2004 MITSUBISHI ENDEAVOR cover

8. Install timing belt covers. Install crankshaft pulley. Using Pulley Holder
(MB991800) and Pins "B" (MB001802), tighten crankshaft pulley bolt to
specification. See TORQUE SPECIFICATIONS
. To complete installation,
reverse removal procedure.
Fig. 5: Adjusting Timing Belt Tension

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
TORQUE SPECIFICATIONS TORQUE SPECIFICATIONS Application
Ft. Lbs. (N.m)
Auto-Tensioner Bolt
15-19 (20-26)
Camshaft Sprocket Bolt
58-72 (78-98)
Crankshaft Pulley Bolt
(1) 134-140 (180-

2004 Mitsubishi Endeavor Limited MITSUBISHI 3.8L V6 - SOHC - Endeavor & Galant

190)
Engine Mount Bracket-To-Engine Bolt
31-37 (42-48)
Timing Belt Idler Pulley Bolt
30-36 (39-49)
Timing Belt Tensioner Arm Pivot Bolt
26-40 (34-54)
Timing Belt Tensioner Center Bolt
32-40 (42-54)
INCH Lbs. (N.m)
Timing Belt Cover Bolt
97 (11)
(1)
Apply engine oil to bolt threads before installation.

2004 Mitsubishi Endeavor Limited MITSUBISHI 3.8L V6 - SOHC - Endeavor & Galant

1. When the selector lever is moved to the "R" position with the rear wiper switch
at the "INT" position, the wiper should operate twice or three times at low
speed after approximately one second.
2. If not, troubleshoot (Refer to SWS DIAGNOSIS
).
REAR WIPER MOTOR CHECK Inspect the rear wiper motor by removing the harness connector with the motor still
installed in the vehicle. WIPER MOTOR OPERATION 1. Remove the motor cover (Refer to REAR WIPER AND WASHER
).
2. Connect the rear wiper motor connector terminal num
ber 1 to the ground.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor

Fig. 3: Checking Rear Wiper Motor Stop
s
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
WIPER MOTOR AT STOP POSITION OPERATION 1. Remove the motor cover (Refer to REAR WIPER AND WASHER
).
2. Connect the rear wi
per motor connector terminal num
ber 1 to the
ground.

2004 Mitsubishi Endeavor LS
2004 BODY & ACCESSORIES Rear Wiper And Washer - Endeavor