2005 HONDA CIVIC HATCHBACK interior lights

µµ
µ
Turn Signal
Of f
Parking and interior lights
Headlight on
High beams
Flashhighbeams Push down on the
lef t lever to signal a lef t turn and up
to signal a right turn. To signal a lane
change, push lightly on the lever and
hold it. The lever will return to the
center when you release it or
complete a turn. Push the lever back
untilyouhearaclicktoturnonthe
high beams. The blue high beam
indicator will come on (see page ).
Pull the lever back again to low
beams.
The headlights revert to normal
operation when you turn them on
with the switch.
To f lash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
switch of f , even if you set the
parking brake.
Turning the switch to
the ‘‘ ’’ position turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate lights. Turning the
switch to the ‘‘ ’’ position turns
on the headlights. If you leave the
lights on with the key removed f rom
the ignition switch, you will hear a
reminder tone when you open the
driver’s door.
1.2.3.4.5.6. 53
Canadian model only
T urn Signal and Headlights T urn Signal High Beams
Daytime Running L ights
Headlights
Turn Signal and Headlights
Inst rument s and Cont rols
61
——
y
y
()yy

µ
µ
µ Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
Press this button once
to unlock the driver’s door. Push it
twice to unlock the other doors and
hatch. Some exterior and interior
lights f lash twice each time you
press this button. If you do not open
anydoorswithin30seconds,they
will automatically relock.
Pressthisbuttonfor
about 1 second to attract attention;
thehornwillsoundandtheexterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to ON (II).
Press this button once to
lock both doors and hatch. Some
exterior lights will f lash. When you
push LOCK twice within 5 seconds,
you will hear a beep to verify that the
doors are locked. You cannot lock it
if any door is not f ully closed or the
key is in the ignition switch.Remote Transmitter CareUNL OCK
PA NIC
LOCK
Remote Transmitter
Inst rument s and Cont rols
69
UNLOCK
BUTTON
LED LOCK
BUTTON
PANIC
BUTTON
——
y
y
()yy

The ceiling light has a three-position
switch: ON, Door Activated, and
OFF.
In the Door Activated (center)
position, the light comes on when
you:Open any door.
Remove the key from the ignition.
If you do not open a door, the light
f ades out in about 10 seconds.
Unlock the doors with the key or
remote transmitter. The cargo area light comes on when
you open the hatch.
The f ront ceiling light also contains
two spotlights. Push the button next
to the light to turn it on and off.
Interior Lights
Ceiling L ight
Cargo A rea L ight
Inst rument s and Cont rols
81
FRONT DOOR ACTIVATED
ON
OFF
——
y
y
()yy

Open the hatch.Put your fingers between the
interior trim and the hatch glass
on either side of the high-mount
brake light. Caref ully pull down on
the trim to unsnap the clips f rom
the hatch. Work your way toward
each end of the trim. Remove the
trim.Remove the bulb holder f rom the
light assembly by pushing the tabs
on both sides and pulling the bulb
holder down.
Pull the bulb straight out of its
holder. Push the new bulb in until
it bottoms in its holder.
1.
3.
2.
4.
Lights
Replacing the High-mount Brake
Light Bulb 150 BULB HOLDER
——
y


y
()y
y

Push the bulb holder into the light
assembly until it locks in place.
Testthelightstomakesurethe
new bulb is working.
Line up the clips on the interior
trim with the corresponding holes
in the hatch.Push on the trim to
snap it back in place.Pushthefrontof thesideturn
signal assembly toward the rear of
the vehicle until it pops out of the
body.
Turn the socket one-quarter turn
counterclockwise to remove it
from the lens.Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Put the socket back into its hole in
the lens and turn it clockwise until
it locks.
Testthelightstomakesurethe
new bulb is working.
Put the side turn signal assembly
back into the body, rear first. Push
on the f ront edge until it snaps into
place.
1.
2. 3. 5. 6.
4.
6.7.
5.
Lights
Replacing a Side T urn Signal Bulb
Maint enance
151
BULB
SOCKET
——
y

y
()y
y

Remove the cover f rom the f use
box.
Check each of the large f uses in
the under-hood f use box by
looking through the top at the wire
inside. Remove the screws with a
phillips-head screwdriver.
Turn the ignition switch to LOCK
(0). Make sure the headlights and
all other accessories are off.
Check the smaller f uses in the
under-hood f use box and all the
fuses in the interior fuse box by
pulling out each one with the f use
puller provided in the under-hood
fuse box.Look f or a burned wire inside the
f use. If it is burned, replace it with
one of the spare f uses of the same
rating or lower.
1. 2. 3. 4.
5.
Fuses
182 BLOWN
BLOWN
FUSE
FUSE PULLER
——
y
y
()y
y

ÎÎ
Î
µ µ µ µ µ
Î
Î
No. Circuits Protected No. Circuits Protected
Amps. Amps.
123456789
10 Ignition Coil
LAF Heater
Daytime Running Lights
Alternator
Not Used
Power Window Relay
Moonroof
ACC Radio
Rear Wiper
Meter 111213141516171819202122 23 2425
ABS
Daytime Running Lights
SRS
Power Mirror
Not Used
Heated Seat
Fuel Pump
Accessory Power Socket
Turn Signal Lights
Front Wiper
Not Used
Front Passenger’s Power
Window
Driver’s Power Window
Not Used
Not Used
15A20A10A10A
7.5A 20A
7.5A 10A
7.5A 7.5A7.5A
10A10A 20A 15A15A
7.5A 30A 20A20A
2: Not Used
1: On Canadian model
1 1
2
Fuse Locations
T aking Care of t he Unexpect ed
185
INTERIOR FUSE BOX
——
y
y
()y
y

µµµ
µ
µ µµµµµµµµµµµµµµ µ µ
Specif ications
T echnical Inf ormation
193
Air Conditioning
Lights Battery
Tires
Alignment
Fuses
HFC-134a (R-134a)
16.9 18.6 oz (500 550 g) SP-10
12 V 60 W
Refrigerant type
Charge quantity
Lubricant type Headlights
Front turn signal
Front parking light
Side turn signal light
Front side marker
Rear turn signal lights
Stop/Taillights
Rear side marker lights
Back-up lights
High-mount brake light
License plate lights
Front ceiling light/Spotlights
Center ceiling light
Cargo area light 12 V 5 W
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
12 V
8W
5W
5W
5W
18 W
2CP(3.8W)
21/5 W
21 W
2CP(3.8W)
5W
3CP(5W)
21 W
12 V 51 W
Capacity Size
Pressure
Toe-in
CamberCaster
60 psi (420 kPa , 4.2 kgf/cm
)
30 psi (210 kPa , 2.1 kgf/cm)
30 psi (210 kPa , 2.1 kgf/cm)
T135/70D15 99M P205/55R16 89V 1°36’
0°51’
0°09’
0.08 in (2.0 mm)
0.00 in (0.0 mm)
36 AH/5 HR
12 V Interior
Under-hood
45 AH/20 HR
12 V See page 185 or the fuse label
attached to the inside of the fuse
box door under the dashboard.
See page 184 or the fuse box
cover.
FrontRear
FrontRear
Front
Front/Rear
Spare
FrontRear
Spare
HILO
(HB3)(HB4)
——
y

y
()y
y