Page 214 of 288
214 MAINTAINING YOUR VEHICLE
Headlamps, Taillamps, Identification Lamps,
Turn Signal Lenses . . . . . . . . . . . . . . . . . . . . . . . 234Reversing Aid Sensors . . . . . . . . . . . . . . . . . . . . 235Window Cleaning . . . . . . . . . . . . . . . . . . . . . . . 235Wiper Blade . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 236Light Alloy Wheels . . . . . . . . . . . . . . . . . . . . . . 236Instrument Cluster . . . . . . . . . . . . . . . . . . . . . . . 236Steering Wheel and Gear Selector Lever . . . . 236Cup Holder . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 237Seat Belts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 237Headliner and Shelf Below Rear Window . . . 237Upholstery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 237Hard Plastic Trim Items . . . . . . . . . . . . . . . . . . 237Plastic and Rubber Parts . . . . . . . . . . . . . . . . . . 238
Electrical Fuses . . . . . . . . . . . . . . . . . . . . . . . . . . . . 238Standard Fuse and Relay Equipment . . . . . . . 239Relay Assignment, Standard Equipment . . . . 242Fuse and Relay Optional Equipment . . . . . . . 242
Bulb Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . 245Front Lamp Unit . . . . . . . . . . . . . . . . . . . . . . . . . 245Taillamps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 250License Plate Lamps
(Cargo/Passenger Vans Only) . . . . . . . . . . . . . 252Additional Brake Lamp
(Cargo/Passenger Vans Only) . . . . . . . . . . . . . 252Side-Mounted Turn Signals . . . . . . . . . . . . . . . 253Side-Marker Lamps,
Standing Lamps (Optional) . . . . . . . . . . . . . . . . 253Identification Lamps (Cargo/
passenger vans only) . . . . . . . . . . . . . . . . . . . . . 254Interior Lighting in Passenger Compartment
and Load Compartment . . . . . . . . . . . . . . . . . . 254Interior Lighting with Reading Lamp . . . . . . . 255Interior Lighting with Interior Sensor
Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 255Exit Lamps (Optional) . . . . . . . . . . . . . . . . . . . . 256
Capacities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 257Recommended Fluids and Lubricants . . . . . . 258
Page 245 of 288
MAINTAINING YOUR VEHICLE 245
7
BULB REPLACEMENTSwitch the lights off to prevent short circuits.
Only touch new bulbs with a clean, lint-free cloth. Do
not touch bulbs with wet or greasy fingers.
Only fit 12 volt bulbs of the same type as before and
with the correct wattage rating.
Front Lamp UnitBulbs are changed from inside the engine
compartment.
Move the retainer bar to the side and remove the
housing cover.
WARNING!
Bulbs and bulb holders can become very hot. Al-
low the lamp to cool down before changing the
bulb.
Keep bulbs out of reach of children.
Do not use bulbs which have been dropped or
which show signs of scratches on the glass. They
could explode.
Changing an H7 bulb:
The bulb is pressurized. Always wear eye and
hand protection.
Page 246 of 288
246 MAINTAINING YOUR VEHICLE1. Turn signal lamp and sidemarker lamp, 3457 NA – 12V 28 / 7.5W, yellow glass
2. Low beam headlamp, H7 – 12V 55W
3. Fog lamp, H1 – 12V 55W
4. Side and parking lamps, W5W – 12V 5W
5. High beam headlamps, H1 – 12V 55 Turn Signal Lamps and Side-Marker Lamps
1. Turn bulb holder, together with bulb,
counterclockwise and remove.
2. Remove the bulb from the bulb holder.
3. Insert a new bulb in the bulb holder.
4. Insert the bulb holder together with the bulb and turn clockwise to the stop.
Page 247 of 288
MAINTAINING YOUR VEHICLE 247
7
Low Beam Headlamps
1. Unplug the cable connector from the bulb.
2. Unclip in the retaining springs. Press the retaining springs towards the headlamps and down
(direction of arrow). 3. Remove the bulb.
4. Insert the new bulb so that the retaining lugs are
fed into the recesses in the reflector section of the
bulb holder.
5. Clip in the retaining springs.
6. Press on the cable connector.
7. Secure the housing cap.
Page 248 of 288
248 MAINTAINING YOUR VEHICLEFog Lamp (Optional)
1. Remove the cable connector from the bulb holder.
2. Press both retaining springs in the direction of the headlamps and then outward (in the direction of
the arrow). 3. Remove the bulb.
4. Put in the new bulb so that the retaining lugs on the
bulb holder are inserted into the recesses in the
bulb holder reflector section.
5. Secure both retaining springs.
6. Press on the cable connector.
7. Secure the housing cap.
Page 249 of 288
MAINTAINING YOUR VEHICLE 249
7
Side and Parking Lamps
1. Pull out the bulb holder with the bulb.
2. Replace the bulb.
3. Insert the bulb holder.
4. Secure the housing cap. High Beam Headlamp
1. Unplug the cable connector from the bulb.
2. Press the retaining spring towards the headlamps
and outwards (direction of arrow).
3. Remove the bulb.
4. Insert the new bulb so that the retaining lugs are fed into the recesses in the reflector section of the bulb holder.5. Clip in the retaining springs.
6. Press on the cable connector.
7. Secure the housing cap.
Page 250 of 288
250 MAINTAINING YOUR VEHICLETaillampsCargo/Passenger Van
1. Locked
2. Unlocked
Bulbs are changed from inside the cargo area.
The rear lamp cluster bulb holder is located behind the
interior paneling. Remove the paneling. (1) Brake lamp, taillamp, standing lamp,
P21/5W – 12V 21/5W
(2) Backup lamp, P21W – 12V 21W
(3) Turn signal lamp, P21W – 12V 21W
(4) Side-marker lamp, R5W – 12V 5W 1. Unclip and remove the bulb socket.
2. To change a bulb, press the bulb into the bulb socket, turn it counterclockwise and remove.
3. Insert the new bulb.
4. Clip the bulb socket into place.
Page 251 of 288
MAINTAINING YOUR VEHICLE 251
7
Chassis
(1) Retaining screws
(2) Clearance lamp, R5W - 12V 5W
(3) Turn signal lamp, P21W - 12V 21W
(4) Stop lamp, P21W - 12V 21W
(5) Taillamp, R5W - 12V 5W
(6) Backup lamp, P21W - 12V 21W
(7) License plate lamp (driver‘s side only), R5W - 12V 5W 1. Loosen retaining screw a and remove lamp
housing.
2. To change a bulb, press the bulb into the bulb socket, turn it counterclockwise and remove.
3. Insert the new bulb.
4. Install lamp housing.
