EXTERIOR MARKINGS51 5
(2) EVOLUTION MR MARK
Boot lid end line
Boot lid end line
2.Important fixing notes
(1) Clean and remove any grease from the body surface where markings will be
affixed, using unleaded petrol.
(2) Remove the paper backing on the rear of the markings, and fix in position.
(3) Remove the ‘application’ tape.
Note
• Do this job in an ambient temperature of 20 38
˚C in a dust free location.
•If temperature is less than 20
˚C,warm up the markings and the body where
they will be fitted to between 20 – 30
˚C.
•Stick the markings on and press firmly so that no air bubbles get trapped.
RJSY402025–46
