2004 PORSCHE CAYENNE high beam

150
Multi-Purpose Display and Instruments
Immobilizer active Have the fault remedied at an authorized Porsche dealer.Check left static cornering
lightCheck bulb.Check right static cornering
lightCheck bulb.Check dynamic cornering light Have the fault remedied at an authorized Porsche dealer.
If the warning message appears, the high beam indicator light on the speedometer flashes additionally.Check dipped beam Check bulb.Check trailer lights Check bulb.Check direction indicators Check bulb.Check high beam Check bulb.Check licence plate light Check bulb.Check fog lights Check bulb.Check reversing lights Check bulb.Check front side lights Check bulb.Check headlight beam adjustment Have the fault remedied at an authorized Porsche dealer.Daytime driving lights off Daytime driving lights switch off when the ignition is switched-off.
Switch on lights by light switch if necessary.System fault headlamp Have the fault remedied at an authorized Porsche dealer.
Light on
instrument
panel
Warning message on the multi-purpose
displayMeaning/measures
10_Cayenne_21_KW17.book Seite 150 Donnerstag, 9. April 2009 3:33 15

Minor Repairs
315
Fuse assignment – fuse box in left side of dashboardNo. Designation Rating in A No. Designation Rating in A1
Cockpit socket at front centre, centre console sockets
at rear right and rear left
20
24
Tire Pressure Monitoring
5
2 Parking heater radio receiver 5 26Engine control unit (engine management, radiator fans,
airbag, clutch switch, instrument panel)10
3
Socket in passenger footwell
20
30
Off-road roof-mounted headlights
15
4 Parking heater 20 31
Off-road roof-mounted headlights15
5
Sockets in luggage compartment
20
33
Steering column module
15
7 Diagnostic socket, rain sensor 5 34 Passenger compartment monitoring 5
8
Wiper motor for windshield
30
35
Vehicle electrical system control unit (right fog light,
right additional high beam, interior light)
30
9Vehicle electrical system control unit
(pump for washer fluid)15 36 Control unit for power seat controls, left 30
10
Power window and central locking, rear left door
30
39
Heated rear window relay (control)
5
14 Power window and central locking, front left door 30 40 Instrument panel, diagnosis 5
15
Tail light, right
15
41
Kessy control unit (steering column lock, ignition lock,
Porsche Entry & Drive, clutch switch)
15
16 Vehicle electrical system control unit (horn) 20 42Sliding/lifting roof or Panorama roof system 30
17
Vehicle electrical system control unit (left turn signal
light, right side marker light, left low beam)
30
43
Subwoofer
30
18 Headlight washer system 25 44
Electrical seat adjustment, left30
19
Vehicle electrical system control unit (interior light)
5
45
Seat heating, rear
25
20Vehicle electrical system control unit (instrument
lighting, fog light left, left additional high beam)30 47 Rear differential lock 10
22
Rear differential lock, automatic rear lid
30
49
Servotronic
5
23 Differential lock 10 51 Air-quality sensor, diagnostic socket, parking brake 5
10_Cayenne_21_KW17.book Seite 315 Donnerstag, 9. April 2009 3:33 15

Minor Repairs
329
Changing bulbs on Halogen headlightsChanging bulb for low beam/high beam
1. Remove headlight.
For information on removing headlights:
Please see the chapter “REMOVING HEAD-
LIGHTS” on Page 327.
2. Press down both release tabs A and remove
cover.3. Turn bulb socket B counter-clockwise and
remove. 4. Remove defective bulb and replace.
5. Insert bulb socket and turn in clockwise direc-
tion.
Make sure that the bulb is installed in the
correct position.
6. Fit cover on headlight.
Both release tabs must be fully engaged.
7. Install headlight.
For information on installing headlights:
Please see the chapter “INSTALLING HEAD-
LIGHTS” on Page 328.
8. Check operation of bulbs.
10_Cayenne_21_KW17.book Seite 329 Donnerstag, 9. April 2009 3:33 15

330
Minor Repairs Changing bulb for additional high beam
fA Bi-Xenon headlight is used to demonstrate
the procedure for changing the bulb for the
additional high beam.
Please see the chapter “CHANGING BULB FOR
ADDITIONAL HIGH BEAM” on Page 331.
Changing bulbs on Bi-Xenon headlights
with cornering lightChanging gas discharge lamp for low beam/
high beam/dynamic cornering light
1. Remove headlight.
For information on removing headlights:
Please see the chapter “REMOVING HEAD-
LIGHTS” on Page 327.
2. Press down both release tabs A and remove
cover.3. Turn gas discharge lamp counter-clockwise
and remove.
10_Cayenne_21_KW17.book Seite 330 Donnerstag, 9. April 2009 3:33 15

Minor Repairs
331
4. Press the release tab on the plug and pull plug
off.
5. Connect plug to new gas discharge lamp.
6. Insert gas discharge lamp and turn in clock-
wise direction. Make sure that the bulb is
installed in the correct position.
7. Fit cover on headlight. Both release tabs must
be fully engaged.
8. Install headlight.
For information on installing headlights:
Please see the chapter “INSTALLING HEAD-
LIGHTS” on Page 328.
9. Check operation of bulbs.Changing bulb for additional high beam
1. Remove headlight.
For information on removing headlights:
Please see the chapter “REMOVING HEAD-
LIGHTS” on Page 327.
2. Press down both release tabs A and remove
cover.3. Turn bulb socket B counter-clockwise and
remove.
10_Cayenne_21_KW17.book Seite 331 Donnerstag, 9. April 2009 3:33 15

Minor Repairs
339
Headlight AdjustmentfCheck tire pressure and adjust if necessary.
fPlease see the chapter “TIRE PRESSURES,
COLD (68 °F/20 °C)” on Page 354.
fPlease see the chapter “REPLACING BULBS”
on Page 326.Adjustment
The adjustment is made with the vehicle ready to
drive and the fuel tank completely filled.
T h e d r i ve r ' s s e a t m u s t b e l o a d e d b y a p e r s o n o r a
165lbs. (75kg) weight and the tire pressures must
meet the prescribed values. After being loaded,
the car must be rolled a few meters so that the
suspension can settle.
For checking the headlight adjustment, the verti-
cal position of the cutoff of the lowbeam (see fig.)
has to be projected on a vertical screen (wall) in
distance of 24.6 ft. (7.5 m) from the front lens of
the headlamp.The correct position of the cutoff is
3.0 in. (7.5 cm) at 24.6 ft. or 7.5 m (0.4°) below
a horizontal line, x cm from ground to the center
of the headlamp lens.
Lateral adjustment of the headlights should be
carried out at a specialist workshop with an optical
adjustment unit.
Distance
Visual aim shall be performed at not less than
24.6 ft. (7.5 m) (this value is a rounded down con-
version from the 25-foot distance typical of field
aim using a screen). The 24.6 ft. (7.5 m) distance
is measured from the headlamp lens to the
viewing screen.
Floor
The surface upon which the vehicle rests is flat
and approximately level.
Screen
The screen upon which headlamp beams are pro-
jected is perpendicular to the floor and the
vehicle's longitudinal axis, flat, uniformly light in
color, unobstructed, and wide and high enough to
accommodate the vehicle beam patterns to be
aimed.
The screen should be wide enough to provide at
least 3.3 ft. (1 m) of space outboard of the
vehicle's headlamp spacing.
10_Cayenne_21_KW17.book Seite 339 Donnerstag, 9. April 2009 3:33 15

340
Minor Repairs
Height adjustment for low beam/
high beam and additional high beam1. Switch ignition on.
2. Switch on low beam and/or high beam.
3. Open engine compartment lid.
4. Place allen key (6 mm) on adjusting screw.
5. Adjust low beam in direction of the arrow.
Changing headlights from left to
right-hand trafficIf you travel to a country where traffic uses the
other side of the road, the headlights must be
repositioned when you cross the border. The low
beam then lights symmetrically and drivers of
oncoming vehicles are not dazzled.
On the return journey, do not forget to readjust the
headlights.
Repositioning headlights1. Please see the chapter “REMOVING HEAD-
LIGHTS” on Page 327.
Remove headlight. Press down both release
tabs A and remove cover.
10_Cayenne_21_KW17.book Seite 340 Donnerstag, 9. April 2009 3:33 15

342
Minor Repairs
Bulb ChartExterior lights Type, ratingHalogen low beam and high beam
H7
Xenon low beam and high beam D1S
Side marker lights, front
W5W
Turn signal light, rear P21W
Turn signal light, front
PY21W
License plate light C5W
Fog light
H11
Rear fog light P21W
Back up light
P21W
Additional high beam H7
Cornering light
H11
Interior lights
Interior light, front
W5W
Reading light W5W
Footwell light
W3W
Glove compartment light W3W
Center console
W3W
Curb lights (doors) W3W
Warning lights (doors)
W3W
Curb light (rear lid) W5W
Guard light (rear lid)
W5W
Luggage compartment light K12V10W
TowingCertain state statutes and local ordinances prohi-
bit towing with a chain, rope or even a tow bar. In
addition, damage to your vehicle may result from
improper procedures. Consult your authorized
Porsche dealer for details.
When the turn signal light is set with the ignition on
and the emergency warning lights active, only the
turn signal light on the corresponding side of the
vehicle will light up. After the turn signal light is re-
set, the emergency warning lights will be switched
on again.Vehicle towingFlat bed towing is the preferred type of towing to
be used on Porsche vehicles. Under certain cir-
cumstances, wheel lifts may be used when the
vehicle will not roll.
The vehicle must be towed with all four
wheels off the ground, otherwise damage to
the vehicle may result.
10_Cayenne_21_KW17.book Seite 342 Donnerstag, 9. April 2009 3:33 15