11
Rainsense™ Wipers (if equipped)
The Rainsense system monitors the
amount of moisture on the windshieldand automatically operates the wipers
as needed, depending on driving condi
tions and the sensitivity setting. The
moisture sensor is mounted on the inte rior side of the windshield behind the
rearview mirror.
The Rainsense wipers operate in a
delay mode as well as a continuous lowor high speed as needed. If the system
is left on for long periods of time, occa sional wipes may occur without anymoisture on the windshield to indicatethe system is active.
To activate the Rainsense wipers:
Turn the wiper band to one of the five
sensitivity levels within the delay area.
The position closest to OFF is the low
est sensitivity level. Each higher sensi tivity level increases the frequency of
wipes. The system can be overridden atany time by manually turning the wiperband to LO or HI speed.
See Section 3 of your Owner Manual.
Cruise Control
Set Cruise Control
The Cruise Control buttons are located
on the steering wheel. Press theON/OFF button to turn Cruise Control
on. Accelerate to the speed you want to set.
Press the SET/COAST button. The
Cruise Control light on the instrumentcluster will illuminate. Remove your footfrom the accelerator pedal.
Resume Set Speed
Applying the brakes will turn the Cruise
Control off.
Press the RESUME/ACCELbutton.
The vehicle’s preset speed will resume.
OFF
Press ON/OFF or step on the brake
pedal.
See Section 3 of your Owner Manual.
Notice:Turn the Rainsense
wipers off to avoid wiper damagewhen going through an automaticcar wash.
Headlamps — High Beam
High/Low Beam Changer
Pull the turn signal lever toward you until
it clicks to change from low beam tohigh beam.
Flash To Pass
Pull and hold the turn signal lever toward
you briefly to flash the headlamps.
See Section 3 of your Owner Manual.
