Page 174 of 539

OCCUPANT RESTRAINT SYSTEMS
155
If your steering wheel is adjustable, tilt it downward.
This points the airbag toward your chest instead of
your head and neck.
The seat should be adjusted as recommended by
NHTSA above, while still maintaining control of the foot
pedals, steering wheel, and your view of the instrument
panel controls.
Front passenger seat
CAUTION
The SRS front passenger airbag also deploys with
considerable force, and can cause death or serious
injury especially if the front passenger is very close to
the airbag. The front passenger seat should be as far
from the airbag as possible with the seatback adjusted,
so the front passenger sits upright.
Front seats
CAUTION
The SRS side airbags are installed in the driver and front
passenger seats. Observe the following precautions.
Do not lean against the front door when the vehicle
is in use, since the side airbag inflates with
considerable speed and force. Otherwise, you may
be killed or severely injured.
Do not use seat accessories which cover the area
where the side airbags inflate. Such accessories may
prevent the side airbags from activating correctly,
causing death or serious injury.
Do not modify or replace the seats or the upholstery
of the seats equipped with side airbags. Such
change may prevent the side airbag system from
activating correctly, disable the system, or cause the
side a irbags to inflate accidentally, resulting in death
or serious injury.
Page 175 of 539
OCCUPANT RESTRAINT SYSTEMS
156
Seat adjustment precautions
CAUTION
Do not adjust the seat while the vehicle is moving as
the seat may unexpectedly move and cause the
driver to lose control of the vehicle.
Be careful that the seat does not hit a passenger,
luggage or the rear seat.
NOTICE
Do not operate the control switch in more than one
dimension at a time. It may cause electrical overload.
Adjusting front seats
16L257a
1
Seat cushion length control switch
2 Seat position control switch, seat cushion angle
and height control switch
3Seatback angle and head restraint control switch
4Upper lumbar support control switch
5 Lower lumbar support control switch
Page 177 of 539
OCCUPANT RESTRAINT SYSTEMS
158
16L259
For passenger’s seat
Move the control switch in the desired direction.
Releasing the switch will stop the seat in that position. Do not
place anything under the seat as this might interfere with the
seat movement.
Adjusting seatback angle
16L260a
Move the control switch in the desired direction.
Releasing the switch will stop the seatback in that position.
CAUTION
Avoid reclining the seatback any more than needed.
The seat belts provide maximum protection in a frontal
or rear collision when the driver and the front passenger
are sitting up straight and well back in the seats. If you
are reclined, the lap belt may slide past your hips and
apply restraint forces directly to the abdomen or your
neck may contact the shoulder belt. In the event of a
frontal collision, the more the seat is reclined, the
greater the risk of death or personal injury.
Page 179 of 539
OCCUPANT RESTRAINT SYSTEMS
160
16L262a
Upper lumbar support
Push the upper lumbar support control switch on either
side.
The amount of upper lumbar support will change while the
switch is pushed. Front passenger’s seat
16L354a
Push the control switch on either side.
The amount of lumbar support will change while the switch is
pushed.
Page 180 of 539
OCCUPANT RESTRAINT SYSTEMS
161
Adjusting front passenger’s seat from the
driver’s seat
16L266a
Seat position
Move the control switch in the desired direction.
Releasing the switch will stop the seat in that position. Do not
place anything under the seat as this might interfere with the
seat movement.
CAUTION
If you operate the switch when a front passenger is
seated or he/she is getting on or off the front passenger
seat, take full safety precautions beforehand by telling
the occupant that the seat is about to move.
16L265a
Seatback angle
Move the control switch in the desired direction.
Releasing the switch will stop the seatback in that position.
Page 181 of 539

OCCUPANT RESTRAINT SYSTEMS
162
CAUTION
If you operate the switch when an occupant is seated
or when he/she is getting on or off the front
passenger seat, take full safety precautions
beforehand by telling the occupant that the seat is
about to move.
Avoid reclining the seatback any more than needed.
The seat belts provide maximum protection in a
frontal or rear collision when the front passenger is
sitting up straight and well back in the seats. If he/she
is reclined, the lap belt may slide past his/her hips
and apply restraint forces directly to the abdomen or
his/her neck may contact the shoulder belt. In the
event of a frontal collision, the more the seat is
reclined, the greater the risk of death or personal
injury.
REAR SEATS
Adjusting rear power seats
16L630
1
Seat position control switches
2Head restraint height control switches
3Refreshing rear seat switches
The rear power seat control switches are located in the rear
armrest.
For the operation of head restraints and refreshing rear seat
switches, see “Head restraints” on page 165 and “Refreshing
rear seat switches” on page 76.
Page 187 of 539

OCCUPANT RESTRAINT SYSTEMS
168
SEAT BELTS
Seat belt precautions
Lexus strongly urges that the driver and passengers in the
vehicle be properly restrained at all times with the seat belts
provided. Failure to do so could increase the chance of injury
and/or the severity of injury in accidents.
The seat belts provided for your vehicle are designed for
people of adult size, large enough to properly wear them.
Child. Use a child restraint system appropriate for the child
until the child becomes large enough to properly wear the
vehicle’s seat belts. See “Child restraint” on page 199 for
details.
If a child is too large for a child restraint system, the child should
sit in the rear seat and must be restrained using the vehicle’s
seat belt. According to accident statistics, the child is safer
when properly restrained in the rear seat than in the front seat.
If a child must sit in the front seat, the seat belts should be worn
properly. If an accident occurs and the seat belts are not worn
properly, the force of the rapid inflation of the airbag may cause
death or serious injury to the child.
Do not allow any children to stand up or kneel on either rear or
front seats. An unrestrained child could suffer serious injury or
death during emergency braking or a collision. Also, do not let
the child sit on your lap. Holding a child in your arms does not
provide sufficient restraint. Pregnant
woman. Lexus recommends the use of a seat belt.
Ask your doctor for specific recommendations. The lap belt
should be worn securely and as low as possible over the hips
and not on the waist.
Injured person. Lexus recommends the use of a seat belt.
Depending on the injury, first check with your doctor for specific
recommendations.
CAUTION
Persons should ride in their seats properly wearing
their seat belts whenever the vehicle is moving.
Otherwise, they are much more likely to suffer serious
bodily injury or death in the event of sudden braking or
a collision.
When using the seat belts, observe the following:
Use the belt for only one person at a time. Do not use
a single belt for two or more people even children.
Avoid reclining the seatback any more than needed.
The seat belts provide maximum protection in a
frontal or rear collision when the driver and the front
passenger are sitting up straight and well back in the
seats. If you are reclined, the lap belt may slide past
your hips and apply restraint forces directly to the
abdomen or your neck may contact the shoulder belt.
In the event of a frontal collision, the more the seat is
reclined, the greater the risk of death or personal
injury.
Page 188 of 539

OCCUPANT RESTRAINT SYSTEMS
169
Be careful not to damage the belt webbing or
hardware. Take care that they do not get caught or
pinched in the seat or doors.
Inspect the belt system periodically. Check for cuts,
fraying, and loose parts. Damaged parts should be
replaced. Do not disassemble or modify the system.
Keep the belts clean and dry. If they need cleaning,
use a mild soap solution or lukewarm water. Never
use bleach, dye, or abrasive cleaners, or allow them
to come into contact with the belt they may severely
weaken the belts. (See “Cleaning the interior” on
page 515 for instructions.)
Replace the belt assembly (including bolts) if it has
been used in a severe impact. The entire assembly
should be replaced even if damage is not obvious.Front seat belt buckle illumination
16L371
Opening the driver’s door lights up the driver’s seat belt
buckle for easy use. The same applies for the front
passenger’s door and seat belt buckle.
The light remains on for 15 seconds after the door is closed,
but goes off immediately when all the doors are locked.