2005 CHRYSLER PACIFICA power steering

WARNING!
Fluid level should be checked on a level surface and
with the engine off to prevent injury from moving
parts and to insure accurate fluid level reading. Do
not overfill. Use only manufacturers recommended
power steering fluid.
If necessary, add fluid to restore to the proper indicated
level. With a clean cloth, wipe any spilled fluid from all
surfaces. Refer to Recommended Fluids, Lubricants, and
Genuine Parts for correct fluid type.
Front & Rear Suspension Ball Joints
The suspension ball joints are permanently sealed. No
regular maintenance is required for these components.
Steering Shaft Seal
The steering shaft seal, at the point where the shaft passes
through the bulkhead, is lubricated when it is installed. If
the seal becomes noisy when the steering shaft is turned,
it should be lubricated with a multi-purpose grease.
Mopar multi-purpose lubricant is recommended.
Steering Linkage
The tie rod end ball joints are permanently lubricated and
do not require periodic maintenance.
Drive Shaft Universal Joints
Your vehicle has constant velocity universal joints. Peri-
odic lubrication of these joints is not required. However,
the joint boots should be inspected for external leakage or
damage when other maintenance is performed. If leakage
or damage is evident, the universal joint boot and grease
should be replaced immediately.
MAINTAINING YOUR VEHICLE 337
7

Insure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
Components should be replaced immediately if there is
any evidence of wear or damage that could cause failure.
Brakes
In order to assure brake system performance, all brake
system components should be inspected periodically.
Suggested service intervals can be found in the Mainte-
nance Schedules.
WARNING!
Riding the brakes can lead to brake failure and
possibly an accident. Driving with your foot resting
or riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You wouldn’t have your full
braking capacity in an emergency.
Brake And Power Steering Hoses
When the vehicle is serviced for scheduled maintenance,
inspect surface of hoses and nylon tubing for evidence of
heat and mechanical damage. Hard and brittle rubber,
cracking, tears, cuts, abrasion, and excessive swelling
indicate deterioration of the rubber. Particular attention
should be made to examining those hose surfaces nearest
to high heat sources, such as the exhaust manifold.
346 MAINTAINING YOUR VEHICLE

Insure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
NOTE:Often, fluid such as oil, power steering fluid,
and brake fluid are used during assembly plant opera-
tions to facilitate the assembly of hoses to couplings.
Therefore, oil wetness at the hose-coupling area is not
necessarily an indication of leakage. Actual dripping of
hot fluid when systems are under pressure (during
vehicle operation), should be noted before a hose is
replaced based on leakage.
NOTE:Inspection of brake hoses should be performed
whenever the brake system is serviced and at every
engine oil change. Inspect hydraulic brake hoses for
surface cracking, scuffing, or worn spots. If there is any
evidence of cracking, scuffing, or worn spots, the hoseshould be replaced immediately! Eventual deterioration
of the hose can take place resulting in a possibility of a
burst failure.
WARNING!
Worn brake hoses can burst and cause brake failure.
You could have an accident. If you see any signs of
cracking, scuffing, or worn spots, have the brake
hoses replaced immediately.
Master Cylinder—ABS Brakes Brake Fluid Level
Check
The fluid level in the master cylinder should be checked
when performing underhood services, or immediately if
the brake system warning light indicates system failure.
MAINTAINING YOUR VEHICLE 347
7

Chassis
Component Fluids, Lubricants and Genuine Parts
Automatic Transmission MoparATF+4 Automatic Transmission Fluid or equivalent.
AWD Power Transfer Unit MoparGear Lubricant 75W-90 or equivalent.
AWD Overrunning Clutch MoparATF+4 Automatic Transmission Fluid or equivalent.
AWD Rear Carrier MoparGear Lubricant 75W-90 or equivalent.
Brake Master Cylinder MoparDOT 3 and SAE J1703 should be used. If DOT 3 brake fluid is not
available, then DOT 4 or DOT 4+ is acceptable. Use only recommended
brake fluids.
Power Steering Reservoir MoparATF+4 Automatic Transmission Fluid or equivalent.
370 MAINTAINING YOUR VEHICLE

Filters
Air Cleaner.......................... 331
Air Conditioning....................243,336
Automatic Transaxle.................... 351
Engine Fuel.......................... 332
Engine Oil........................330,369
Engine Oil Disposal.................... 330
Flashers
Hazard Warning....................... 300
Turn Signal.....................166,366,367
Floor Console.......................... 151
Fluid Capacities......................... 368
Fluid Leaks............................. 69
Fluid Level Checks
Automatic Transmission................. 350
Brake............................347,370
Power Steering.....................336,370
Fluids................................ 369
Fog Light Service........................ 366Fog Lights.......................124,171,366
Folding Rear Seat........................ 113
Freeing A Stuck Vehicle................... 312
Fuel................................. 287
Adding............................. 290
Additives............................ 289
Clean Air............................ 287
Filler Cap............................ 290
Filter............................... 332
Gasoline............................ 287
Gauge.............................. 166
Hoses.............................. 349
Octane Rating......................287,369
Requirements......................287,368
Tank Capacity........................ 368
Fuel System Caution..................... 289
Fueling............................... 290
Fuses................................ 359
INDEX 409
10

Security Alarm (Theft Alarm)................ 25
Selection of Coolant...................341,369
Sentry Key............................. 12
Sentry Key Programming................... 14
Service Assistance....................... 394
Service Contract......................... 396
Service Engine Soon Light (Malfunction Indicator) . 170
Service Manuals........................ 400
Setting the Clock.....................182,183
Shoulder Belts........................... 33
Signals, Turn.....................166,366,367
Slippery Surfaces, Driving On............... 311
Snow Chains (Tire Chains)................. 284
Snow Tires............................ 285
Spare Tire.......................276,277,304
Spark Plugs............................ 331
Speed Control.......................... 134
Speedometer........................... 166
Starting............................... 248Engine Fails to Start.................... 249
Starting and Operating.................... 248
Starting Procedures...................... 248
Steering
Linkage............................. 337
Power...........................261,336
Shaft Seal............................ 337
Tilt Column.......................... 129
Steering Wheel Mounted Sound System
Controls............................. 218
Storage............................151,362
Storage, Vehicle......................242,362
Storing Your Vehicle...................... 362
Sun Roof.............................. 145
Sun Visor Extension....................... 79
Sunglass Storage........................ 138
Sunroof Maintenance..................... 148
Supplemental Restraint System - Airbag........ 44
Synthetic Engine Oil...................... 330
INDEX 417
10