2004 TOYOTA PRIUS belt

[x] Cancel search: belt

Page 252 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 252
2. Put the flat tire on the center ofthe luggage storage box lid with
the outer side of the wheel facing
up. Hook one ends of the belts to
the front tie −down hooks.3. Pass the belts through the

Page 253 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 253
CAUTION
Make sure the rear seats are in
their original position.
 When carrying the flat tire, se-
cure it using a tire tie�down
belts. Otherwise, the flat tire
may fly out in case of the sud-
d

Page 264 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 264
Do not apply water—the best results are
obtained by keeping the carpet as dry as
possible. Read the shampoo instructions
and follow them closely.
Seat belts
The seat belts may be cleaned with
mi

Page 270 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 270
INSIDE THE VEHICLE
Items listed below should be checked
regularly, e.g. while performing periodic
services, cleaning the vehicle, etc.
Lights
Make sure the headlights, stop lights, tail
lights, tu

Page 276 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 276
If you perform maintenance by yourself,
be sure to follow the correct procedure
given in this Section.
You should be aware that improper or in-
complete servicing may result in operating
problems.

Page 293 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 293
CAUTION
Observe the following instruc-
tions. Otherwise, an accident
may occur resulting in death or
serious injuries.
Do not mix radial, bias belted,
or bias�ply tires on your ve-
hicle, as this

Page 321 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 321
Occupant restraint sys-tems
Toyota encourages you and your
family to take the time to read
Section 2−2 of this  Owner’s Manu-
al carefully. In terms of helping
you understand how you can re-
c

Page 326 of 333

TOYOTA PRIUS 2004 2.G Owners Manual 326
Spark ignition system ofyour Toyota
The spark ignition system in your
Toyota meets all requirements of
the Canadian Interference −Causing
Equipment Standard.
Installation of a mobile two�way rad