starting the engine,
automatic transmission* 47
Starting the engine,
manual transmission 46
Turning off the engine 56
Unlocking the trunk lid 91
Unlocking with 32
Kickdown 163, 401
Kilometers/miles in speedometer 135
Km/h or mph in speedometer 135L
Labels, identification 376
Lamp bulbs, exterior 344
Lamp sensor
Message in display 324
Lamps, exterior
Front 345
Light sensor 324
Messages in display 323–326
Rear 345
Lamps, indicator and warning
ABS 25, 302
Battery (SmartKey) 89
Brakes 25, 303
Engine diagnostics 304, 307
Engine malfunction 25, 304–305
ESP 25, 306
Front fog lamps 109
Front passenger
front air bag off 27, 63, 70, 308
Fuel reserve 25, 307
High beam headlamps 25Instrument cluster 302–307
Low beam headlamps 25
Maintenance service indicator 292
Rear fog lamp 109
Seat belt telltale 25, 307
SRS 25, 59, 307
Turn signals 25
Language
Multifunction display 136
Setting 136
LATCH-type child seat anchors 73
Folding back 74
Layout of poly-V-belt drive 377
Leather upholstery
Cleaning 299
Lever for voice control system* 23
License plate lamps
Messages in display 324
Replacing bulbs 345
Light alloy wheels
Cleaning 298
Technical data 381, 382

425 Index
Premium unleaded gasoline 391
Problems
While driving 53
With vehicle 17
Product information 9
Program mode 121
Program mode selector switch 402
Automatic shift program,
automatic transmission* 162
Manual shift program (C 55 AMG only),
automatic transmission* 166
Q
Quick search
Phone book* 153
R
Radio
Selecting stations 128
Radio operation 191
Radio see Radio operation
Radio transmitters, control and
operation 272Range (distance to empty)
Calling up 150
Reading lamp 115
Rear bench seat
Foldable* 237
Rear door window
Blocking operation 75
Rear fog lamp 345
Bulb 345
Indicator lamp 109
Switching on 113
Rear lamp bulbs
Replacing 351
Rear lamps
Messages in display 323–326
Rear lamps see Tail lamps
Rear outer seats
Adjusting head restraint height 101
Rear passenger compartment,
adjustable air vents 182
Rear seat ashtray 246Rear seat head restraints 101
Adjusting 101
Adjusting tilt 103
Folding back, electrical 102
Folding back, manual 102
Installing 103
Outer seats 103
Placing upright 102
Removing 103
Rear view mirrors see Mirrors
Rear window defroster 173
Rear window sunshade* 172
Reconnecting
Vehicle battery 362
Recovery services
For stolen vehicle 256
Refrigerant
Air conditioning 390
Refueling 275
Regular checks 277
Reinstalling vehicle battery 361
Remote control
SmartKey 88