2005 Alfa Romeo GT seats

GETTING TO KNOW YOUR CAR
34
GROUP 2 (fig. 45)
Starting from 15 to 25 kg in weight,
children may be restrained directly by the
car seat belts.
Child seats only have the function of
positioning the child correctly in relation to
the belts, so that the diagonal part
adheres to the chest and never to the neck
and that the horizontal part adheres to the
child’s pelvis and not to the abdomen.
GROUP 3 (fig. 46)
For children from 22 up to 36 kg the
child’s chest is thick enough not to need
the spacer back rest anymore.
The figure shows proper child seat posi-
tioning on the rear seat.
Over 1,50 m in height, children may
wear seat belts like adults.The illustration is indica-
tive only for assembly. As-
semble the seat according
to the compulsory instructions pro-
vided with it.
fig. 45
A0A0661b
fig. 46
A0A0662b

GETTING TO KNOW YOUR CAR
35
PASSENGER SEAT COMPLIANCE WITH REGULATIONS ON CHILD’S SEAT USE
The car omplies with the new EC Directive 2000/3 regulating child’s seat assembling on the different car seats according to the follow-
ing table:
Key:
U= suitable for child restraint systems of the “Universal category”, according to European Standard ECE-R44 for the specified “Group”.
Group
Group 0, 0+
Group 1
Group 2
Group 3
Range of weight
until 13 kg
9-18 kg
15-25 kg
22-36 kgFront
passenger
U
U
U
URear
passengers
U
U
U
UCentral
passenger
U
U
U
U

GETTING TO KNOW YOUR CAR
36
Below is a summary of the safe-
ty rules to be observed when car-
rying children:
– The recommended position for
installing a child’s seat is on the rear seat,
as it is the most protected in the event of
a crash.
– If the passenger’s air bag is deactivat-
ed,alwayscheck the warning light
F
on the cluster to make sure that it has
actually been deactivated.
– Carefully follow the instructions pro-
vided with the child’s seat, which the sup-
plier is obliged to attach. Keep them in the
car together with the documents and this
booklet. Do not use used seats without
the instructions for use.
– Always pull the tape to check that
belts are buckled.With passenger’s air bag
active, never place child’s
seats with the cradle fac-
ing backwards since the air bag ac-
tivation could cause to the child se-
rious injuries, even mortal, re-
gardless of the seriousness of the
crash that triggered it. You are ad-
vised to carry children always with
proper restraint systems on the
rear seats, as this is the most pro-
tected position in the case of a
crash.– All restraint systems are strictly for one
child only: never use for two children at
the same time.
– Always make sure that the belts do
not rest on the child’s neck.
– During the journey, do not allow the
child to stay in abnormal positions or
release the belts.
– Do not carry children in your arms, not
even small babies. No-one, however
strong, can keep hold od them in a crash.
– In the case of accidents, replace the
child’s seat with a new one.
PRESETTING FOR
MOUNTING THE
“TYPE ISOFIX” CHILD
RESTRAINT SYSTEM
The vehicle is fitted with rear seat
arranged for mounting type Isofix child
restraint system, a European standardised
system for mounting child restraints. Type
Isofix is an additional option that does not
prevent from using traditional child
restraint systems. The type Isofix child’s
seat covers three weight groups: 0, 0+
and 1.
Due to its different anchoring system,
the type Isofix child’s seat shall be
anchored just using the metal brackets
(A-fig. 47) set between rear seat back
and cushion.
fig. 47
A0A0671b

GETTING TO KNOW YOUR CAR
37
Mount the child restraint
system only with the car
stationary. The Isofix child
restraint system is properly an-
chored to the mounting brackets
when clicks are heard. In any case,
keep to the installation instructions
that must be provided by the child
restraint system Manufacturer.– push the child restraint system until
hearing the locking clicks;
– check proper locking by moving the
child’s seat with force: the built-in safety
mechanism actually inhibits proper cou-
pling with only one coupling locked.
It is possible to mount both the tradi-
tional restraint system and the type Isofix
one, one on the left and the other on the
right, for example.
Since sizes are different, it is possible to
install max two traditional child’s seats on
the rear seats, or two type Isofix child’s
seats. On the front passenger’s seat it is
possible to mount only traditional child’s
seats.
These child’s seats are recommended
since they have been designed and exper-
imented expressely for this car.
fig. 48
A0A0663b
FITTING THE TYPE ISOFIX
CHILD’S SEAT
Groups 0 and 0+
For children of the 0 and 0+ group
(babies up to 13 Kg), the child’s seat is
facing backwards and the child is restrained
by the child’s seat belts (D-fig. 48).
As the child grows, passing to weight
group 1, the child’s seat shall be fitted fac-
ing forwards.
For proper mounting proceed as follows:
– check whether the release lever (B) is
at rest position (inward);
– find the presetting brackets (A), then
position the child restraint system with the
fastening devices (C) aligned with the
brackets;

GETTING TO KNOW YOUR CAR
40
PASSENGER’S FRONT AIR BAG
It is formed of a cushion contained in a
special recess of the dashboard that inflates
instantaneously and a cushion of bigger vol-
ume than the driver’s one
(fig. 51).
MANUAL DEACTIVATION OF
PASSENGER’S FRONT AIR BAG
(
fig. 52)(optional for versions /
markets where applicable)
Should it be absolutely necessary to
carry a child on the front seat, the pas-
senger’s font air bag can be deactivated.
Deactivation/reactivation takes place
with ignition key at STOPand through
the key operating the switch in the glove
compartment. SERIOUS DANGER
If it is absolutely
necessary to carry a
child on the front passenger seat
with the cradle child’s seat facing
backwards, the front passenger’s
air bags must be deactivated using
the key switch. In this case it is ab-
solutely necessary to check the
warning light Fon the instru-
ment panel (see paragraph “Pas-
senger’s front air bag”) to make
sure that deactivation has actual-
ly taken place. Moreover, the front
passenger’s seat shall be adjust-
ed in the most backward position
to prevent any contact between
the child’s seat and the dashboard.
fig. 51
A0A0392b
fig. 52
A0A0392b
With passenger’s air bag
active, never place child’s
seats with the cradle fac-
ing backwards since the air bag ac-
tivation could cause to the child se-
rious injuries, even mortal, re-
gardless of the seriousness of the
crash that triggered it. You are ad-
vised to carry children always with
proper restraint systems on the
rear seats, as this is the most pro-
tected position in the case of a
crash.

GETTING TO KNOW YOUR CAR
43
GENERAL CAUTIONS
If the ¬warning light does
not turn on when turning
the ignition key to MAR or
if it stays on when travelling, this
could indicate a failure in safety re-
taining systems; under this condi-
tion air bags or pretensioners could
not trigger in the event of collision
or, in a restricted number of cas-
es, they could trigger accidentally.
Stop the car and contact Alfa
Romeo Authorised Services.
Do not cover the back rest
of front seats with trims or
covers there are not set for
the use of side bags.Never travel with objects
on your lap, in front of the
chest or with a pipe, pen-
cil, etc. Serious injury may result in
the case of the air bag being trig-
gered.
Always keep your hands
on the steering wheel rim
when driving, so that if the
air bag is triggered, it can inflate
without meeting obstacles. Do not
drive with the body bent forwards,
keep the seat back rest in the erect
position and lean your back well
against it.
If the car has been stolen
or an attempt to steal it
has been made, if it has
been subjected to vandals or
floods, have the air bag system
checked by Alfa Romeo Authorised
Services.
You are reminded that
when the ignition key is
engaged and in the MAR
position, even with the engine off,
the air bags can be triggered also
on a stationary vehicle, if it is
bumped by another moving vehi-
cle. Therefore, even with the car
stationary, never allow children on
the front seat. You are also re-
minded that with the ignition key
engaged in the STOP position, the
safety devices (air bags or preten-
sioners) are not triggered in the
event of an impact; in this case the
failure to trigger the air bags
should not be considered a system
failure.

GETTING TO KNOW YOUR CAR
126
The adjustment of Xenon headlights is au-
tomatic, therefore the versions fitted with
this optional lack the headlight aiming de-
vice (fig. 116a).
HAND BRAKE(fig. 117)
The hand brake lever is located between
the two front seats.
To operate the brake when the vehicle is
stationary, pull lever (A) upwards, until the
required braking action is obtained.
When the ignition key is at MAR, the
warning light on the instrument cluster
x
will come on.
fig. 117
A0A0620b
fig. 116a versions with Xenon headlights
A0A0677b
Adjust the beams every
time the load carried
changes.
For correct adjustment, bear in mind the
following conditions:
– position 0: one or two people occupy-
ing the the front seats
– position 1: five people;
– position 2: five people + load in the
boot;
– position 3: driver + maximum permis-
sible load all stowed in lug-
gage compartment
fig. 116 versions without Xenon headlights
A0A0093b
HEADLIGHT AIMING DEVICE
(fig. 116)
The headlights should be aimed correctly
depending on the vehicle load.
To do this, use the rocker button (A), on
the plate at the side of the steering column:
– press the arrow on the button (
A), to
increase by one position (e.g.:0
➟1➟2➟
3);
– press the arrow on the button (
S), to lower
by one position (e.g.:3
➟2➟1➟0);
The display (B) in the tachometer shows the
positions during adjustment.

GETTING TO KNOW YOUR CAR
149
Check beam aiming every
time the load carried
changes.
fig. 152
A0A0199b
For correct adjustment, bear in mind the
following conditions:
– position 0: one or two people occupy-
ing the front seats
– position 1: five people;
– position 2: five people + load in the
boot;
– position 3: driver + maximum permis-
sible load all stowed in lug-
gage compartmentHEADLIGHT ADJUSTMENT
ABROAD
(fig. 152)
The dipped-beam headlights are adjusted
for circulation in the country in which the ve-
hicle is marketed. In countries with opposite
circulation, to avoid glaring oncoming vehi-
cles it is necessary to cover the area of the
headlights as shown below; this is done us-
ing non-transparent sticker tape.
The illustration refers to passing from right-
hand drive to left-hand drive.
fig. 151
A0A00677b
IMPORTANTThe compensation for tilt of
Xenon headlights (if fitted) is carried out au-
tomatically and therefore in the versions fitted
with this type of headlights the aiming de-
vice is not present (fig. 151).