2005 KIA Rio tires

In Case Of An Emergency6-16If You Have a Flat TireStoring the Spare Tire, Jack and ToolsThe spare tire, tool bag, jack and jack handle are stored
in the trunk compartment. Move the carpeting out of
the way to reach this equipment.
ARSB06002A
ARSB06002
Spare tire
Jack
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 16

In Case Of An Emergency6-18The compact spare should be inflated to 60 psi
(415 kPa).
When using a compact spare tire, observe the
following precautions:
 Under no circumstances should you exceed 80 km/h
(50 mph); a higher speed could damage the tire.
 Ensure that you drive slowly enough for the road
conditions to avoid all hazards. Any road hazard,
such as a pothole or debris, could seriously damage
the compact spare.
 Any continuous road use of this tire could result in
tire failure, loss of vehicle control, and possible
personal injury.
 Do not exceed the vehicle’s maximum load rating or
the load-carrying capacity shown on the sidewall of
the compact spare tire. Avoid driving over obstacles. The compact spare tire
diameter is smaller than the diameter of a
conventional tire and reduces the ground clearance
approximately 25 mm (1 in.), which could result in
damage to the vehicle.
 Do not take this vehicle through an automatic car
wash.
 Do not use tire chains on this tire. Because of the
smaller size, a tire chain will not fit properly. This
could damage the vehicle and result in loss of the
chain.
 This tire should not be installed on the front axle if
the vehicle must be driven in snow or on ice.
 Do not use the compact spare tire on any other
vehicle because this tire has been designed
especially for your vehicle.
 The compact spare’s tread life is shorter than a
regular tire. Inspect your compact spare tire
regularly and replace worn compact spare tires with
the same size and design, mounted on the same
wheel.
✽
NOTICE
Check the inflation pressure after installing the
spare tire. Adjust it to the specified pressure, as
necessary.
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 18

6-19 Changing Tires
Jacking Instructions
The jack is provided for emergency tire changing only.
Follow jacking instructions to reduce the possibility of
personal injury.Tire Replacement
1. Park on a level surface and set the parking brake
firmly.
2. Set the automatic transaxle in P (Park), or shift the
manual transaxle into R (Reverse).
3. Activate the hazard warning flasher.
4. Remove the wheel lug nut wrench, jack, jack
handle, and spare tire from the vehicle.
5. Block both the front and rear of the wheel that is
diagonally opposite the jack position.
WARNING - Changing Tires
 Never attempt vehicle repairs or a tire
change in the traffic lanes of a public road or
highway. Always move the vehicle completely
off the road and onto the shoulder before
trying to change a tire. If you cannot find a
firm, level place off the road, call a towing
service company for assistance.
 Do not exceed the maximum permissible
load of the jack: 600 kg. (1,320 lbs).
 Be sure to use the correct front or rear
jacking positions on the vehicle; never use
the bumpers or any other part of the vehicle
for jack support.
 Never allow any portion of your body to get
beneath the vehicle while using the jack.
 Do not start or run the engine while the
vehicle is supported by the jack.
AS2B06012
Flat tire
Wheel block
RIO ENG CNA 6.qxd 7/29/05 5:15 PM Page 19

7-1
MAINTENANCEMaintenance Services . . . . . . . . . . . . . . . . . . . . . . . . .7-3
Maintenance Schedule . . . . . . . . . . . . . . . . . . . . . . . .7-5
Owner Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . .7-10
Engine Compartment . . . . . . . . . . . . . . . . . . . . . . . . .7-13
Engine Oil and Oil Filter . . . . . . . . . . . . . . . . . . . . . . .7-14
Engine Cooling System . . . . . . . . . . . . . . . . . . . . . . .7-16
Brakes and Clutch . . . . . . . . . . . . . . . . . . . . . . . . . . .7-20
Parking Brake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-21
Power Steering . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-22
Automatic Transaxle . . . . . . . . . . . . . . . . . . . . . . . . . .7-23
Lubricants and Fluids . . . . . . . . . . . . . . . . . . . . . . . . .7-26
Air Cleaner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-27
Wiper Blades . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-28
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-31
Tires and Wheels . . . . . . . . . . . . . . . . . . . . . . . . . . . .7-34
Bulb Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . .7-42
Lubricant Specifications . . . . . . . . . . . . . . . . . . . . . . .7-47
7
RIO ENG CNA 7-1.qxd 7/29/05 5:16 PM Page 1

Maintenance7-8Chassis and Body (cont.)I: Inspect these items and their related parts. If necessary,
Check the engine oil and coolant levels every week.
R: Replace or change.
Kilometers or Time in Months, Whichever Comes First
km 8 16 24 32 40 48 56 64 72 80 88 96 104 112 120 128Months 4 8 12 16 20 24 28 32 36 40 44 48 52 56 60 64
Brake lines & connections (including booster)IIIIIManual transaxle oil
IIIRIIIRIIIRIIIR
Clutch & brake pedal free playI IIIIIIIIII IIIII
Automatic transaxle fluid
IIIRIIIRIIIRIIIR
Chassis & underbody bolts & nuts
I IIIIIIIIII IIIII
Tire condition & inflation pressure
I IIIIIIIIII IIIII
Wheel alignmentInspect when abnormal condition noted
Tire rotationSteering operation & linkageI IIIIIIIIII IIIII
MAINTENANCE
INTERVALS
MAINTENANCE
ITEM
x 1,000
Rotate the tires every 12,000 km (1)
(1)
(4)
(1) Refer to the lubricant and coolant specifications in the Owner’s Manual.
(4) If necessary, rotate and balance the wheels.
RIO ENG CNA 7-1.qxd 7/29/05 5:16 PM Page 8

Tires and WheelsTire CareFor proper maintenance, safety, and maximum fuel
economy, you must always maintain recommended tire
inflation pressures and stay within the load limits and
weight distribution recommended for your vehicle.Inflation PressuresCheck all tire pressures (including the spare) monthly
when the tires are cold. “Cold tires” means the car has
not been driven for at least three hours or driven less
than 1.6 km (one mile). Recommended pressures must
be maintained to ensure ride quality, vehicle handling,
and minimum tire wear.Maintenance7-34
All specifications (sizes and pressures) can be found
on a label attached to the front passenger door sill.
The correct tire pressure is 200 kPa (29 psi)
The compact spare should be at 415 kPa (60 psi).
AS2B07021
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 34

7-35
Tire Rotation
To equalize tread wear, it is recommended that the tires
be rotated every 12,000 km (7,500 miles), or sooner if
irregular wear develops.
✻ ✻
NOTICE
 Warm tires normally exceed recommended
cold tire pressures by 28 to 41 kPa (4 to 6 psi).
Do not release air from warm tires to adjust the
pressure. The tires will become underinflated
when cold.
 Underinflation results in excessive wear, poor
handling, reduced fuel economy, and the
possibility of blowouts from overheated tires.
Also, low tire pressure can cause poor sealing
of the tire bead. If the tire pressure is
excessively low, wheel deformation and/or tire
separation are possible. Keep tire pressures at
the proper levels. If a tire frequently needs
refilling, have it checked by an authorized Kia
dealer or a tire shop.
 Overinflation produces a harsh ride, handling
problems, excessive wear at the center of the
tire tread, and a greater possibility of damage
from road hazards.
WARNING -Tire Inflation
Overinflation or underinflation can reduce tire
life, adversely affect vehicle handling, and lead
to sudden tire failure. This could result in loss
of vehicle control.
AS2B07022A
Do not include compact spare tire in rotationFront
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 35

During tire rotation, check the tires for correct balance.
Check for uneven wear and damage. Abnormal wear is
usually caused by incorrect tire pressure, improper
wheel alignment, an out-of-balance condition, severe
braking or severe cornering. Look for bumps or bulges
in the tread or side of tire. Replace the tire if you find
either of these conditions. Also, replace the tire if you
can see fabric or cord. After rotation, be sure to bring
the front and rear tire pressures to specification and
check lug nut tightness.
Disc brake pads should be inspected for wear
whenever tires are rotated. Maintenance7-36
Tire Replacement
If the tire is worn evenly, a tread wear indicator will
appear as a solid band, 12.7 mm wide (1/2 inch) acrossthe tread. This shows there is less than 1.6 mm (1/16 inch)of tread remaining on the tire. Replace the tire when
this happens.
Do not wait for this band to appear across the entire
tread before replacing the tire.
✻ ✻
NOTICE
Rotate radial tires that have an asymmetric tread
pattern from front to rear only and not from right
to left.
AS2B07023
Tread wear indicator
New tread Worn tread
RIO ENG CNA 7-2.qxd 7/29/05 5:18 PM Page 36