8-7
CHECKING THE BULBS AND BULB SOCKETSELEC
NOTE:
NOTE:
WARNING
Pocket tester
90890-03112, YU-3112
Check each bulb socket for continuity in the
same manner as described in the bulb section;
however, note the following.
a. Install a good bulb into the bulb socket.
b. Connect the pocket tester probes to the re-
spective leads of the bulb socket.
c. Check the bulb socket for continuity. If any of
the readings indicate no continuity, replace
the bulb socket.
CHECKING THE LEDs
The following procedures applies to all of the
LEDs.
1. Check:
LED (for proper operation)
Improper operation Replace.
a. Disconnect the meter assembly coupler (me-
ter assembly side).
b. Connect two jumper leads
1 from the bat-
tery terminals to the respective coupler ter-
minal.
As for connecting with which coupler terminal,
refer to “CABLE ROUTING” in chapter 2.
A wire that is used as a jumper lead must
have at least the same capacity of the bat-
tery lead, otherwise the jumper lead may
burn.
This check is likely to produce sparks,
therefore, make sure no flammable gas or
fluid is in the vicinity.
c. When the jumper leads are connected to the
terminals the respective LED should illumi-
nate.
Does not light Replace the meter assem-
bly.
ProCarManuals.com
9-3
FAULTY GEAR SHIFTING / FAULTY CLUTCH
TRBL
SHTG
JUMPS OUT OF GEAR
Shift shaft
Incorrect shift pedal position
Improperly returned stopper lever
Shift forks
Worn shift fork
Shift drum
Incorrect axial play
Worn shift drum groove
Transmission
Worn gear dog
CLUTCH DRAGS
Clutch
Unevenly tensioned clutch springs
Warped pressure plate
Bent clutch plate
Swollen friction plate
Bent clutch pull rod
Broken clutch boss
Burnt primary driven gear bushing
Match marks not aligned
Engine oil
Incorrect oil level
Incorrect oil viscosity (high)
Deteriorated oil
EAS00850
FAULTY GEAR SHIFTING
SHIFTING IS DIFFICULT
Refer to “CLUTCH DRAGS”.
SHIFT PEDAL DOES NOT MOVE
Shift shaft
Improperly adjusted shift rod
Bent shift shaft.
Shift drum and shift forks
Foreign object in a shift drum groove
Seized shift fork
Bent shift fork guide bar
Transmission
Seized transmission gear
Foreign object between transmission gears
Improperly assembled transmission
EAS00851
FAULTY CLUTCH
CLUTCH SLIPS
Clutch
Improperly assembled clutch
Improperly adjusted clutch cable
Loose or fatigued clutch spring
Worn friction plate
Worn clutch plate
Engine oil
Incorrect oil level
Incorrect oil viscosity (low)
Deteriorated oil
ProCarManuals.com
