2004 NISSAN ARMADA engine

[x] Cancel search: engine

Page 270 of 344

NISSAN ARMADA 2004 1.G Owners Manual If the cooling system frequently requires
coolant, have it checked by a NISSAN
dealer.
CHANGING ENGINE COOLANT
A NISSAN dealer can change the engine coolant.
The service procedure can be found in the

Page 271 of 344

NISSAN ARMADA 2004 1.G Owners Manual CAUTION
Oil level should be checked regularly. Op-
erating the engine with an insufficient
amount of oil can damage the engine, and
such damage is not covered by warranty.
CHANGING ENGINE OIL
1. Park

Page 272 of 344

NISSAN ARMADA 2004 1.G Owners Manual 7. Refill engine with recommended oil through
the oil filler opening, then install the oil filler
cap securely.
See “Capacities and recommended
fuel/lubricants” in the “Technical and con-
sumer

Page 273 of 344

NISSAN ARMADA 2004 1.G Owners Manual When checking or replacement is required, we
recommend your NISSAN dealer for servicing.
WARNING
cUse only Genuine Nissan Matic J ATF.
Do not mix with other fluids.
cUsing automatic transmission fluid

Page 274 of 344

NISSAN ARMADA 2004 1.G Owners Manual BRAKE FLUID
Check the brake fluid level in the reservoir. If the
fluid level is below the MIN line or the brake
warning light comes on, add Genuine NISSAN
Super Heavy Duty Brake Fluid or equivalentDOT

Page 276 of 344

NISSAN ARMADA 2004 1.G Owners Manual 2. Check the fluid level in each cell If it is
necessary to add fluid, add only distilled
water to bring the level up to the bottom of
the filler opening.Do not overfill.Vehicles operated in high temp

Page 277 of 344

NISSAN ARMADA 2004 1.G Owners Manual 1. Visually inspect each belt for signs of un-
usual wear, cuts, fraying or looseness. If the
belt is in poor condition or is loose, have it
replaced or adjusted by a NISSAN dealer.
2. Have the belts

Page 278 of 344

NISSAN ARMADA 2004 1.G Owners Manual The air cleaner filter should not be cleaned and
reused. Replace it according to the maintenance
intervals shown in the “NISSAN Service and
Maintenance Guide.” When replacing the filter,
wipe the