2005 LEXUS LS430 park

STARTING AND DRIVING
319
31L149b
Corner obstacles
Depending on the distance between your vehicle and the
obstacle, the display and beeps change as follows:
1 About 37.5 cm (1.1 ft.) to about 50 cm (1.5 ft.): 3 arcs
appear on the corner of the vehicle mark where the
obstacle is detected. At this time, the beeps remind you
that your vehicle is getting closer to the obstacle by
sounding intermittently.
2 About 25 cm (0.8 ft.) to about 37.5 cm (1.1 ft.): The
number of arcs will decrease from 3 to 2. The beeps
sound at shorter intervals than in step
1.
3 Less than about 25 cm (0.8 ft.): The number of arcs will
decrease from 2 to 1, and the bar blinks while the beeps
sound continuously.
Lexus park assist system failure warning
31L351
The system self check is automatically performed when
the Lexus park assist system is turned on. At this time if
an error is detected, the master warning light comes on
accompanied by 5 beeps, the faulty sensor blinks and
either of the following messages appear in the
multiinformation display.
 “Check Park Sonar”
 “Clean Park Sonar”
The sensors operate individually. When one sensor is
malfunctioning, you will notice sounding beeps and blinking
indicators to show that it is malfunctioning. If another sensor
detects an obstacle during this time, the approximate distance
to the obstacle will be shown by that sensor.

STARTING AND DRIVING
320
W285
If the sensor is malfunctioning or a cable is broken, the
above message appears.
Although it is no problem to continue driving, have your vehicle
checked by your Lexus dealer as soon as possible.
W286
If icicles, snowflakes or mud gets on the sensor or it is
frozen, the sensor may not be able to detect an obstacle.
In either case, the above message appears.
Remove the foreign matter or deice the sensor. If the message
does not appear after cleaning, the system is operating
properly.
Lexus park assist system operating hints
31L355
 Sensor detection range
1
About 1 m (3 ft.) 2About 50 cm (1.5 ft.)
The sensor detection range is limited around the bumper.
Be sure to confirm a safe distance around your vehicle
and drive slowly.
If more than one obstacle is detected in the same
direction, the indicators for the obstacle nearest to the
vehicle will turn on.

STARTING AND DRIVING
321
CAUTION
Do not install an accessory or the like within the sensor
detection range. Doing so may cause the Lexus park
assist system to malfunction, resulting in an accident.
NOTICE
The sensors do not detect an obstacle just under the
bumper. A short object, thin stake or the like will be
detected once but might not be detected as your
vehicle gets very close to such an object.
 If an obstacle is very close to your vehicle, it might
not be detected.
 If a sensor is subjected to a strong impact, it will not
operate properly.
The Lexus park assist system may not work properly in
the following cases:
When icicles, snowflakes or mud gets on the sensors.
If removed, the system will work properly.
 When the sensor is frozen.
If deiced, the system will work properly.
 When the sensor is covered with something.
If removed, the system will work properly. Especially in cold weather, a malfunction warning screen may
appear on
the display due to frozen sensors. If the “Clean Park
Sonar” appears on the display, be sure to clean the sensor. If
the “Clean Park Sonar” appears despite no mud, ice or
snowflakes on the sensor, the sensor might have
malfunctioned. Have your vehicle checked by your Lexus
dealer.
In the following conditions, the detection range may be
affected:
 When you stop your vehicle in extreme hot or cold weather.
 Foreign matter such as snowflakes or mud gets on the
sensor.

STARTING AND DRIVING
322The Lexus park assist system may detect the following by
mistake:

Bumpy roads or gravelled roads or grass when driving on
such surfaces, or on grass
 Devices issuing ultrasonic waves, such as a horn from
another vehicle, motorcycle engine, air braking sound from
heavy−duty vehicles, if such a device is operated around
your vehicle
 Rain or water splashing over the sensor
 The ground on which the vehicle is tilted
 Radio antenna or fender pole mounted on your vehicle
 Mud, ice or snowflakes on the sensor
 Tall curb stone
 Towing eyelet mounted on your vehicle
 Towing hitch mounted on your vehicle The Lexus park assist system may not detect the
following:

Thin objects such as wire or rope
 Objects with a surface area too small to reflect ultrasonic
waves such as wire gauze or fence
 Sound wave absorbing objects such as cotton or snow
 Objects with a sharp edge
 Shorter objects
 Tall objects with the upper part projected
For vehicles with a Navigation System, the park assist
graphics appear both on the navigation display and
multi− information display. For details, see the separate
“Navigation System Owner’s Manual”.
For vehicles sold in Canada
This ISM device complies with Canadian ICES −001.

STARTING AND DRIVING
369
If any of the following conditions occurs, this indicates a
malfunction
somewhere in the components monitored by
the warning light system. Contact your Lexus dealer as
soon as possible to service the vehicle.
 The light does not come on when the ignition switch is
turned to the “ON” position, or remains on.
 The light comes on while you are driving.
A warning light turning on briefly during operation does not
indicate a problem.
CAUTION
If the “ABS” warning light remains on together with the
brake system warning light, immediately stop your
vehicle at a safe place and contact your Lexus dealer.
In this case, not only the antilock brake system will fail
but also the vehicle will become extremely unstable
during braking.
Drumindisc type parking brake system
Your vehicle has a drum−in−disc type parking brake system.
This type of brake system needs bedding −down of the brake
shoes periodically or whenever the parking brake shoes
and/or drums are replaced.
Have your Lexus dealer perform the bedding −down.
Brake assist system
If you slam the brakes on such as in an emergency or
apply the brakes more firmly than usual such as when
descending the hill with the designated number of
occupants in the vehicle, the brake assist system
provides more powerful braking.
If you slam the brakes on or apply the brakes more firmly, more
powerful braking will be applied. At this time, you may hear a
sound in the engine compartment and feel the vibrations of the
brake pedal. This does not indicate a malfunction.
The brake assist system becomes operative after the vehicle
has accelerated to a speed in excess of approximately 10 km/h
(6 mph). It stops operating when the vehicle decelerates to a
speed below approximately 5 km/h (3 mph).
For an explanation of this system’s warning light, see “ABS”
warning light on page 87 or 368.

STARTING AND DRIVING
372
Tire pressure warning system reset switch
31L568b
The tire pressure warning system needs to be initialized
after tires or wheels are replaced or rotated.
To initialize the system, perform the following:
1. Park the vehicle at a safe place with the parking brake
applied and turn the ignition switch to “LOCK”.
2. Adjust the pressure of all the installed tires to the specified
level. (See “Tires and wheels” on pages 463 through 465.)
3. Turn the ignition switch to “ON”.
If the low tire pressure warning message “Low Tire” appears
in the multi−information display, push the reset switch for a few
seconds and make sure the warning message goes off.
4. With the vehicle stopped, push and hold the reset switch
until “Pressure Initial” appears in the multi−information display.
W266
Initialization is completed after driving at the speeds of 30
km/h (19 mph) or over for more than one hour. If the
following driving conditions are satisfied, initialization
will be completed in about one hour.
 The vehicle speeds is between 50 km/h (31 mph) and
100 km/h (62 mph).
 The roads are dry, smooth and straight.
 The number of passengers is one or two (including the
driver).
If you make a mistake in the middle of initialization, perform the
operation from the beginning again.
Do not push the reset switch without adjusting the tire inflation
pressure to the specified level. Otherwise, the low tire
pressure warning may not turn on even if the tire inflation
pressure is low, or it may turn on when the tire inflation
pressure is actually normal.
If you push the reset switch while driving, initialization is not
performed.
If “Pressure Initial”does not appear when the reset switch is
held down, the system may be malfunctioning. Have your
vehicle checked by your Lexus dealer as soon as possible.

DRIVING TIPS
382
BREAKIN PERIOD
Drive gently and avoid high speeds.
You need not follow a break−in schedule with your new Lexus.
But following a few simple tips for the first 1600 km (1000 miles)
can add to the future economy and long life of your vehicle:
 Avoid full throttle acceleration when starting and driving.
 Avoid racing the engine.
 Try to avoid hard stops during the first 300 km (200 miles).
 Do not drive for a long time at any single speed, either fast
or slow.
 Do not tow a trailer during the first 800 km (500 miles).
OPERATION IN FOREIGN
COUNTRIES
If you plan to drive your Lexus in another country ...
First, comply with the vehicle registration laws.
Second, confirm the availability of the correct fuel (unleaded
and minimum octane rating).
TIPS FOR DRIVING IN VARIOUS CONDITIONS
Always slow down in gusty crosswinds. This will allow you
much better control.
 Drive slowly onto curbs and, if possible, at a right angle.
Avoid driving onto high, sharp −edged objects and other
road hazards. Failure to do so can lead to severe tire
damage such as a tire burst.
Drive slowly when passing over bumps or travelling on a
bumpy road. Otherwise, the impact could cause severe
damage to the tires and/or wheels.
 When parking on a hill, turn the front wheels until they touch
the curb so that the vehicle will not roll. Apply the parking
brake, and place the transmission in “P”. If necessary, block
the wheels.
 Washing your vehicle or driving through deep water may get
the brakes wet. To see whether they are wet, check that
there is no traffic near you and then press the pedal lightly.
If you do not feel a normal braking force, the brakes are
probably wet. To dry them, drive the vehicle cautiously while
lightly pressing the brake pedal with the parking brake
applied. If they still do not work safel y, pull to the side of the
road and call a Lexus dealer for assistance.

DRIVING TIPS
383
CAUTION
Before driving off, make sure the parking brake is
fully released and that the parking brake reminder
light is off.
 Do not leave your vehicle unattended while the
engine is running.
 Do not rest your foot on the brake pedal while driving.
It can cause dangerous overheating, needless wear,
and poor fuel economy.
 To drive down a long or steep hill, reduce your speed
and downshift. Remember, if you ride the brakes
excessively, they may overheat and not work
properly. See page 311.
 Be careful when accelerating, upshifting,
downshifting or braking on a slippery surface. The
abrupt change in engine speed, such as sudden
acceleration or engine braking, could cause the
vehicle to skid or spin.
 Do not drive in excess of the speed limit. Even if the
legal speed limit permits it, do not drive over 140 km/h
(85 mph) unless your vehicle has highspeed
capability tires. Driving over 140 km/h (85 mph) may
result in tire failure, loss of control and possible
injury. Be sure to consult a tire dealer to determine
whether the tires on your vehicle are highspeed
capability tires or not before driving at such speeds.
 Do not continue normal driving when the brakes are
wet. If they are wet, your vehicle will require a longer
stopping distance, and it may pull to one side when
the brakes are applied. Also, the parking brake will
not hold the vehicle securely.