2004 SKODA OCTAVIA TOUR brake

5
CONTROLS AND EQUIPMENT
Page
1 Exterior mirrors adjustable from inside* 172 Air vents73, 76, 833Lever for the multi-functional switch:
67, 68
Turn signal lights, main beam, parking light,
low beam, headlight flasher and cruise control*
4 Instrument cluster:
48, 56
Instruments and warning lights
5 Lever for windscreen wiper/ washer
50, 71with switch for multifunction display
6 Switch for heated rear window 637 Switch for ESP/TCS*638 Switch for hazard warning light system 639 Thumbwheel for seat heater*65
10 Remote fuel filler flap release from driver’s
65
seat*
11 Passenger airbag 10312 Storage compartment in the front doors -
13 Button for central locking and electrical
8, 15
power windows
14 Remote bonnet release 135
15 Switch for parking light, low beam, rear fog 62
light
and instrument lighting
66
Page
16
Storage compartment below the steering wheel
-
17 Horn, driver airbag* 10318 Lever for adjusting height of steering column19 Ignition lock 4320 Ashtrays90
21 Gearshift lever (manual gearbox), or
38, 39
Selector lever (automatic gearbox)
22 Handbrake 3623 Control for heating and air conditioning* 72, 75, 7924 Storage compartment -25 Radio
1)
-
26 Storage compartment on the front
87
passenger side

The arrangement of the controls and the styling of the dash
panel depend on the model version.

Equipment marked with * is fitted as standard only to certain
model versions or is available only for certain models as optional
equipment.

On right-hand drive vehicles the arrangement of the controls
and switches and the location of some items may vary. The sym-
bols on the controls and switches are the same as for left-hand
drive vehicles.
1)Cars with factory-fitted radio are supplied with a radio instruction lea\
flet.
43

10CONTROLS AND EQUIPMENTNote
If the car is locked and the Safe lock is
deactivated, it is possible to open the doors
from the inside as follows:

The door is unlocked by pulling the door
opening handle.

The door is opened by once again pul-
ling the handle.Convenience systemWhen unlocking and locking the car, it is
also possible to open and close the power
windows (only to close the sliding/tilting
roof) as follows:

Hold the key in the unlocking or locking
position until all the windows are opened
or closed. The opening or closing operati-
on is stopped immediately once the key is
released.
The rollback protection is not active if
the convenience system is used. Refer
to p. 16 for further information.
Warning

If the vehicle is locked from the
outside, make sure no persons or
animals are left behind. As locked
doors make outside emergency as-
sistance difficult, never leave chil-
dren or animals unattended in the
car.

Locking the doors will prevent their
opening unintentionally in excep-
tional circumstances (accident).
Locked doors also prevent unauthor-
ized access e.g. while waiting at traf-
fic lights. However, they do make it
more difficult for emergency workers
to provide assistance inside the car.

Check the locking process visu-
ally to ensure the locking knobs are
down.

The car is unlocked automatically
if the airbag system is activated.
Storage compartmentsAn overview
You will find the following storage facilities
in your vehicle:

Storage compartment on the front pas-
senger side - see page 87

Storage compartment below the steer-
ing wheel - see page 4

Storage compartment in the middle of
the dash panel - see page 4

Storage compartment in the door panel
- see page 4
Warning


Please do not place anything on top
of the dash panel. Such objects might
slide or fall down when driving (when
accelerating or cornering) and may
distract you from concentrating on the
traffic situation - risk of accident!

Use the storage compartments in
the door panels only for small items,
which do not project out of the com-
partment in order to avoid any inter-
ference with the proper operation of
the side airbags.

Ensure that when driving no ob-
jects from the centre console of from
other storage possibilities may get
into the footwell of the driver.
You would then no longer be able to
apply the brakes, operate the clutch
or accelerator - risk of accident!

26CONTROLS AND EQUIPMENTFolding rear seat back
First of all, insert head restraints into the
backrest.

Then, fold back rear seat backrest until
it locks in position - pull as a check. Fold
back seat into its original position.
Note
After folding back the seat cushion and the
rear seat backrests, the seat belt buckles
and the lap belt should be in their original
position - they should be ready for use.
Warning
The backrests of the rear seat should
be properly locked to ensure that no
objects can slip forward out of the
luggage compartment into the inte-
rior of the car during a sudden appli-
cation of the brakes.
Luggage compartment coverWarning
No objects should be carried on the
luggage compartment cover. These
may result in injuries to occupants
in the event of a sudden application
of the brakes or an accident.
In addition, the heater elements of the rear
window may be damaged by objects rub-
bing against them.
The luggage compartment cover is auto-
matically raised when opening the tailgate.
The cover can be removed in order to trans-
port bulky items:

Unhook retaining cords from the tailgate.

Pull the cover back out of the side re-
tainers (see arrows).
The cover can then be stowed behind the
rear seat backrests.

When installing, slide the cover forward
into the side retainers and hook the retain-
ing cords onto tailgate.

32CONTROLS AND EQUIPMENTLuggage compartment cover
(Estate)
Pull the luggage compartment cover in
the direction of the arrow into the recesses
on the sides of the luggage compartment.

The cover can be removed for transpor-
ting bulky items. Press on the side of the
transverse bars in direction of arrow 1. Take
out the cover in the direction of arrow 2.
Warning
No objects should be carried on the
luggage compartment cover. The
occupants of the car are at risk in the
event of a sudden application of the
brakes or an accident.
In addition, the heating elements of the rear
window could be damaged by objects rub-
bing against them.
Raised luggage area*
(Estate)The raised luggage area makes it easier
to put in and remove large items. This can
be removed by adopting the following pro-
cedure:

Release the luggage area by turning the
locking pins A about 90° to the left.

Raise the luggage area in direction of
arrow and take out.

Release the supporting bars B by turn-
ing the plug-in rings C about 90° to the right
and take out.

35
CONTROLS AND EQUIPMENT
Removing complete net partitionRemove the head restraints and fold the
rear seats forward.
Open the rear right door.
Then, push housing B in the direction of
arrow 1 as far as the stop and take it out of
the mounts of the rear seat backrests in the
direction of arrow 2.
Installing complete net partitionPosition housing into the mounts of the rear
seat backrest.
Then, push the housing in the opposite di-
rection of arrow 1 as far as the stop.
Fold rear seats back.
PedalsProper operation of the pedals must not be
obstructed by any objects!
For this reason, do not put articles in the
footwell which could roll or slide underneath
the pedals.
There should not be any foot mats or other
additional floor coverings around the pedal
area.

Greater pedal travel may be necessary
if there is a fault in the brake system.

It should always be possible to depress
the clutch and accelerator pedals fully.

All the pedals must be able to return,
unhindered, to their rest positions.
For these reasons, only fit foot mats which
leave the pedal area completely free and
which have a non-slip surface.

36CONTROLS AND EQUIPMENT
HandbrakePull the lever up firmly in order to apply the
handbrake. In addition, on a steep hill, also
engage 1st gear (or position P on cars with
an automatic gearbox). The handbrake le-
ver should therefore always be applied
firmly to avoid driving off inadvertently with-
out releasing the handbrake. The hand-
brake warning light comes on when the
handbrake is applied and the ignition is
switched on, see also page 61.
To release handbrake, pull lever up slightly,
press locking knob in and push lever fully
down.
Armrest*Front armrestTo fold down the armrest, press the button
A on the front end of the armrest. Fold down
armrest and release button again.
The movement of your arm may be re-
stricted if the armrest is folded down. It is
therefore recommended not to drive in
towns with the armrest folded down.
A stowage compartment is provided in the
armrest. Press button B to open the stow-
age compartment and raise lid.
Rear armrest*The armrest at the rear can be folded down
by pulling on the strap in the direction of
the arrow.

39
CONTROLS AND EQUIPMENT
Automatic gearbox*Selector lever positionsThe selector lever position engaged (re-
fer to illustration) is indicated in the dis-
play panel*.
P - Park lock
The driven wheels are mechanically blocked.Warning
The Park lock must not be engaged
unless the vehicle is stationary other-
wise the Park lock might be damaged.
Before moving the selector lever into or out
of position „P“, the lock button in the se-
lector lever handle has to be pressed. In
addition, the brake pedal has to be de-
pressed first of all before moving out of this
position with the ignition switched on. R - Reverse gear
Reverse gear must only be engaged if the
vehicle is stationary and the engine is idling.
Before moving selector lever into position
„R“
from positions „P“ or „N“ , the brake pedal
has to be depressed and the lock button in
the selector lever handle pressed in.
When the selector lever is moved into po-
sition „R“ and the ignition is on, the revers-
ing lights come on.
N - Neutral
To move the selector lever out of „N“ at a
speed of less than 5 km/h (3 mph) and also
when vehicle is stationary and the ignition
on, depress brake pedal and press in lock
button in selector lever handle (if the se-
lector lever remains in this position for more
than 2 seconds). D - Continuous position for driving for-
ward
In this position, the four forward gears are
shifted up and down automatically in line
with engine load, the speed of the car and
your style of driving.
To shift out of position „D“ into „3“, the lock
button in the selector lever handle must first
of all be pressed in.
3 - Position for hilly sections
This selector lever position is recommen-
ded if holding the position „D“ would re-
sult in frequent gear changes in certain driv-
ing conditions.
1st, 2nd and 3rd gears are automatically
shifted up and down in line with engine load,
the speed of the car and your style of dri-
ving. 4th gear cannot be engaged. This
ensures increased engine braking power
when the accelerator is released.
The shiftlock button must not be pressed
in the grip of the selector lever in order to
shift from position „3“ into „2“.

40CONTROLS AND EQUIPMENT2 - Position for mountainous sections
This selector lever position is suitable for
long mountainous stretches.
1st and 2nd gears are automatically shif-
ted up and down in line with engine load,
the speed of the car and your style of dri-
ving. 3rd and 4th gears cannot be enga-
ged in order to avoid the gearbox shifting
up unnecessarily. This increases the engi-
ne braking power.
To shift out of position „2“ into „1“, the lock
button in the selector lever handle has to
be pressed in. 1-
Position for steep mountainous stret-
ches
This selector lever position is recommen-
ded for extreme downhill stretches.
The car runs only in 1st gear. 2nd, 3rd and
4th cannot be engaged. This ensures that
the maximum possible engine braking
power is available.
Note
When shifting down manually, it is possi-
ble to engage selector lever positions
„3“,
„2“ and „1“, although the automatic gear-
box does not shift down until there is no
longer any risk of the engine overrevving.
Selector lever lockThe selector lever is locked in the positions
„P“ and „N“ when the ignition is switched
on. The warning light on the cover panel
next to the selector lever comes on and
remains on until the brake pedal is de-
pressed. The brake pedal has first of all to
be depressed and at the same time the lock
button in the selector lever handle pressed
in to shift the selector lever out of these
positions. This is intended to ensure that it
is not possible to inadvertently engage a
gear and for the car to move off unexpect-
edly.
A time delay element ensures that the se-
lector lever is not blocked if it is shifted rap-
idly through position „N“ (e.g. from „R“ to
„D“ ). This makes it possible, for example,
to „rock“ the car free if it is stuck in mud or
snow. The selector lever lock does not en-
gage unless the lever is held for more than
2 seconds in position „N“ without the brake
pedal being depressed.
The selector lever lock is switched off au-
tomatically in the position „N“ and speeds
of more than 5 km/h.