2004 YAMAHA YZF-R1S coolant level

3-37
ADJUSTING THE EXUP CABLES /
CHECKING THE COOLANT LEVELCHK
ADJ
NOTE:
CAUTION:
NOTE: 7. Install:

bottom cowlings
Refer to “COWLINGS”.
EAS00102
CHECKING THE COOLANT LEVEL
1. Stand the motorcycle on a level surface.

Place the motorcycle on a suitable stand.

Make sure the motorcycle is upright.
2. Check:

coolant level
The coolant level should be between the
maximum level mark
a and minimum level
mark
b.
Below the minimum level mark
Add the
recommended coolant to the proper level.

Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.

Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
4. Check:

coolant level
Before checking the coolant level, wait a few
minutes until it settles.
ProCarManuals.com

3-41
CHANGING THE COOLANT
CHK
ADJ
CAUTION:
NOTE:
Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.

Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.

If coolant comes into contact with painted
surfaces, immediately wash them with wa-
ter.

Do not mix different types of antifreeze.
13. Install:

radiator cap
14. Fill:

coolant reservoir tank
(with the recommended coolant to the maxi-
mum level mark
a)
15. Install:

coolant reservoir cap
16. Start the engine, warm it up for several min-
utes, and then stop it.
17. Check:

coolant level
Refer to “CHECKING THE COOLANT LEV-
EL”.
Before checking the coolant level, wait a few
minutes until the coolant has settled.
18. Install:

rider seat
Refer to “SEATS”.

bottom cowlings

side cowlings
Refer to “COWLINGS”.
ProCarManuals.com

6-12
WATER PUMPCOOL
Order Job / Part Q’ty Remarks
1
2
3
4Removing the impeller shaft
Oil / water pump assembly and oil
pump rotor
Water pump cover
O-ring
Pin
Impeller shaft (along with the impeller)1
1
2
1
Remove the parts in the order listed.

The water pump and oil pump are com-
bined into one unit (oil / water pump as-
sembly).

It is not necessary to remove the impeller
shaft unless the coolant level is extreme-
ly low or coolant leaks from the oil pan.
Refer to “OIL PAN AND OIL PUMP” in
chapter 5.
12 Nm (1.2 m
kg, 8.7 ft
lb)
NOTE:
EAS00468
WATER PUMP
IMPELLER SHAFT
ProCarManuals.com

8-35
SIGNALING SYSTEMELEC
1Main switch
4Fuse (main)
6Battery
10Starting circuit cut-off relay
11Neutral switch
13Fuel pump
14E.C.U.
27Speed sensor
38Fuel level warning light
39Oil level warning light
40Neutral indicator light
41Tachometer
42Shift timing indicator light
43Multi function meter
45Coolant temperature indicator light
47Turn signal indicator light (left)
48Turn signal indicator light (light)
55Turn signal relay
58Horn switch
60Turn signal switch
61Horn
62Front turn signal / position light (left)
63Front turn signal / position light (right)
64Rear turn signal light (left)
65Rear turn signal light (right)
73Fuse (ignition)
74Fuse (signal)
ProCarManuals.com

9-4
OVERHEATING / OVERCOOLING /
POOR BRAKING PERFORMANCETRBL
SHTG
FUEL SYSTEM
Throttle body (-ies)

Damaged or loose throttle body joint
Air filter

Clogged air filter element
CHASSIS
Brake(s)

Dragging brake
ELECTRICAL SYSTEMS
Spark plug(s)

Incorrect spark plug gap

Incorrect spark plug heat range
Ignition system

Faulty E.C.U.

Loose union bolt

Damaged brake hose

Oil or grease on the brake disc

Oil or grease on the brake pad

Incorrect brake fluid level
EAS00855
OVERHEATING
ENGINE
Clogged coolant passages

Cylinder head(s) and piston(s)

Heavy carbon buildup
Engine oil

Incorrect oil level

Incorrect oil viscosity

Inferior oil quality
COOLING SYSTEM
Coolant

Low coolant level
Radiator

Damaged or leaking radiator

Faulty radiator cap

Bent or damaged radiator fin
Water pump

Damaged or faulty water pump

Thermostat

Thermostat stays closed

Oil cooler

Clogged or damaged oil cooler

Hose(s) and pipe(s)

Damaged hose

Improperly connected hose

Damaged pipe

Improperly connected pipe
EAS00856
OVERCOOLING
COOLING SYSTEM
Thermostat

Thermostat stays open
EAS00857
POOR BRAKING PERFORMANCE

Worn brake pad

Worn brake disc

Air in hydraulic brake system

Leaking brake fluid

Faulty brake caliper kit

Faulty brake caliper seal
ProCarManuals.com

59Clutch switch
60Turn signal switch
61Horn
62Front turn signal / position light (left)
63Front turn signal / position light (right)
64Rear turn signal light (left)
65Rear turn signal light (right)
66Headlight
67Auxiliary light
68License plate light
69Rear brake light switch
70Tail / brake light
71Headlight relay (on / off)
72Headlight relay (dimmer)
73Fuse (ignition)
74Fuse (signal)
75Fuse (headlight)
76Radiator fan motor relay
77Fuse (radiator fan motor left)
78Fuse (radiator fan motor light)
79Radiator fan motor 2
80Radiator fan motor 1
81Ground
COLOR CODE
B Black. . . . .
Br Brown. . . .
Ch Chocolate. . .
Dg Dark green. . .
G Green. . . .
Gy Gray. . .
L Blue. . . . .
Lg Light green. . . .
O Orange. . . .
P Pink. . . . .
R Red. . . . .
Sb Sky blue. . . .
W White. . . .
Y Yellow. . . . .
B / G Black / Green. .
B / L Black / Blue. . .
B / R Black / Red. .
B / W Black / White. .
B / Y Black / Yellow. .
Br / G Brown / Green.
Br / L Brown / Blue. .
Br / R Brown / Red. .
Br / W Brown / White.
G / B Green / Black. .
G / R Green / Red. .
G / W Green / White. . G / Y Green / Yellow. .
Gy / B Gray / Black.
Gy / G Gray / Green.
Gy / R Gray / Red.
L / B Blue / Black. . .
L / R Blue / Red. .
L / W Blue / White. .
L / Y Blue / Yellow. . .
O / B Orange / Black. .
O / G Orange / Green. .
P / W Pink / White. .
R / B Red / Black. .
R / G Red / Green. .
R / L Red / Blue. .
R / W Red / White. .
R / Y Red / Yellow. .
Sb / W Sky blue / White.
W / B White / Black. .
W / R White / Red. .
W / Y White / Yellow. .
Y / B Yellow / Black. .
Y / G Yellow / Green. .
Y / L Yellow / Blue. . .
Y / R Yellow / Red. .
Y / W Yellow / White. .
YZF-R1S / YZF-R1SC WIRING DIAGRAM
1Main switch
2A.C. magneto
3Rectifier / regulator
4Fuse (main)
5Fuse (backup)
6Battery
7Fuse (fuel injection)
8Starter relay
9Starter motor
10Starting circuit cut-off relay
11Neutral switch
12Sidestand switch
13Fuel pump
14E.C.U
15Ignition coil #1
16Ignition coil #2
17Ignition coil #3
18Ignition coil #4
19Spark plug
20Injector #1
21Injector #2
22Injector #3
23Injector #4
24Air induction system solenoid
25Sub-throttle position sensor
26EXUP servo motor
27Speed sensor
28Coolant temperature sensor
29Intake air temperature sensor
30Option switch
31Crankshaft position sensor
32Throttle position sensor
33Intake air pressure sensor
34Atmospheric pressure sensor
35Cylinder identification sensor
36Lean angle cut-off switch
37Meter assembly
38Fuel level warning light
39Oil level warning light
40Neutral indicator light
41Tacho meter
42Shift timing indicator light
43Multi function meter
44Engine trouble warning light
45Coolant temperature indicator light
46Hi beam indicator light
47Turn signal indicator light (left)
48Turn signal indicator light (light)
49Meter light
50Oil level switch
51Right handlebar switch
52Front brake light switch
53Engine stop switch
54Start switch
55Turn signal relay
56Left handlebar switch
57Dimmer switch
58Horn switch
ProCarManuals.com