2005 CHRYSLER VOYAGER wheel bolts

[x] Cancel search: wheel bolts

Page 1512 of 2339

CHRYSLER VOYAGER 2005  Service Manual (69) Install and tighten solenoid/pressure switch
assembly-to-transaxle case bolts to 12 N´m (110 in.
lbs.) (Fig. 158).
(70) Install and torque input and output speed
sensors to case to 27 N´m (20 f

Page 1617 of 2339

CHRYSLER VOYAGER 2005  Service Manual (11) Reposition leak detection pump harness and
hoses.
(12) Remove rear mount bracket-to-transaxle case
bolts (Fig. 13).
(13) Remove transaxle upper bellhousing-to-block
bolts.
(14) Raise vehicle on h

Page 1657 of 2339

CHRYSLER VOYAGER 2005  Service Manual (69) Install and tighten solenoid/pressure switch
assembly-to-transaxle case bolts to 12 N´m (110 in.
lbs.) (Fig. 158).
(70) Install and torque input and output speed
sensors to case to 27 N´m (20 f

Page 1778 of 2339

CHRYSLER VOYAGER 2005  Service Manual WHEEL MOUNTING STUDS -
FRONT
REMOVAL
NOTE: Before proceeding, (Refer to 5 - BRAKES -
WARNING)(Refer to 5 - BRAKES - CAUTION).
CAUTION: Wheel mounting studs MUST NOT be
hammered out of hub flange of hu

Page 1794 of 2339

CHRYSLER VOYAGER 2005  Service Manual CHECK STRAP
REMOVAL
(1) Remove front door trim panel.
(2) Remove front door watershield (Refer to 23 -
BODY/DOOR - FRONT/WATERSHIELD -
REMOVAL).
(3) Remove front door speaker, if equipped.
(4) Remove

Page 1795 of 2339

CHRYSLER VOYAGER 2005  Service Manual (2) Position door to vehicle. Verify net pierce nub-
bin is engaged if reusing original hinges. Applies to
body half of hinge only.
(3) Steady door on lifting device and install bolts
attaching upper

Page 1836 of 2339

CHRYSLER VOYAGER 2005  Service Manual (2) Insert ends of crossmember between layered
metal sections of radiator closure panel at each side
of radiator.
(3) Align with paint breaks around bolt heads.
(4) Install bolts attaching ends of cro

Page 1839 of 2339

CHRYSLER VOYAGER 2005  Service Manual INSTALLATION
SHORT WHEELBASE
(1) Position the air exhauster to the hole in the
lower aperture panel (Fig. 21).
(2) Using hand pressure, press the air exhauster
into the opening in the lower aperture p