2005 FORD EXPEDITION warning

[x] Cancel search: warning

Page 12 of 368

FORD EXPEDITION 2005 2.G Owners Manual Air bag readiness:If this light fails
to illuminate when ignition is turned
to ON, continues to flash or remains
on, have the system serviced
immediately. A chime will also sound when a malfunction in

Page 13 of 368

FORD EXPEDITION 2005 2.G Owners Manual Check fuel cap (if equipped):
Illuminates when the fuel cap may
not be properly installed. Continued
driving with this light on may cause
the Service engine soon warning
light to come on. Refer toFuel

Page 14 of 368

FORD EXPEDITION 2005 2.G Owners Manual four-wheel drive is engaged. If the light fails to illuminate when the
ignition is turned ON, continues to flash or remains on, have the system
serviced immediately.
Door ajar (if equipped):
Illuminat

Page 43 of 368

FORD EXPEDITION 2005 2.G Owners Manual Don’t:
•Expose discs to direct sunlight or heat sources for extended periods
of time.
•Insert more than one disc into each slot of the CD changer magazine.
•Clean using a circular motion.
CD u

Page 55 of 368

FORD EXPEDITION 2005 2.G Owners Manual Whenever a warning is received, the radio volume will be lowered
to a volume that will allow the tones to be heard. The radio
volume will return to the previous level after the warning goes
away.
Fede

Page 134 of 368

FORD EXPEDITION 2005 2.G Owners Manual 4. Drive the vehicle slowly (less than 3 mph [5 km/h]) in circles until
CAL indicator turns off. As many as 5 complete circles may be required.
5. The compass is now calibrated.
MESSAGE CENTER (IF EQU

Page 136 of 368

FORD EXPEDITION 2005 2.G Owners Manual 7. To exit the zone setting mode,
and to “lock in” your change, press
and release the RESET control.
Perform compass calibration in an open area free from steel structures
and high voltage lines.

Page 139 of 368

FORD EXPEDITION 2005 2.G Owners Manual 1. To disable/enable the autolamp
delay feature, select this function
from the SETUP control for the
current display mode.
2. Press the RESET control to select
the new Autolamp delay values of >0, >10
Page:   < prev 1-8 9-16 17-24 25-32 33-40 41-48 ... 56 next >