2004 YAMAHA T105 tow

EAB80001
Shift pedal
This motorcycle is equipped with a con-
stant-mesh 4-speed transmission. The shift
pedal is located on the left side of the en-
gine.
EAB90001
Front brake lever
The front brake lever is located on the right
handlebar. Pull it toward the handlebar to
apply the front brake.
16
1Shift pedal N. Neutral
1Front brake lever
5AV-F8199-E1-1 7/29/03 3:32 PM Page 16

4. Once the motorcycle has reached a
high enough speed to change gears,
close the throttle.
5. Shift into SECOND gear.
6. Open the throttle gradually.
7. Follow the same procedure when
shifting to the next higher gear.
8. The speed can be adjusted by opening
and closing the throttle grip. Turning it
toward you increases the speed, and
turning it in the opposite direction de-
creases the speed.
Recommend shift point
32
Gear position Recommend speed
1 st 0~20 km/h
2 nd 20~40 km/h
3 rd 30 km/h~
4 th (Top) 40 km/h~
5AV-F8199-E1-2 8/1/03 1:47 PM Page 32

EAH48201*
Engine oil
1. Oil level measurement
a. Place the motorcycle on the center-
stand. Warm up the engine for several
minutes.
EUU03901
NOTE:
Be sure the motorcycle is positioned
straight up when checking the oil level. A
slight tilt toward the side can result in false
readings.
b. With the engine stopped, wait a few
minutes and then remove the oil level
gauge.
c. Wipe the oil level gauge off with a
clean rag and insert it in the filler hole
without screwing it in.
41
1Oil level gauge2Upper level3Lower level
5AV-F8199-E1-2 8/1/03 1:47 PM Page 41

EAK00000
CLEANING AND
STORAGE
EAK01302*
A. CLEANING
Frequent, thorough cleaning of your mo-
torcycle will not only enhance its appear-
ance but will improve its general perfor-
mance and extend the useful life of many
components.
1. Rinse the dirt and degreaser off with a
garden hose.
EUU34602
cC
Excessive hose pressure may cause water
seepage and deterioration of wheel bear-
ings, front fork, brakes, transmission seals
and electrical parts.
2. After cleaning the motorcycle, dry all
surfaces with a chamois, clean towel,
or soft absorbent cloth.3. Dry the chain and lubricate it to pre-
vent rust.
4. Automotive-type wax may be applied
to all painted and chrome-plated sur-
faces. When finished, start the engine
and let it idle for several minutes.
EAK00700
B. STORAGE
Long term storage (60 days or more) of
your motorcycle will require some preven-
tive procedures to guard against deteriora-
tion. After thoroughly cleaning the motor-
cycle, prepare for storage as follows:
1. Drain the fuel tank, fuel lines, and car-
buretor float bowl(s).
2. Remove the empty fuel tank, pour a
cup of SAE 10W30 or 20W40 motor oil
in the tank, shake the tank to coat the
inner surfaces thoroughly and drain
off the excess oil. Reinstall the tank.
67
5AV-F8199-E1-3 8/1/03 1:48 PM Page 67