2004 NISSAN TERRANO Windows switch

Ithrough power window main switch (6, 5).
Then, the motor raises or lowers the window until the switch is released.
Rear Door
Rear door windows will raise and lower in the same manner as passenger's door window.
POWER WINDOW LOCK
The power window lock is designed to lock operation of all windows except for driver's door window.
When the lock switch is pressed to lock position, ground of the sub-switches in the power window main switch
is disconnected. This prevents the power window motors from operating.
AUTO OPERATION
The power window AUTO feature enables the driver to open the driver's window without holding the window
switch in the down position.
The AUTO feature operates on the driver's window.
POWER WINDOW
System Description (Cont'd)
EL-157
http://vnx.su/

Trouble Diagnoses
SymptomPossible cause Repair order
None of the power windows can be
operated using any switch. 1. 40A fusible link, for circuit breaker
2. Power window relay
3. Ground circuit
4. Power window main switch1. Check 40A fusible link (letter
F, located in fuse and
fusible link box) and circuit breaker.
2. Check power window relay [built in the fuse block (J/B)].
3. Check the following:
a. Check ground circuit of power window main switch.
b. Check power window relay ground circuit.
4. Check power window main switch.
Driver side power window cannot be
operated but other windows can be
operated. 1. Driver side power window motor
circuit
2. Driver side power window motor
3. Power window main switch 1. Check harness between power window main
switch and driver side power window motor for
open or short circuit.
2. Check driver side power window motor.
3. Check power window main switch.
One or more power windows except
driver's side window cannot be oper-
ated. 1. Power window sub-switches
2. Power window motors
3. Power window main switch
4. Power window circuit1. Check power window sub-switch.
2. Check power window motor.
3. Check power window main switch.
4. Check the following.
a. Check harness between fuse block (J/B) terminal
B06 and power window sub-switch terminal 5.
b. Check harnesses between power window main switch and power window sub-switch for open/
short circuit.
c. Check harnesses between power window sub- switch and power window motor for open/short cir-
cuit.
Power windows except driver's side
window cannot be operated using
power window main switch but can
be operated by power window sub-
switch. 1. Power window main switch 1. Check power window main switch.
Driver side power window automatic
operation does not function properly. 1. Power window main switch 1. Check power window main switch.
POWER WINDOW
EL-162
http://vnx.su/

Trouble Diagnoses
PRELIMINARY CHECK
CHECK-IN
Open all windows and removekey from ignition key cylinder.
Does power door lock operate properly?
Ye s
ENo (All doors) Power door lock does not operate by using;
Ð any switch.
........................................................................\
..
Ð door lock/unlock switch. ........................................................................\
..
Ð driver side lock knob switch and/or key cylinder.
........................................................................\
..
Ð passenger side lock knob switch and/or key cylinder.H
ESYMPTOM 1
ESYMPTOM 2
ESYMPTOM 3
ESYMPTOM 4
No (Specific door) SYMPTOM 5
Insert key to ignition key cylinder,
open any door and lock the door using driver or passenger side knob lock switch.
Does key reminder system oper-
ate properly?
Ye s
ENo SYMPTOM 6
INSPECTION END
After performing preliminary check, continue with diagnostic procedure in ªSYMPTOM CHARTº,
EL-172.
HWhen one or more doors are opened with lock knob on passenger door set to LOCK, only passenger door
will lock. (Power door lock system will not operate.)
E E
H
H
H
H
H
POWER DOOR LOCK
EL-171
http://vnx.su/

Trouble Diagnoses
PRELIMINARY CHECK
CHECK-IN
Open all windows and removekey from ignition key cylinder.
Does power door lock operate properly?
Ye s
ENo (All doors) Power door lock does not operate by using;
Ð any switch.
........................................................................\
..
Ð driver side lock knob switch and/or key cylinder.
........................................................................\
..
Ð passenger side lock knob switch and/or key cylinder.H
ESYMPTOM 1
ESYMPTOM 2
ESYMPTOM 3
No (Specific door) SYMPTOM 4
Does super lock set by using
door key cylinder?
Ye s
ENo (All doors) Super lock does not set by using;
Ð both door key cylinders.
........................................................................\
..
Ð one of door key cylinders.
ESYMPTOM 5
ESYMPTOM 6
No (Specific door) SYMPTOM 9
Does super lock release by using
door key cylinder or IGN key switch?
Ye s
ENo (All doors) Super lock does not release by using;
Ð one or both door key cylinders.
........................................................................\
..
Ð IGN key switch. (Signal from NATS IMMU)
ESYMPTOM 7
ESYMPTOM 8
No (Specific door) SYMPTOM 9
Insert key to ignition key cylinder,
open any door and lock the door using driver or passenger side knob lock switch.
Does key reminder system oper- ate properly?
Ye s
ENo SYMPTOM 10
INSPECTION END
After performing preliminary check, continue with diagnostic procedure in ªSYMPTOM CHARTº,
EL-193.
HWhen one or more doors are opened with lock knob on passenger door set to LOCK, only passenger door
will lock. (Power door lock system will not operate.)
E
E
E
H
H
H
H
H
H
H
POWER DOOR LOCK Ð SUPER LOCK Ð
EL-192
http://vnx.su/

PRELIMINARY CHECK
The system operation is canceled by turning the ignition switch to ªONº at any step between START and
ARMED in the following flow chart.
System phaseSTART
Note: Before starting operation check, open front windows.
EDISARMED Turn ignition switch ªOFFº and remove the ignition key.
ªSECURITYº indicator lamp will blink every 2.6 seconds.
(NATS)
OK
ENGRefer to NATS
trouble diagno-
sis.
Close all doors, hood and trunk lid.
Press the ultrasonic cancel switch. The ªSECURITYº indicator lamp
will go on for approximately 6 seconds.
OK
ENGSYMPTOM 1
PRE-ARMED Lock doors using key or multi-remote controller.
ARMEDFor about 30 seconds, ªSECURITYº indicator lamp will blink inter-
mittently.
OK
ENGSYMPTOM 2
Disarm the system by unlocking the vehicle using the remote con-
troller. Arm the system again without excluding the ultrasonic sen-
sors.
ALARM Unlock any door without multi-remote controller, activate the ultra-
sonic sensors by inserting an object into the vehicle's interior, or
open hood or door.
........................................................................\
...............................
Alarm (horn and hazard lamp) will operate.
OK
ENGSYMPTOM 3
ENGSYMPTOM 4
EDISARMED Unlock the vehicle using the multi-remote controller or insert the
key in the ignition and switch it to ON.
Alarm (horn and hazard lamp) will stop.
OK
ENGSYMPTOM 5
System is OK.
After performing preliminary check, go to ªSYMPTOM CHARTº, EL-266.
H
H
H
HH
HH
H
HH
HH
H
THEFT WARNING SYSTEM
Trouble Diagnoses (Cont'd)
EL-265
http://vnx.su/