EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)
is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system should be determined
not ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.2. Turn the ignition to the ON position, but do not crank
or start the engine.
3. If you crank or start the engine, you will have to start
this test over.
4. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
5. Approximately 15 seconds later, one of two things will
happen:
a. The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn off
the ignition key or start the engine. This means that
your vehicle’s OBD system isnot readyand you
shouldnotproceed to the I/M station.
b. The MIL will not flash at all and will remain fully
illuminated until you turn off the ignition key or
start the engine. This means that your vehicle’s OBD
system isreadyand you can proceed to the I/M
station.
MAINTAINING YOUR VEHICLE 143
7
Alignment.......................... 118
Chains............................. 119
Changing........................... 130
Compact Spare....................... 115
General Information................... 112
High Speed.......................... 114
Inflation Pressures.................... 113
Jacking............................. 130
Load Capacity....................108,109
Quality Grading...................... 201
Radial.............................. 115
Replacement......................... 117
Rotation............................ 120
Safety.............................. 112
Sizes............................... 105
Snow Tires.......................... 119
Spinning............................ 116
Tread Wear Indicators.................. 117
Towing
Disabled Vehicle...................... 138
Transaxle
Manual...........................95,98
Transmitter Battery Service................ 20Transporting Pets........................ 44
Tread Wear Indicators.................... 117
Trip Odometer Reset Button................ 72
Trunk Release Button..................... 17
Trunk Release, Emergency................. 17
Trunk Release Remote Control.............. 17
Turbo Boost Gauge...................91,121
Turbo Cool Down....................... 97
Turn Signals.........................57,70
Underhood Fuses....................... 170
Uniform Tire Quality Grades.............. 201
Untwisting Procedure, Seat Belt............. 28
Vacuum/Vapor Harnesses................ 161
Vehicle Identification Number............... 6
Vehicle Loading........................ 125
Vehicle Modifications/Alterations............ 6
Vehicle Storage......................... 173
Warning Lights (Instrument Cluster Description) . 69
Warnings and Cautions.................... 6
Warranty Information.................... 198
INDEX 213
10
