2004 MERCEDES-BENZ E320 stop start

202 Controls in detailSliding / pop-up roof*
Turn SmartKey in the starter switch to
position1 or2 or press the
KEYLESS-GO* start/stop button once
or twice.
Opening and closing the
sliding / pop-up roof

To open, close, raise or lower the
sliding/pop-up roof, move the switch
to resistance point in the required
direction1to4.
Release the switch when the roof has
reached the desired position.Fully opening (Express-open) and clos-
ing (Express-close) the
sliding/pop-up roof

To open, close, raise or lower the slid-
ing/pop-up roof, move the switch past
the resistance point in the required
direction1to4 and release.
The sliding/pop up roof opens or clos-
es completely.
Stopping the sliding / pop-up roof

Move the switch in any direction.Opening and closing the
sliding / pop-up roof with the SmartKey
The power windows (
page 199) will also
be opened or closed when you operate the
sliding / pop-up roof with the SmartKey.

Aim transmitter eye at the front door
handle.
iIf the movement of the sliding/pop-up
roof is blocked during the closing pro-
cedure, the roof will stop and reopen
slightly.
Warning!
G
Never operate the windows or
sliding / pop-up roof if there is the possibility
of anyone being harmed by the opening or
closing procedure.
In case the procedure causes potential dan-
ger, the procedure can be immediately halt-
ed by releasing the remote control button.
To reverse direction of movement
pressŒ for opening or ‹ for closing.

205 Controls in detail
Panorama sliding / pop-up roof*
Panorama sliding / pop-up roof*
Opening and closing the roller sunblinds
The roller sunblinds can only be opened or
closed when the panorama
sliding / pop-up roof is closed. The front
and rear roller sunblind cannot be operat-
ed individually.Panorama sliding / pop-up roof switch1Open
2Close
Roller sunblinds switch, rear 1Open
2Close
Turn SmartKey in the starter switch to
position1 or2 or press the
KEYLESS-GO* start/stop button.
Opening and closing the roller sun-
blinds

To open or close the roller sunblinds,
move the panorama sliding/pop-up
roof switch or the rear roller sunblind
switch to resistance point in the re-
quired direction1 or2.
Warning!
G
When opening or closing the panorama
sliding / pop-up roof, make sure that there is
no danger of anyone being harmed by the
opening or closing procedure.
If the panorama sliding / pop-up roof is
closed with the convenience closing feature
and becomes blocked, it will not open auto-
matically. Should this occur, press the
Œbutton on the SmartKey and hold it
down; the panorama sliding / pop-up roof
opens again.
The panorama roof is made out of glass. In
the event of an accident, the glass may shat-
ter. This may result in an opening in the roof.
In a vehicle rollover, occupants not wearing
their seat belts or not wearing them properly
may be thrown out of the opening. Such an
opening also presents a potential for injury
for occupants wearing their seat belts prop-
erly as entire body parts or portions of them
may protrude from the passenger compart-
ment.


206 Controls in detailPanorama sliding / pop-up roof*
Release the switch when the roller sun-
blinds have reached the desired posi-
tion.
Fully opening the roller sunblinds
(Express-open)

Move the panorama sliding/pop-up
roof switch or the rear roller sunblind
switch past the resistance point in
direction1 and release.
The roller sunblinds opens completely.
Stopping the roller sunblinds

Move the switch in any direction.Opening and closing the panorama
sliding / pop-up roof
The panorama sliding/pop-up roof can be
opened and closed electrically. The switch
for the panorama sliding/pop-up roof is on
the overhead control panel.
The panorama sliding/pop-up roof only op-
erates with the sunblinds opened.
1Push back to slide roof open
2Push forward to slide roof closed
3Push up to raise roof
4Pull down to lower roof
Warning!
G
When closing the roller sunblinds, make
sure that no one is in danger of being injured
by the closing procedure. The closing of the
roller sunblinds can be immediately halted
by releasing the switch.
Warning!
G
When opening or closing the panorama
sliding / pop-up roof, make sure that there is
no danger of anyone being harmed by the
opening or closing procedure.
The opening procedure of the panorama
sliding/pop-up roof can be immediately
halted by releasing the switch or, if the
switch was moved past the resistance point
and released, by moving the switch in any di-
rection.
The closing procedure of the panorama
sliding/pop-up roof can be immediately
halted by releasing the switch.
When leaving the vehicle, always remove the
SmartKey from starter switch, take the
SmartKey with KEYLESS-GO* with you, and
lock your vehicle. Do not leave children un-
attended in the vehicle, or with access to an
unlocked vehicle. Unsupervised use of vehi-
cle equipment can cause an accident
and/or serious personal injury.


207 Controls in detail
Panorama sliding / pop-up roof*

Turn SmartKey in the starter switch to
position1 or2 or press the
KEYLESS-GO* start/stop button once
or twice.Opening and closing the panorama
sliding/pop-up roof

To open or close the panorama
sliding/pop-up roof, move the switch
to resistance point in the required
direction1 to4.
Release the switch when the roof has
reached the desired position.
Fully opening the panorama
sliding / pop-up roof (Express-open)

Move the switch past the resistance
point in direction1 and release.
The panorama sliding / pop-up roof
opens completely.
Stopping the panorama
sliding / pop-up roof

Move the switch in any direction.
!Do not transport any objects that pro-
trude out of the panorama
sliding / pop-up roof as the seals could
be damaged.
Do not open the panorama
sliding / pop-up roof if there is snow or
ice on the roof, as this could result in
malfunctions.
The panorama sliding/pop-up roof can
be opened or closed manually should
an electrical malfunction occur
(page 358).
iYou can also open or close the panora-
ma sliding/pop-up roof using the:

SmartKey (summer opening/con-
venience future) (
page 199)


button, in the control panel of
the automatic climate control
(page 186)


buttone in the control panel of
the automatic climate control
(page 192)
iThe panorama sliding/pop-up roof can-
not be closed fully (Express-close)

250 Controls in detailUseful featuresYou can take and place telephone calls us-
ing thes andt buttons on the
steering wheel. To carry out other tele-
phone functions, use the control system
(page 129).
See separate operating manual for instruc-
tions on how to use the telephone.
Tele Aid* The Tele Aid system
(Tele
matic A
larm I
dentification on D
e-
mand)
The Tele Aid system consists of three
types of response:


automatic and manual emergency


roadside Assistance and


information
The Tele Aid system is operational provid-
ing that the vehicle’s battery is charged,
properly connected, not damaged and cel-
lular and GPS coverage is available.
The speaker volume of a Tele Aid call can
be adjusted when using the volume control
on the multifunction steering wheel. To
raise, press buttonæ and to lower,
press buttonç.

To activate, press the SOS button, the
Roadside Assistance button• or
the Information button¡, depend-
ing on the type of response required.
Bear in mind that at a speed of just 30 mph
(approximately 50 km / h), your vehicle is
covering a distance of approximately
44 feet (approximately 13.5 m) every sec-
ond.Warning!
G
Some jurisdictions prohibit the driver from
using a cellular telephone while driving a ve-
hicle. Whether or not prohibited by law, for
safety reasons, the driver should not use the
cellular telephone while the vehicle is in mo-
tion.
Stop the vehicle in a safe location before an-
swering or placing a call.
!The initial activation of the Tele Aid sys-
tem may only be performed by com-
pleting the subscriber agreement and
placing an acquaintance call using the
SOS button. Failure to complete either
of these steps will result in a system
that is not activated. If the system is
not activated, the indicator lamp in the
SOS button stays on after turning the
SmartKey in starter switch to
position2, or pressing the
KEYLESS-GO* start/stop button twice
to position2. The message
Tele Aid –
not activated
will be shown in the
multifunction display for approximately
10 seconds.
If you have any questions regarding ac-
tivation, please call the Response Cen-
ter at 1-800-756-9018 (in the USA) or
1-888-923-8367 (in Canada).


256 Controls in detailUseful features
Upgrade signals
The Tele Aid system processes calls using
the following priority:

Automatic emergency – First priority


Manual emergency – Second priority


Roadside assistance – Third priority


Information – Fourth priority
Should a higher priority call be initiated
while you are connected, an upgrade (al-
ternating) tone will be heard, and the ap-
propriate indicator lamp will flash. If
certain information such as vehicle identi-
fication number or customer information is
not available, the operator may need to re-
transmit.
During this time you will hear a beep and
voice contact will be interrupted. Voice
contact will resume once the retransmis-
sion is completed. Once a call is conclud-
ed, a beep will be heard and the respective
indicator lamp will stop flashing. The
COMAND system operation will resume.
!If the indicator lamps do not start flash-
ing after pressing one of the buttons or
remain illuminated (in red) at any time,
the Tele Aid system has detected a
fault or the service is not currently ac-
tive, and may not initiate a call. Visit
your authorized Mercedes-Benz Center
and have the system checked or con-
tact the Response Center at
1-800-756-9018 (in the USA) or
1-888-923-8367 (in Canada) as soon
as possible.
!If the indicator lamp continues to flash
or the system does not reset, contact
the Response Center at
1-800-756-9018 (in the USA) or
1-888-923-8367 (in Canada), or
Mercedes-Benz Customer Assistance
at 1-800-FOR-MERCedes
(1-800-367-6372) in the USA or Cus-
tomer Service at 1-800-387-0100 in
Canada.iThe indicator lamp in the respective
button flashes until the call is conclud-
ed. Calls can only be terminated by a
Response Center or Customer Assis-
tance Center representative except
Roadside Assistance and Information
calls, which can also be terminated by
pressing buttont on the multifunc-
tion steering wheel.

270 OperationDriving instructionsDriving off
Apply the brakes to test them briefly after
driving off. Perform this procedure only
when the road is clear of other traffic.
Warm up the engine smoothly. Do not
place full load on the engine until the oper-
ating temperature has been reached.
When starting off on a slippery surface, do
not allow a drive wheel to spin for an ex-
tended period with the ESP switched off.
Doing so may cause serious damage to the
drive train which is not covered by the
Mercedes-Benz Limited Warranty.
Parking
Tires
!Simultaneously depressing the acceler-
ator pedal and applying the brake re-
duces engine performance and causes
premature brake and drivetrain wear.
!Set the parking brake whenever park-
ing or leaving the vehicle. In addition,
move gear selector lever to position P.
When parking on hills, always set the
parking brake and turn front wheel
against road curb.Warning!
G
Do not park this vehicle in areas where com-
bustible materials such as grass, hay or
leaves can come into contact with the hot
exhaust system, as these materials could be
ignited and cause a vehicle fire.
To reduce the risk of personal injury as a re-
sult of vehicle movement, before turning off
the engine and leaving the vehicle always:

Keep right foot on brake pedal.


Firmly depress parking brake pedal.


Move the selector lever to positionP.


Slowly release brake pedal.


When parked on an incline, turn front
wheel towards the road curb.


Turn the SmartKey to starter switch
position0 and remove, or press
KEYLESS-GO* start/stop button (vehi-
cles with KEYLESS-GO*).


Take the SmartKey or the SmartKey with
KEYLESS-GO* with you and lock vehicle
when leaving.
Warning!
G
If you feel a sudden significant vibration or
ride disturbance, or you suspect that possi-
ble damage to your vehicle has occurred,
you should turn on the hazard warning flash-
ers, carefully slow down, and drive with cau-
ti o n t o an a r ea wh ic h is a s a fe d is ta n c e fr o m
the road.

278 OperationAt the gas station
At the gas stationThe fuel filler flap is located on the
right-hand side of the vehicle towards the
rear. Locking/unlocking the vehicle with
the SmartKey or the SmartKey with
KEYLESS-GO* automatically locks/un-
locks the fuel filler flap.

Turn the engine off

by turning the SmartKey to
position0. Remove the SmartKey
from the starter switch.


by pressing the KEYLESS-GO*
start/stop button. Open the driv-
er’s door (with the driver’s door
open, starter switch is now in
position0, same as SmartKey re-
moved from starter switch).

Open the fuel filler flap by pushing at
the point indicated by the arrow.
The fuel filler flap springs open.

Turn the fuel cap to the left and hold on
to it until possible pressure is released.

Take off the cap and set it in the recess
on the fuel filler flap.
To prevent fuel vapors from escaping
into open air, fully insert filler nozzle
unit.

Only fill your tank until the filler nozzle
unit cuts out – do not top up or over-
fill.
Warning!
G
Gasoline is highly flammable and poisonous.
It burns violently and can cause serious inju-
ry. Whenever you are around gasoline, avoid
inhaling fumes and skin contact, extinguish
all smoking materials. Never allow sparks,
flame or smoking materials near gasoline!