13
HomeLink®Wireless Control
System
The HomeLink system can store three
frequencies for a garage door opener,entry door lock, security system, etc.
To program, with the engine Off:
• Press and hold the two outer buttons
on the HomeLink until the indicatorlight flashes;
then release the buttons(about 20 seconds — do not hold for
more than 30 seconds); do not repeatthis step for the second or thirddevices added.
• Hold the end of your hand held trans
mitter up to three inches away fromthe surface of the HomeLink. Hold itsbutton and the button you wish toassign it to on the HomeLink system.
• Continue holding both buttons (up to
90 seconds); the indicator light will
begin blinking slowly, then more quick
ly. Programming is complete whenthe HomeLink light flashes rapidly.
• Release both buttons.
• Press and hold the HomeLink button
again. If the indicator stays lit con
stantly, programming is complete.
• Continue programming additional
devices using the remaining two
HomeLink buttons, but do not simul taneously press the two outer buttonson the HomeLink again.
If the HomeLink indicator blinks rapidly
for two seconds and remains on duringprogramming, it indicates that yourdevice (usually a garage door opener)has a “rolling code.”
See Section 2 of your Owner Manual.
Accessory Power Outlets
Your vehicle is equipped with 12 volt
outlets. One is located on the center
console below the climate controls. The
second outlet is located inside the cen ter storage console. On 6 passengermodels, the second outlet is located inthe flip/fold console. Use them to powercellular phones, CB radio, etc. See your
Owner Manual for full safety and war ranty cautions.
See Section 3 of your Owner Manual.
