2005 CHRYSLER 300 Owners Manual

Page 273 of 374

CHRYSLER 300 2005 1.G Owners Manual Wheel Cover Installation (If Required)
1. Tighten the two lug nuts on the mounting studs on
each side of the stud which is in alignment with the valve
stem.
2. Align the valve notch in the wheel cover

Page 274 of 374

CHRYSLER 300 2005 1.G Owners Manual WARNING!
²Do not attempt to push or tow your vehicle to get it
started. Vehicles equipped with an automatic trans-
mission cannot be started this way. Unburned fuel
could enter the catalytic converte

Page 275 of 374

CHRYSLER 300 2005 1.G Owners Manual 4. Connect one end of the jumper cable to the remote
jump start positive battery post (A) in the engine com-
partment. Connect the other end of the same cable to the
positive terminal of the booster b

Page 276 of 374

CHRYSLER 300 2005 1.G Owners Manual DRIVING ON SLIPPERY SURFACES
Acceleration
Rapid acceleration on snow covered, wet, or other slip-
pery surfaces may cause the rear wheels to pull errati-
cally to the right or left. This phenomenon oc

Page 277 of 374

CHRYSLER 300 2005 1.G Owners Manual FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand or snow, it
can often be moved by a rocking motion. Turn your
steering wheel right and left to clear the area around the
front wheels

Page 278 of 374

CHRYSLER 300 2005 1.G Owners Manual TOWING A DISABLED VEHICLE
With Ignition Key
Your vehicle may be towed under the following condi-
tions: The gear selector must be in NEUTRAL, the
distance to be traveled must not exceed 30 miles (48 k

Page 279 of 374

CHRYSLER 300 2005 1.G Owners Manual Without The Ignition Key
Special care must be taken when the vehicle is towed
with the ignition in the LOCK position. The only ap-
proved method of towing with out the ignition key is
with a flat bed

Page 280 of 374

CHRYSLER 300 2005 1.G Owners Manual