2004 TOYOTA PRIUS maintenance

293
CAUTION
Observe the following instruc-
tions. Otherwise, an accident
may occur resulting in death or
serious injuries.
Do not mix radial, bias belted,
or biasply tires on your ve-
hicle, as this may cause dan-
gerous handling characteris-
tics resulting in loss of control.
 Do not use tires other than the
manufacturer’s recommended
size, as this may cause danger-
ous handling characteristics
resulting in loss of control.
Toyota recommends all four tires,
or at least both front or rear tires
be replaced at a time as a set.
See “If you have a flat tire” on page
243 for tire change procedure. When a tire is replaced, the wheel
should always be balanced.
An unbalanced wheel may affect ve-
hicle handling and tire life. Wheels
can get out of balance with regular
use and should therefore be balanced
occasionally.
When replacing a tubeless tire, the
air valve should also be repl
aced
w i t h a new on e.
82p104a
To equalize tire wear and help ex-
tend tire life, Toyota recommends
that you rotate your tires accord-
ing to the maintenance schedule.
(For scheduled maintenance infor-
mation, please refer to the “Sched-
uled Maintenance Guide” or “Own-
er’s Manual Supplement”.)
However, the most appropriate tim-
ing for tire rotation may vary ac-
cording to your driving habits and
road surface conditions.
The wheel assemblies must be ro-
tated as illustrated above.
Rotating tires

297
DOITYOURSELF MAINTENANCE
Electrical components
Checking auxiliary battery condition 298
. . . . . . . . . . . . . . . . . . . . . . . . . .
Auxiliary battery recharging precautionss 300
. . . . . . . . . . . . . . . . . . . . .
Checking and replacing fuses 300
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adding washer fluid 302
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . .
Replacing light bulbs 302
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . .
SECTION 8– 3

299
83p001c
Terminals
Ground
cableHold−down clamp
Check the battery for corroded or loose
terminal connections, cracks, or loose
holddown clamp.
a. If the battery is corroded, wash it off with a solution of warm water and bak-
ing soda. Coat the outside of the termi-
nals with grease to prevent further cor-
rosion.
b. If the terminal connections are loose, tighten their clamp nuts—but do not
overtighten.
c. Tighten the hold− down clamp only
enough to keep the battery firmly in
place. Overtightening may damage the
battery case.
NOTICE
 Be sure the hybrid system and all
accessories are off before perform-
ing maintenance.
 When checking the battery, remove
the ground cable from the negative
terminal (“–” mark) first and rein-
stall it last.
 Be careful not to cause a short cir-
cuit with tools.
 Take care no solution gets into the
battery when washing it.
If the auxiliary battery is disc onnected
or run down, the power window and back
door may not operate automatically and
the jam protection function will not func-
tion correctly and does not open the back
door after you reconnect, replace or re-
charge the battery. In any of these cases,
you should normalize each system. To
normalize them, see “Power windows” on
page 40 and “Back door” on page 39.
Before you disconnect the auxiliary bat-
tery, confirm the shift position is “P” and
apply the parking brake completely. After you reconnect the auxiliary battery,
shift the shift lever to “N” and confirm the
shift position is “N” when the “IG
−ON”
mode is enabled.
After connecting the cables, the hybrid
system may not start by pushing the
“POWER” switch. In that case, push it
once again.

323
In order to be effective, the SRS
airbags must deploy with tremen-
dous speed. The rapid deployment
of the SRS airbags makes the
SRS airbags themselves potential
sources of serious injury if an oc-
cupant is too close to an airbag,
or if an object or some part of his
or her body has been placed be-
tween the occupant and the airbag
at the time of deployment. This is
just one example of how the in-
structions in Section 2−2 of this
Owner ’s Manual will help ensure
proper use of the occupant re-
straint systems, and increase the
safety they can provide to you
and your family in the event of an
accident.
Toyota recommends you to read
the provisions in Section 2− 2 care-
fully and refer to them as needed
during your time of ownership of
this vehicle.New vehicle warranty
Your new vehicle is covered by
the following Toyota limited war-
ranties:
 New vehicle warranty
 Emission control systems war-
ranty
 Others
For further information, please re-
fer to the “Owner ’s Warranty Infor-
mation Booklet” or “Owner ’s Manu-
al Supplement”.
Your responsibility for maintenance
It is the owner’s responsibility to
make sure the specified mainte-
nance is performed. Section 7
gives details of these maintenance
requirements. Also included in
Section 7 is general maintenance.
For scheduled maintenance infor-
mation, please refer to the
“Scheduled Maintenance Guide” or
“Owner ’s Manual Supplement”.

2
Publication No. OM47482U
Part No. 01999-47482
Printed in Japan 04−0407 −01
U 5Quick index
 If a service reminder indicator or warning buzzer comes on 117 . . .
 If your vehicle will not start 238 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
 If your vehicle overheats 242 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
.
 If you have a flat tire 243 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . .
 If your vehicle needs to be towed 254 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
 Tips for driving during break-in period 202 . . . . . . . . . . . . . . . . . . . . . . . . . .
 How to start the hybrid system 230 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
 General maintenance 269 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . .
Gas station information
Fuel type:
UNLEADED gasoline, Octane Rating 87 (Research Octane Number 91)
or higher.
See page 202 for detailed information.
Fuel tank capacity:
45 L (11.9 gal., 9.9 lmp. gal.)
See page 204 for detailed information.
Engine oil:
API grade SL “Energy −Conserving” or ILSAC multigrade engine oil
is recommended.
See page 283 for detailed information.
Tire information: See pages 289 through 296.
Tire inflation pressure: See page 313.
C