2005 Hyundai Azera headlight aiming

Engine Compartment .................................................... 6-2
General Checks ........................................................... 6-3
Maintenance Precautions ............................................. 6-4
Checking the Engine Oil .............................................. 6-4
Checking and Changing the Engine Coolant ............... 6-7
Spark Plugs .................................................................. 6-9
Changing the Air Cleaner Filter ...................................6-10
Checking the Transaxle Fluid (Automatic) .................6-14
Checking the Brakes .................................................. 6-16
Air Conditioning Care .................................................. 6-18
Changing the Air Conditioner Filter .............................6-18
Checking Drive Belts .................................................. 6-21
Checking and Replacing Fuses ..................................6-21
Checking the Battery .................................................. 6-23
Checking the Eclectric Cooling Fans .........................6-25
Power Steering Fluid Level ......................................... 6-25
Headlight Aiming Adjustment ...................................... 6-26
Replacement of Light Bulbs ........................................6-28
Bulb Wattage ............................................................... 6-36
Fuse Panel D escription ............................................... 6-37
DO-IT-YOURSELF MAINTENANCE
6
6

6 DO-IT-YOURSELF MAINTENANCE
26HEADLIGHT AIMING ADJUSTMENT
G290A01TG-GAT
G290A01NF
Before performing aiming adjustment, make sure of the following.
1. Keep all tires inflated to the correct pressure.
2. Place the vehicle on level ground and press the front bumper & rear bumper down several times. Place vehicle at a distance of 3m (118 in.) from the test wall.
3. See that the vehicle is unloaded (except for full levels of coolant,engine oil and fuel, and spare tire,jack, and tools). Have the driver or equivalent weight placed in driver's seat.
Vertical aiming
Horizontal aiming 4. Clean the headlight lenses and turn
on the headlights (Low Beam or High Beam).
5. Open the hood.
6. Draw the vertical line (through the center of each headlight beam pat- tern) and the horizontal line (throughthe center of each headlight beam pattern) on the aiming screen. And then, draw the parallel line at 30 mm (1.18 in.) under the hori- zontal line.
7. Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver - VERTICAL AIMING.
8. Adjust each cut-off line of the low beam to the each vertical line with a phillips screwdriver - HORIZON-TAL AIMING.
NOTE: Grinding noise from the power steering pump may be heard im-mediately after the engine is started in extremely cold conditions (be- low - 20°C). If the noise stops dur-ing warm up, there is no abnormal function in the system. It is due to a power steering fluid characteristicin extremely cold conditions.
Recommended Fluid Use PSF-3 type fluid. NOTE: Do not start the engine when the power steering oil reservoir is empty. G240A01A-AAT POWER STEERING HOSES It is suggested that you check the power steering hose connections forfluid leakage at regular intervals. The power steering hoses should be re- placed if there is severe surface crack-ing, pulling, scuffing or worn spots. Deterioration of the hose could cause premature failure.

6
DO-IT-YOURSELF MAINTENANCE
27
G290B01TG-GAT
Adjustment After Headlight As- sembly Replacement
G290B01TG
Left-Hand Drive (Low Beam)
G290B01TG-R
Right-Hand Drive (Low Beam)
If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming shouldbe checked using the aiming screen as shown in the illustration. Turn on the headlight switch (Low Beam Posi-tion or High Beam Position).
1. Adjust headlights so that main axis of light is parallel to the center lineof the body and is aligned withpoint "P" shown in the illustration.
2. Dotted lines in the illustration show the center of the headlights. SPECIFICATION: "H" Horizontal center line of headlightsfrom ground; Low Beam : 691 mm (27.2 in.) High Beam : 680 mm (26.77 in.) "W" Distance between each headlight cen-ter;Low Beam : 1,350 mm (53.14 in.) High Beam : 1,080 mm (42.51 in.) "L" Distance between the headlights andthe wall that the lights are testedagainst: 3,000 mm (118.11 in.)
G290B02TG
Left-Hand Drive (High Beam)
LW
H
H Cut-off line
Ground line"P"
Horizontal line
30 mm
L
H 90 mm
Ground line
Horizontal line Vertical line
H45 mm
LW
H Cut-off line
"P"
Horizontal line
Ground line 30 mm
30 mm
Vertical line
Vertical line
H

6 DO-IT-YOURSELF MAINTENANCE
28
Replacement instructions:
1. Allow the bulb to cool. Wear eye protection.
2. Open the engine hood and discon- nect the negative (-) post of the battery.
3. Always grasp the bulb by its plastic base, avoid touching the glass.
G270A01TG-GAT
HEADLIGHT AND FRONT FOG LIGHT
Headlight (High beam) Headlight(Low beam)
G270A01TG
Front Fog Light
REPLACEMENT OF LIGHT BULBS
G260A01TG-GAT Before attempting to replace a light
bulb, be sure the ignition switch is turned to the "OFF" position.
The next paragraph shows how to
reach the light bulbs so they may bechanged. Be sure to replace theburned-out bulb with one of the same number and wattage rating.
See page 6-36 for the wattage descrip-
tions.
! CAUTION:
o Keep the lights out of contact with petroleum products, such as oil, gasoline, etc.
o Be sure to replace the LED type
equipped bulbs with an assem- bly.
o If you don't have necessary tools, the correct bulbs and the exper-tise, consult your authorized Hyundai dealer. CAUTION:
o The headlight aiming should be checked by an authorized Hyundaidealer after replacing the head-light bulbs.
o If your vehicle is equipped with
HID (High Intensity Discharge) type headlight, you must not replace or inspect the headlight. It has a danger of an electric shock. If the headlight is not work- ing, have your vehicle inspectedby your Hyundai Dealer.
! Headlight

10INDEX
4
G General Checks ........................................................... 6-3
Glove Box ................................................................. 1-95
HHazard Warning System ............................................ 1-83
Headlight
Aiming adjustment .................................................. 6-26
Leveling device system .......................................... 1-82
Bulb replacement .................................................... 6-28
Switch ..................................................................... 1-77
Washer switch ........................................................ 1-82
Heating and Cooling Control ....................................1-113
Heating and Ventilation ............................................ 1-114
Air flow control ........................................... 1-115, 1-128
Air intake control switch ............................ 1-117, 1-126
Air quality control system ..................................... 1-126
Bi-level heating ..................................................... 1-118
Defrosting/Defogging .................................. 1-119, 1-130
Fan speed control (Blower control) ............ 1-115, 1-125
Temperature control ................................... 1-115, 1-127
High-Mounted Rear Stop Light .................................1-103
Hood Release .......................................................... 1-105
Horn ......................................................................... 1-107
I Ignition Switch ............................................................. 2-3
Immobilizer System ..................................................... 1-5
Limp home procedures ............................................. 1-8
Key ........................................................................... 1-5 Instrument Cluster and
Indicator Lights ..................... 1-58
Instrument Panel Light Control (Rheostat) .................1-85
Intergrated Memory System (I.M.S) ..........................1-26
Interior Light ............................................................... 1-93
Intermittent Wiper ...................................................... 1-82
J Jump Starting .............................................................. 3-3
K
Key .............................................................................. 1-4 If you lose your keys ............................................. 3-13
Positions ................................................................... 2-4
L Light Bulbs Repl acement ........................................... 6-28
Light Bulbs Watages ................................................. 6-36
Lubrication Chart .......................................................... 9-4
M Maintenance Intervals Explanation of scheduled maintenance items ......... 5-7
Maintenance under severe usage conditions .......... 5-6 Scheduled maintenance ........................................... 5-4
Service requirements ................................................ 5-2
Maintenance Precautions ............................................ 6-4
Mirrors
Day/night inside rearview mirror .............................. 1-99
Outside rearview m irror ........................................... 1-96
Outside rearview mirror heater ................................1-98