2004 TOYOTA LAND CRUISER Lock

87
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
13c564
(A) INFANT SEAT INSTALLATION
An infant seat must be used in rear
facing position only.
13c565
CAUTION
Never install a rearfacing child
restraint system on the front
passenger seat. In the event of
an accidents, the force of the
rapid inflation of the front pas-
senger airbag can cause death
or serious injury to the child if
the rearfacing child restraint
system is installed on the front
passenger seat.
Do not install a child restraint
system on the third seat if it in-
terferes with the lock mechanism
of the second seats. Otherwise,
the child or second seat occu-
pant(s) may be killed or serious-
ly injured in case of sudden
braking or a collision.
If the driver’s seat position does
not allow sufficient space for
safe installation, install the child
restraint system on the second
right seat.
—Installation with 3point
type seat belt

88
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
1. Run the lap and shoulder belt throughor around the infant seat following the
instructions provided by its manufactur-
er and insert the tab into the buckle
taking care not to twist the belt. Keep
the lap portion of the belt tight.
CAUTION
After inserting the tab, make
sure the tab and buckle are
locked and that the lap and
shoulder portions of the belt are
not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent
your child from properly latching
the tab and buckle.
If the seat belt does not function
normally, it cannot protect your
child from death or serious
injury. Contact your Toyota
dealer immediately. Do not install
the child restraint seat on the
seat until the seat belt is fixed.2. Fully extend the shoulder belt to put itin the lock mode. When the belt is
then retracted even slightly, it cannot
be extended.
To hold the infant seat securely, make
sure the belt is in the lock mode before
letting the belt retract.

91
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
On vehicle with side airbags and
curtain shield airbags, do not al-
low the child to lean his/her
head or any part of his/her body
against the door or the area of
the seat, front or rear pillar,
front, center or rear garnish or
roof interior from which the side
airbags or curtain shield airbags
deploy even if the child is
seated in the child restraint sys-
tem. It is dangerous if the side
airbag and curtain shield airbag
inflate, and the impact could
cause death or serious injury to
the child.
13c501b
Do not install a child restraint
system on the third seat if it in-
terferes with the lock mechanism
of the second seats. Otherwise,
the child or second seat occu-
pant(s) may be killed or serious
injured in case of sudden brak-
ing or a collision.
If the driver’s seat position does
not allow sufficient space for
safe installation, install the child
restraint system on the second
right seat.
1. Run the lap and shoulder belt throughor around the convertible seat following
the instructions provided by its
manufacturer and insert the tab into
the buckle taking care not to twist the
belt. Keep the lap portion of the belt
tight.

92
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
CAUTION
After inserting the tab, make
sure the tab and buckle are
locked and that the lap and
shoulder portions of the belt are
not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent
your child from properly latching
the tab and buckle.
If the seat belt does not function
normally, it cannot protect your
child from death or serious
injury. Contact your Toyota
dealer immediately. Do not install
the child restraint seat on the
seat until the seat belt is fixed.2. Fully extend the shoulder belt to put itin the lock mode. When the belt is
then retracted even slightly, it cannot
be extended.
To hold the convertible seat securely,
make sure the belt is in the lock mode
before letting the belt retract.3. While pressing the convertible seat firmly against the seat cushion and
seatback, let the shoulder belt retract
as far as it will go to hold the convert-
ible seat securely.

95
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
CAUTION
Always make sure the shoulder
belt is positioned across the
center of child’s shoulder. The
belt should be kept away from
child’s neck, but not falling off
child’s shoulder. Otherwise, the
child may be killed or seriously
injured in case of sudden brak-
ing or a collision.
Both highpositioned lap belts
and loosefitting belts could
cause death or serious injuries
due to sliding under the lap belt
during a collision or other unin-
tended event. Keep the lap belt
positioned as low on child’s hips
as possible.
For child’s safety, do not place
the shoulder belt under child’s
arm.
After inserting the tab, make
sure the tab and buckle are
locked and that the lap and
shoulder portions of the belt are
not twisted.
Do not insert coins, clips, etc. in
the buckle as this may prevent
your child from properly latching
the tab and buckle.
If the seat belt does not function
normally, it cannot protect your
child from death or serious
injury. Contact your Toyota
dealer immediately. Do not install
the child restraint seat on the
seat until the seat belt is fixed.

99
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
Ty p e A —2. Latch the hooks of lower straps onto the anchorages and tighten the lower
straps.
Ty p e B —
2. Latch the buckles onto the anchor- ages
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see “—Using
a top strap” on page 96.)
For the installation details, refer to the
instruction manual equipped with each
product.CAUTION
When using the lower anchorages
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages or that
the seat belt is not caught.
Push and pull the child restraint
system in different directions to be
sure it is secure. Follow all the
installation instructions provided by
its manufacturer.
Do not install a child restraint sys-
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. Otherwise, the child or
front seat occupant(s) may be killed
or seriously injured in case of sud-
den braking or a collision.

108
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
13C011
CALIBRATING THE COMPASS (circling
calibration)
“C” appears on the display in case the
circling calibration is required due to a
drastic change in the magnetic field. To
rectify this, follow the calibration proce-
dure below.
13C012
Drive the vehicle slowly (at 8km/h (5mph)
or lower) in a circle until the direction is
displayed. If there is not enough space to
drive in a circle, drive around the block
until the direction is displayed.
After driving in 1 to 3 circles in the above
method, calibration is complete with the
direction shown on the display.
If calibration cannot be performed because
of the magnetized vehicle, etc., take your
vehicle to Toyota dealer.
Do not perform circling calibration of
the compass in a place where the
earth’s magnetic field is subject to in-
terference by artificial magnetic fields
(underground parking, under a steel
tower, between buildings, roof parking,
near a crossing, near a large vehicle,
etc.).
During calibration, do not operate elec-
tric systems (moon roof, power win-
dows, etc.) as they may interfere with
the calibration.
CAUTION
When doing the circling calibra-
tion, be sure to secure a wide
space, and watch out for people
and vehicles in the neighbor-
hood. Do not violate any local
traffic rules while performing cir-
cling calibration.
Do not adjust the display while
the vehicle is moving. Be sure to
adjust the display only when the
vehicle is stopped.

109
2004 L/C100 from Aug ’03 Prod. (OM60A04U)
Sun visors—
To block out glare, move the sun visor.
To block out glare from the front—Swing
down the main sun visor.
To block out glare from the side—Swing
down the main sun visor, remove it from
the hook and swing it to the lateral side.
You can adjust its position as shown.To block the glare from the front when the
main sun visor is swung down, swing
down the second sun visor.
CAUTION
Slide the main sun visor only when
it is swung down to the lateral side.
It can cover the antiglare inside rear
view mirror and obstruct the rear
view.
—Vanity mirror
To use the vanity mirror, swing down
the main sun visor and open the cover.
The vanity light comes on when you open
the cover.