Page 65 of 307

GETTING TO KNOW YOUR CAR
63
If the display shows a failure message, see the details given in the
“Warning lights” chapter; if there are two or more failures, the display
shows them in cycle, one after the other. To eliminate the display of the
message and/or of the warning light repeated on the rev counter
by the reconfigurable multifunction display press button
Q.
INITIAL CHECK
Turning the ignition key to MAR, the reconfigurable multifunction display shows the message CHECK ACTIVE: the diagnostic phase of
all the electronic systems on the car has started; this lasts for about 4 seconds (for JTD versions only, the multifunction reconfigurable dis-
play is also able to show the engine oil level, see the “Engine oil level check” paragraph below). If no faults are detected, when the engine
has started, the display shows the OK message.
IMPORTANT If the reconfigurable multifunction display shows a failure message, see the details given in the “Warning lights” chapter.
Standard screen with
mechanical transmission Only JTD versionsStandard screen with
Selespeed transmission
The Programmed Maintenance
Schedule includes vehicle
maintenance every 20,000
km; this is shown automatical-
ly with the ignition key at
MAR, starting from 2,000
km (or miles) from this dead-
line and it is shown again
every 200 km.
If no failures
are presentIs the
engine
started?YES
NO
Page 85 of 307

GETTING TO KNOW YOUR CAR
83
DIMMER
With this function it is possible to adjust the lighting (dimming/brightening) of the instrument cluster, mileage recorder (total, trip meter),
headlamp aiming display, radio display, radio navigator display and two-zone climate control.
Partial lighting
Keeping the
ãbutton pressed (on the plate at the side of the steering column) for more than 4 seconds, the instrument cluster light-
ing is turned off with the exception of the speedometer.
Keeping the
âbutton pressed (on the plate at the side of the steering column) for more than 4 seconds, the complete instrument clus-
ter lighting is turned on again.
Standard screen
with mechanical
transmission
Standard screen with
Selespeed transmission
Return to
standard screen
IMPORTANT
When the outer lights are switched on, dimming of the brightness
can be perceived. In the event of any faults, lighting adjustment
(rheostat) is not possible and the display is
shown at its maximum brightness.
QR
â
ã
â
ãâ
ã
See
INITIAL CHECK
Page 86 of 307
GETTING TO KNOW YOUR CAR
84
DISPLAYS IN CONCURRENCE WITH THE EVENT
Standard screen:
when the radio is
turned on in the
RADIO DISPLAY ON
condition
Standard screen:
when a phone call is
received in the TELEPHONE
DISPLAY ON conditionDisplay with the ignition key removed open-
ing or closing a door.
The reconfigurable multifunction display
together with the mileage recorder display
(total and trip) is timed, after 10 seconds it
goes off automatically.
In the event of a failure
see the “Warning lights”
chapterStandard screen:
during assisted
navigation in the
NAVIGATION DISPLAY
ON condition
The displays illustrated
are purely indicative.
fig. 87
A0A0676b
Page 87 of 307

GETTING TO KNOW YOUR CAR
85
Warning
light on dialMessage
on display
WARNING LIGHTS
IMPORTANTThe number of warning lights present depends on the type of engine and equipment with which the car is fitted.
x
LOW BRAKE FLUID AND/OR HANDBRAKE ON
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds.
The warning light turns on when the level of the brake fluid in the reservoir falls below the min-
imum level, due to a possible leak in the circuit and when the handbrake is engaged.
If the
xwarning light turns on when travelling check that the hand-
brake is not engaged. If the warning light stays on with the handbrake
off (on some versions together with the message + symbol shown on
the reconfigurable multifunction display) stop the car immediately and contact
Alfa Romeo Authorised Services.
u
HIGH ENGINE COOLANT FLUID TEMPERATURE
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds.
The warning light turns on (on some versions together with the message + symbol shown on
the reconfigurable multifunction display) when the engine is overheated. If it turns on when trav-
elling, stop the car, leaving the engine on and slightly accelerated to further activate the circula-
tion of the coolant fluid.
If the warning doesn’t go off within 2 or 3 minutes, stop the car immediately and contact Alfa
Romeo Authorised Services.
Page 93 of 307
GETTING TO KNOW YOUR CAR
91
Warning
light on dialMessage
on display
ALFA ROMEO CODE SYSTEM
Turning the key to MARthe warning light on the dial turns on; it should flash only once and
then go off. If, with the ignition key at MAR, the warning light stays on, this indicates a possi-
ble failure: “Alfa Romeo CODE system”.
IMPORTANTThe turning on at the same time of the
UandYwarning lights indicates
a failure of the Alfa Romeo CODE system.
If, with the engine running, the message + symbol are shown on the reconfigurable multifunc-
tion display, contact Alfa Romeo Authorised Services immediately.
Y
If with the engine running, the Ywarning light flashes, on some versions together with the
message + symbol on the reconfigurable multifunction display, this means that the car is not pro-
tected by the engine inhibitor device (see “Alfa Romeo CODE system” in this chapter). Contact
Alfa Romeo Authorised Services to have all the keys memorised.
Page 96 of 307

GETTING TO KNOW YOUR CAR
94
Warning
light on dialMessage
on display
>
INEFFICIENT ABS SYSTEM (where fitted)
Turning the ignition key to MARthe warning light on the dial turns on, but it should go off after
approx. 4 seconds.
The warning light turns on (on some versions the message + symbol are shown on the recon-
figurable multifunction display) when the system is inefficient. In this case the braking system
keeps its effectiveness unchanged, but without the potential offered by the ABS system. Caution
is advised, particularly in all cases of less than perfect grip. It is also necessary to contact Alfa
Romeo Authorised Services.
The car is fitted with electronic braking distributor (EBD). The turn-
ing on at the same time of the
xand>warning lights on the dial
(on some versions the message + symbol are shown on the reconfig-
urable multifunction display) with the engine running indicates an EBD system
failure; in this case heavy braking may cause the rear wheels to lock before
time, with the possibility of skidding. Driving extremely carefully, immedi-
ately contact Alfa Romeo Authorised Services to have the system checked.
The turning on only of the
>warning light (on some versions the
message + symbol are shown on the reconfigurable multifunction dis-
play) with the engine running normally indicates a failure of the ABS
system only. In this case the braking system maintains its effectiveness,
without however the antilock function. In these conditions, the effectiveness
of the EBD may also be reduced. In this case, too, you are recommended to
contact the nearest Alfa Romeo Authorised Service immediately, driving in
such a way as to avoid sharp braking, to have the system checked.
Inefficient EBD electronic braking distributor
x
>
+
Page 98 of 307
GETTING TO KNOW YOUR CAR
96
Warning
light on dialMessage
on display
W
LIGTH FAILURE
Turning the key to MAR, the warning light on the dial turns on but should go out after about
6 seconds.
The message + symbol are shown by the reconfigurable multifunction display when a fault to
any one of the following ligths is detected:
- sidelights
- braking lights and corresponding fuse
- rear fog lights
- number plate lights.
The failure referring to these lights could be: one or more blown bulbs, a blown protection fuse
or a cut-off electric connection.
Page 100 of 307

GETTING TO KNOW YOUR CAR
98
Warning
light on dialMessage
on display
R
LEFT-HAND DIRECTION INDICATOR (INTERMITTENT)
The warning light on the dial turns on when the direction indicator control lever is moved down-
wards or, together with the right indicator, when the hazard warning light button is pressed.
E
RIGHT-HAND DIRECTION INDICATOR (INTERMITTENT)
The warning light on the dial turns on when the direction indicator control lever is moved
upwards or, together with the left indicator, when the hazard warning light button is pressed.
3
SIDELIGHTS AND DIPPED-BEAMS
The warning light on the dial turns on when the sidelights or dipped beams are turned on.
Ü
CONSTANT SPEED ADJUSTMENT (CRUISE CONTROL)
The warning light on the dial turns on (on some versions the symbol is shown on the reconfig-
urable multifunction display) with the knurled ring of the cruise control in the ON position.
1
MAIN BEAMS
The warning light on the dial turns on when the main beams are turned on or when the “Follow
me home” device is turned on (see corresponding chapter).