Page 35 of 264

WARNING!
A rearward facing infant restraint must not be used
in your Viper unless the passenger airbag has been
shut off. A rearward facing infant restraint may be
struck by a deploying passenger airbag which may
cause severe or fatal injury to the infant.
In addition, some manufacturers make systems that can
be first used as an infant carrier, then converted to a child
seat as the child grows.
Here are some tips on getting the most out of your child
restraint.
Before buying any restraint system, make sure that it has
a label certifying that it meets Motor Vehicle Safety
Standard 213. The manufacturer also recommends that
before you buy a child restraint, you try it in the seat
where you will use it.The restraint must be appropriate for your child’s weight
and height. Check the label on the restraint for this too.
Carefully follow the instructions that came with the
restraint. If you install the restraint improperly, it may not
work when you need it.
WARNING!
Improper installation can lead to failure of a child
restraint. It could come loose in a collision. The child
could be badly injured or killed. Follow the manu-
facturer’s directions exactly when installing a child
restraint.
•Child restraints are secured in the passenger seat by
the lap part of the lap/shoulder belt.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 35
2
Page 127 of 264

Tire and Loading Information Placard
This placard tells you important information about the,
1) number of people that can be carried in the vehicle
2) the total weight your vehicle can carry
3) the tire size designed for your vehicle4) the cold tire inflation pressures for the front, rear
and spare tires.
Loading
The vehicle maximum load on the tire must not exceed
the load carrying capacity of the tire on your vehicle. You
will not exceed the tire’s load carrying capacity if you
adhere to the loading conditions, tire size and cold tire
inflation pressures specified on the Tire and Loading
Information placard and the Vehicle Loading section of
this manual.
NOTE:Under a maximum loaded vehicle condition,
gross axle weight ratings (GAWR’s) for the front and rear
axles must not be exceeded. For further information on
GAWR’s, vehicle loading and trailer towing, see the
Vehicle Loading section of this manual.
To determine the maximum loading conditions of your
vehicle, locate the statement“The combined weight of
occupants and cargo should never exceed XXX kg or XXX
Tire and Loading Information
STARTING AND OPERATING 127
5
Page 128 of 264

lbs.”on the Tire and Loading Information placard. The
combined weight of occupants, cargo/luggage and
trailer tongue weight (if applicable) should never exceed
the weight referenced here.
Steps for Determining Correct Load Limit
1. Locate the statement“The combined weight of occu-
pants and cargo should never exceed XXX pounds”on
your vehicle’s placard.
2. Determine the combined weight of the driver and
passengers that will be riding in your vehicle.
3. Subtract the combined weight of the driver and pas-
sengers from XXX kilograms or XXX pounds.
4. The resulting figure equals the available amount of
cargo and luggage load capacity. For example, if“XXX”
amount equals 1400 lbs. and there will be five 150 lb.
passengers in your vehicle, the amount of available cargo
and luggage load capacity is 650 lb. (since 5 x 150 = 750,
and 1400–750 = 650 lb.)5. Determine the combined weight of luggage and cargo
being loaded on the vehicle. That weight may not safely
exceed the available cargo and luggage load capacity
calculated in step 4.
6. If your vehicle will be towing a trailer, load from your
trailer will be transferred to your vehicle. Consult this
manual to determine how this reduces the available
cargo and luggage load capacity of your vehicle.
NOTE:The following table shows examples on how to
calculate total load, cargo/luggage and towing capacities
of your vehicle with varying seating configurations and
number and size of occupants. This table is for illustra-
tion purposes only and may not be accurate for the
seating and load carry capacity of your vehicle.
NOTE:For the following example the combined weight
of occupants and cargo should never exceed 865 lbs. (392
Kg).
128 STARTING AND OPERATING
Page 212 of 264

Headlight Aiming
The headlights on your new Viper were aimed at the
factory. The factory setting was made at a no load setting.
A great increase in weight will change the aiming and it
may be necessary to readjust the headlights if you
typically carry an excessive amount of weight in the
trunk or otherwise suspect misalignment.
Aiming Check
Each headlight assembly can be adjusted up and down
only. No left to right adjustment is necessary. To check,
proceed as follows:
1. Fill the fuel tank and park the vehicle on level ground.
A driveway is not normally level. If in doubt and you
have no way to check levelness, do not attempt to adjust
the headlights.
2.
Mark the position of the headlights on a wall prior to
loading the vehicle. Load the trunk with the items you
normally carry. Have someone sit in the driver’s seat who is
about the same weight as the person who drives the vehicle.
3. Push down on the front and rear of the vehicle several
times to make sure that the suspension has settled.
4. Then readjust the headlights to the original position.
NOTE:If any further adjustments are necessary, contact
your dealership.
FLUIDS AND CAPACITIESU.S. Metric
Fuel (approximate)
8.3 Liter Engine (Premium 91
Octane)18 gal-
lons68 liters
Engine Oil-With Filter
8.3 Liter Engines (0W-40) 10 qts. 9.5 Liters
Cooling System *
8.3 Liter Engines* (Mopar
Antifreeze/Coolant 5 Year/
102,000 Mile Formula)16 qts. 15 Liters
* Includes heater and coolant recovery bottle filled to
MAX level.
212 MAINTAINING YOUR VEHICLE
Page 245 of 264

Gas Caution.......................... 173
Jump Starting......................... 150
Keyless Transmitter Replacement............ 19
Bearings.............................. 194
Belt System, Six Point..................... 32
Belts, Drive............................ 168
Belts, Seat.............................. 26
Body Damage.......................... 195
Body Mechanism Lubrication............179,180
Body Mechanisms....................... 181
Boot, Convertible Top...................59,64
B-Pillar Location........................ 126
Brake, Parking.......................... 116
Brake System........................ 117,188
Anti-Lock............................ 117
Fluid Check.......................190,214
Hoses.............................. 189
Master Cylinder....................... 191
Warning Light......................... 91Break-In Recommendations, New Vehicle.....50,121
Bulb Replacement....................... 205
Bulbs, Light.........................204,205
Capacities, Antifreeze (Engine Coolant)........ 212
Capacities, Fluid........................ 212
Capacity, Cargo Weight................... 146
Caps, Filler
Power Steering........................ 178
Radiator (Coolant Pressure)............... 185
Car Washes............................ 197
Carbon Monoxide Warning...............51,145
Cargo Compartment
Capacity............................ 146
Carpeting............................. 196
Catalytic Converter...................... 168
CD Player............................95,98
CD Player Maintenance................... 103
Chains, Tire............................ 140
INDEX 245
10