2004 YAMAHA BREEZE engine

[x] Cancel search: engine

Page 253 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-31
EBU00959
Engine and V-belt case air filter element
cleaning
Both air filter elements should be cleaned at the
specified intervals in the periodic maintenance
chart.
Engine air filter element
NOTE

Page 255 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-33
4. Remove the air filter element, and separate
it from the frame.
5. Wash the air filter element gently but thor-
oughly in solvent.
w
Always use parts cleaning solvent to clean
the air filter el

Page 259 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-37
NOTE:
The air filter element should be cleaned every
20–40 hours. It should be cleaned and lubricat-
ed more often if the machine is operated in
extremely dusty areas. Each time air filter ele-

Page 263 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-41
EBU13020
Idle speed adjustment
NOTE:
A diagnostic tachometer must be used for this
procedure.
1. Start the engine and warm it up for a few
minutes at approximately 1,000 to 2,000
r/min. Occasiona

Page 265 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-43
EBU00303
Valve clearance adjustment
The correct valve clearance changes with use,
resulting in improper fuel/air supply or engine
noise. To prevent this, the valve clearance must
be adjusted regu

Page 281 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-59
EBU01146
Drive chain slack adjustment
1. Loosen the hub stopper bolt locknut and
then the hub stopper bolt.
2. Loosen the upper and lower axle holding
bolts.
3. Loosen the locknut. To tighten the

Page 287 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-65
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive chain with a
special O-ring chain lubricant.
cC
Do not use engine oil or any other lubricants
for the drive chain, as they may conta

Page 289 of 350

YAMAHA BREEZE 2004  Notices Demploi (in French) 8-67
EBU00570
Cable inspection and lubrication
w
Inspect cables frequently and replace if dam-
aged. Corrosion can result when the outer
covering of control cables becomes dam-
aged. Cables can also b
Page:   < prev 1-10 ... 9-16 17-24 25-32 33-40 41-48 49-56 next >