2005 LEXUS LS430 parking

GAUGES, METERS AND SERVICE REMINDER INDICATORS
82
ODOMETER AND TRIP METER
13L145
This meter displays the odometer and two trip meters. To
change the mode indication, push the “ODO/TRIP” button
briefly. Each time you push the button, the mode changes
in order from the odometer to trip meter A to trip meter B,
then to the odometer.
The odometer records the total distance the vehicle has
been driven. The twin trip meter records two different
distances independently.
For example, you can use one meter to calculate the fuel
economy and the other to measure the distance on each trip.
To change the trip meter indication from one trip to the
other, push the “ODO/TRIP” button. To set the trip meter
A to zero, display the meter A reading, then push the
“RESET” button. The same applies for the trip B meter.
The data of trip meters will be cancelled if the electrical power
source is disconnected.
SERVICE REMINDER INDICATORS AND WARNING BUZZERS
IF THIS INDICATOR OR
BUZZER COMES ON ...DO THIS.
(a)or
If parking brake is off,
stop immediately and
contact Lexus dealer.
(b)
(Indicator and buzzer)
Fasten driver’s seat
belt.
(c)Fasten front
passenger’s seat belt.
(d)Take vehicle to Lexus
dealer immediately.
(e)Stop and check.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
84
(a) Brake System Warning Light
This light comes on in the following cases when the ignition
switch is in the “ON” position.
When the parking brake is applied ...
This light comes on for a few seconds when the ignition switch
is turned to the “ON” position even after the parking brake is
released.
 When the brake fluid level is low ...
CAUTION
It is dangerous to continue driving normally when the
brake fluid level is low.
Have your vehicle checked at your Lexus dealer in the
following case:
The light does not come on even if the parking brake is
applied when the ignition switch is in the “ON” position.
 The light does not come on even if the ignition switch is
turned on with the parking brake released.
A warning light turning on briefly during operation does not
indicate a problem.
CAUTION
If either of the following conditions occurs, immediately
stop your vehicle at a safe place and contact your Lexus
dealer.
 The light does not turn off even after the parking
brake is released while the engine is running.
In this case, the brakes may not work properly and
your stopping distance will become longer. Depress
the brake pedal firmly and bring the vehicle to an
immediate stop.
 The brake system warning light remains on together
with the “ABS” warning light.
In this case, not only the antilock brake system will
fail but also the vehicle will become extremely
unstable during braking.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
89
How to check all the service reminder
indicators
(except the low fuel level warning light):
1. Apply the parking brake.
2. Open the door.
The following service reminder indicator should come on. It
goes off when you close the door completely.
3. Turn the ignition switch to “ON”.
The following service reminder indicators should come on.

W287
or

or
or
w243
The following service reminder indicator goes off after a few
seconds.

W287 w243
or
The following service reminder indicator goes off after 6
seconds.
If any service reminder indicator or warning buzzer does not
function as described above, have it checked by your Lexus
dealer as soon as possible.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
97
W43W256
W42W257
W258
W44W259
W46W260
When any door or trunk is open with the ignition switch
turned on, a message appears to let you know which door
or trunk is open. If you continue driving in this condition,
the master warning light flashes and a warning tone
sounds when the vehicle speed exceeds 5 km/h (3 mph).
If any of the above warning messages appears, stop your
vehicle and close the door or trunk securely.
W52W261
If the driver’s door is opened with the ignition switch
turned off and the moon roof opened, the master warning
light flashes, a warning tone sounds and the above
message appears.
When you leave your vehicle, be sure to close the moon roof.
w262
If you start driving with the parking brake applied, the
master warning light flashes, a warning tone sounds and
the above message appears when the vehicle speed
exceeds 5 km/h (3 mph).
If the above warning message appears, stop your vehicle and
release the parking brake.
W48W263
If the vehicle stability control system or the traction
control system malfunctions, the master warning light
and “TRAC OFF” indicator light come on. At this time a
warning tone sounds and the above message appears.
If the message appears, the vehicle stability control system
and traction control system do not work. Although it is no
problem to continue driving, have your vehicle checked by
Lexus dealer as soon as possible.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
106Displays
Directions
N
NE
E
SE S
SW W
NWNorth
Northeast
East
Southeast South
Southwest West
Northwest
The compass may not show the correct direction in the
following conditions:
 The vehicle is stopped immediately after turning.
The compass does not adjust while the vehicle is stopped.
 The ignition switch is turned off immediately after turning.
 The vehicle is on an inclined surface.
 The vehicle is in a place where the earth’s magnetic field is
subject to interference by artificial magnetic fields
(underground parking, under a steel tower, between
buildings, roof parking, near a crossing, near a large
vehicle, etc.). 
The vehicle is magnetized. (There is a magnet or a metal
object near the audio system.)
 The battery has been disconnected.
If the deviation is small, the compass works to calibrate the
direction automatically while the vehicle is in motion.
For obtaining additional precision or for complete calibrating,
see “CALIBRATING THE COMPASS” on page 107.
COMPASS SENSOR
13L072
 Compass sensor
The compass sensor is located behind the audio system.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
109

Do not perform circling calibration of the compass in a place
where the earth’s magnetic field is subject to interference by
artificial magnetic fields (underground parking, under a
steel tower, between buildings, roof parking, near a
crossing, near a large vehicle, etc.).
 During calibration, do not operate electric systems (moon
roof, power windows, etc.) as they may interfere with the
calibration.
CAUTION
When doing the circling calibration, be sure to secure
a wide space, and watch out for people and vehicles
in the neighborhood. Do not violate any local traffic
rules while performing circling calibration.
 Do not adjust the display while the vehicle is moving.
Be sure to adjust the display only when the vehicle is
stopped.
INSTRUMENT PANEL LIGHT
CONTROL
13L143a
To adjust the brightness of the instrument panel lights,
turn the knob.
With the knob turned fully right, the intensity of the instrument
panel lights will not be reduced when the headlight switch is on.

STEERING WHEEL AND MIRRORS
232
Folding and extending automatic rear view
mirrors
16L642
With the rear view mirror folding switch in the “AUTO”
position:
When you turn the ignition switch to “ACC” or “ON” position,
the folded rear view mirrors are automatically extended.
 When you turn the ignition switch to “LOCK” position, the
rear view mirrors are automatically folded.
The rear view mirrors can be folded or extended manually.
CAUTION
 To avoid personal injury and mirror malfunction, do
not touch the mirror while it is moving.
 Do not drive with the mirrors folded backward. Both
the driver and passenger side rear view mirrors must
be extended and properly adjusted before driving.
Folding rear view mirrors154.
16L643
To fold the mirrors, push the switch on the right side. To
extend the rear view mirrors, push the switch on the left
side.
The rear view mirrors can be folded backward for parking in
compact areas.
CAUTION
To avoid personal injury and any mirror malfunction,
do not touch the mirror while it is moving.
 Do not drive with the mirrors folded backward. Both
the driver and passenger side rear view mirrors must
be extended and properly adjusted before driving.

AIR CONDITIONING
252
(d) Operating tips
Make sure the air inlet grilles in front of the windshield are
not blocked by leaves or other obstructions.
 If air flow control is not satisfactory, check the dashboard
vents. (See “Center vents”, “Side vents” and “Rear vents”.)\
 To help cool down the interior after parking in the hot sun,
drive for the first few minutes with the windows open. After
the excess heat has blown away, close the windows.
 When driving on dusty roads, close all windows. If dust
thrown up by the vehicle is still drawn into the vehicle after
closing the windows, it is recommended that the air intake
control button be left to the OUTSIDE AIR mode and the fan
speed control button be pressed to anywhere except the
“OFF” button.
 If following another vehicle on a dusty road, or driving in
windy and dusty conditions, it is recommended that the air
intake control button be temporarily pressed in to the
RECIRCULATED AIR mode, which will close off the outside
passage and prevent outside air and dust from entering the
vehicle interior.
Center vents
21L064a
The center vents may be opened or closed as shown.
21L057b
Push the swing button to swing the vanes.
The vanes directly aimed at the driver and front passenger will
swing wider as the room temperature nears the desired
temperature. The swinging angle will also change from narrow
to wide depending on the room temperature.