2-2
ENGINE SPECIFICATIONSSPEC
2
ENGINE SPECIFICATIONS
ItemStandardLimit
Engine
Engine type
Displacement
Cylinder arrangement
Bore stroke
Compression ratio
Engine idling speed
Vacuum pressure at engine idling
speed
Standard compression pressure
(at sea level)
Liquid-cooled, 4-stroke, DOHC
998 cm3 (60.90 cu.in)
Forward-inclined parallel 4-cylinder
77.0 53.6 mm (3.03 2.11 in)
12.4 : 1
1,150 1,250 r / min
22 kPa (165 mmHg, 6.5 inHg)
1,480 kPa (14.80 kg / cm
2,14.80 bar,
210.5 psi) at 350 r / min
Fuel
Recommended fuel
Fuel tank capacity
Total (including reserve)
Reserve only
Premium unleaded gasoline only
18 L (3.96 Imp gal, 4.76 US gal)
3.4 L (0.75 Imp gal, 0.90 US gal)
Engine oil
Lubrication system
Recommended oil
Quantity
Total amount
Without oil filter cartridge
replacement
With oil filter cartridge replacement
Oil pressure
Engine oil temperature
Relief valve opening pressure
Wet sump
At 5C (40F) or higher
Yamalube 4 (20W40) or SAE 20W40
type SE motor oil
At 15C (60F) or lower
Yamalube 4 (10W30) or SAE 10W30
type SE motor oil
3.8 L (3.35 Imp qt, 4.02 US qt)
2.9 L (2.55 Imp qt, 3.07 US qt)
3.1 L (2.73 Imp qt, 3.28 US qt)
230 kPa at 5,000 r / min
(2.3 kg / cm
2 at 5,000 r / min)
(2.3 bar at 5,000 r / min)
(32.7 psi at 5,000 r / min)
100C (212F)
600 680 kPa (6.0 6.8 kg / cm
2,
6.0 6.8 bar, 87.0 98.6 psi)
ProCarManuals.com
8-16
YESNO
3. Starter motor
Connect the positive battery terminal and
starter motor lead with a jumper lead .
Repair or replace the
starter motor. A wire that is used as a jumper lead
must have at least the same capacity or
more as that of the battery lead, other-
wise the jumper lead may burn.
This check is likely to produce sparks,
therefore make sure nothing flammable
is in the vicinity.
Does the starter motor turn?
WARNING
1
23
EAS00758
YESNO 2. Battery
Check the condition of the battery.
Refer to “CHECKING AND CHARGING
THE BATTERY” in chapter 3.
Minimum open-circuit voltage
12.8 V or more at 20C (68F)
Is the battery OK?
Clean the battery
terminals.
Recharge or re-
place the battery.
EAS00739
ELECTRIC STARTING SYSTEMELEC
NOTE:
YESNO
1. Main and ignition fuses
Check the main and ignition fuses for conti-
nuity.
Refer to “CHECKING THE FUSES” in chap-
ter 3.
Are the main and ignition fuses OK?
Replace the fuse(s).
EAS00757
TROUBLESHOOTING
The starter motor fails to turn.
Check:
1. main and ignition fuses
2. battery
3. starter motor
4. starting circuit cut-off relay
5. starter relay
6. main switch
7. engine stop switch
8. neutral switch
9. sidestand switch
10. clutch switch
11. start switch
12. wiring connections
(of the entire starting system)
Before troubleshooting, remove the following
part(s):
1. seat
2. fuel tank
3. side cowlings
4. throttle body assembly
Troubleshoot with the following special tool(s).
Pocket tester
90890-03112, YU-3112
EAS00738
ProCarManuals.com
