2004 MERCEDES-BENZ CLK-CLASS remote control

265 Controls in detail
Useful features
Stolen vehicle tracking services
In the event your vehicle was stolen:
Report the incident to the police.
The police will issue a numbered inci-
dent report.

Pass this number on to the
Mercedes-Benz Response Center along
with your password issued to you when
you subscribed to the service.
The Response Center will then attempt
to covertly contact the vehicle’s
Tele Aid system. Once the vehicle is lo-
cated, the Response Center will con-
tact the local law enforcement and you.
The vehicle’s location will only be pro-
vided to law enforcement.
Garage door opener
The built-in remote control is capable of
operating up to three separately controlled
devices, for example garage door openers,
gate openers, or other devices compatible
with HomeLink
® or some other systems.
You can program the signal transmitter
buttons.
Remote control integrated into the interior
rear view mirror1Indicator lamp
2 3 4Signal transmitter button
5Hand-held transmitter button
6Hand-held remote control trans-
mitter (not part of the vehicle
equipment)
ProCarManuals.com

266 Controls in detailUseful featuresWarning!
G
Before programming the integrated remote
control to a garage door opener or gate op-
erator, make sure that people and objects
are out of the way of the device to prevent
potential harm or damage.
When programming a garage door opener,
the door moves up or down. When program-
ming a gate operator, the gate opens or
closes.
Do not use the integrated remote control
with any garage door opener that lacks safe-
ty stop and reverse features as required by
U.S. federal safety standards (this includes
any garage door opener model manufac-
tured before April 1, 1982). A garage door
that cannot detect an object - signaling the
door to stop and reverse - does not meet
current U.S. federal safety standards.
iCertain types of garage door openers
are incompatible with the integrated
opener. If you should experience diffi-
culties with programming the transmit-
ter, contact your authorized
Mercedes-Benz Center, or call
Mercedes-Benz Customer Assistance
Center (in the USA only) at
1-800-FOR-MERCedes, or Customer
Service (in Canada) at
1-800-387-0100.
iFor operation in the USA only:
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any inter-
ference received, including interfer-
ence that may cause undesired
operation.
Any unauthorized modification to this
device could void the user’s authority
to operate the equipment.
ProCarManuals.com

267 Controls in detail
Useful features
Programming or reprogramming the in-
tegrated remote control
Step 1:
Switch on ignition.
Step 2:

If you have previously programmed an
integrated signal transmitter button
and wish to retain its programming,
proceed to step 3. Otherwise, press
and hold the two outer signal transmit-
ter buttons2 and4 and release
them only when the indicator light be-
gins to flash after approximately 20
seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory. If you later wish to program a
second and/or third hand-held trans-
mitter to the remaining two signal
transmitter buttons, do not repeat this
step and begin directly with step 3.Step 3:

Hold the end of the hand-held remote
control transmitter6 of the device
you wish to train approximately 2 to
5 in (5 to12 cm) away from the surface
of the integrated remote control locat-
ed on the interior rear view mirror,
keeping the indicator lamp1 in view.
Step 4:

Using both hands, simultaneously
press the hand-held transmitter
button5 and the desired integrated
signal transmitter button (2, 3
or4). Do not release the buttons until
completing step 5.
The indicator lamp1 on the integrat-
ed remote control will flash, first slowly
and then rapidly.Step 5:

When the indicator lamp1 flashes
rapidly, release both buttons.
Step 6:

Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp1.
If the indicator lamp1 stays on con-
stantly, programming is complete and
your device should activate when the
integrated signal transmitter button is
pressed and released.iThe indicator lamp1 flashes the first
time the signal transmitter button is
programmed. If this button has already
been programmed, the indicator lamp
will only start flashing after 20 sec-
onds.
ProCarManuals.com

269 Controls in detail
Useful features
Step 12:
Confirm the garage door operation by
pressing the programmed integrated
signal transmitter button (2, 3
or4).
Step 13:

To program the remaining two buttons,
repeat the steps above starting with
step 3.Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the inte-
grated signal transmitter to pick up the sig-
nal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:Step 4:

Continue to press and hold the inte-
grated signal transmitter button (2,
3 or4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter6 every two seconds
until the frequency signal has been
learned. Upon successful training, the
indicator lamp1 will flash slowly and
then rapidly after several seconds.

Proceed with programming step 5 and
step 6 to complete.
Operation of integrated remote control

Switch on ignition.

Select and press the appropriate inte-
grated signal transmitter button (2,
3 or4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
ProCarManuals.com

270 Controls in detailUseful featuresErasing the integrated remote control
memory
Switch on ignition.

Simultaneously hold down the signal
transmitter buttons2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp1 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:

Press and hold the desired signal trans-
mitter button (2, 3 or4). Do not re-
lease the button.

The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
iIf you sell your vehicle, erase the codes
of all three channels.
ProCarManuals.com

424 Technical termsRemote Vehicle Diagnostics
Transmission of vehicle data and cur-
rent location to the Mercedes-Benz
Customer Assistance Center for sub-
scribers to Tele Aid service.
REST
(Residual engine heat utilization)
Feature that uses the engine heat
stored in the coolant to heat the vehi-
cle interior for a short time after the en-
gine has been turned off.
Restraint systems
Seat belts, belt tensioners, airbags and
child restraint systems. As indepen-
dent systems, their protective func-
tions complement one another.Roll bars
Occupant protection system which
consists of tubular steel, integrated in
the rear head restraints. The roll bars
are lowered into the car body during
normal driving conditions and raised
automatically in an accident or in a crit-
ical driving situation.
RON
(R
esearch O
ctane N
umber)
The Research Octane Number for gaso-
line as determined by a standardized
method. It is an indication of a gaso-
line's ability to resist undesired detona-
tion (knocking). The average of both
the ->MON (Motor Octane Number)
and RON (Research Octane Number) is
posted at the pump, also known as
ANTI-KNOCK INDEX.Shift lock
When the vehicle is parked, this lock
prevents the gear selector lever from
being inadvertently moved out of
positionP without SmartKey turned
and brake pedal depressed.
Soft top
Soft top roof that can be opened by
pulling and closed by pressing a switch
and stored in the soft top compartment
in the trunk area.
Speedshift (CLK 55 AMG)
Steering wheel gearshift control. You
can change the gears yourself with the
steering wheel gearshift buttons.
SRS
(S
upplemental R
estraint S
ystem)
Seat belts, emergency tensioning de-
vice and airbags. Though independent
systems, they are closely interfaced to
provide effective occupant protection.
ProCarManuals.com

435 Index
Setting last stored speed
("Resume" function) 235
Setting the current speed 234
Warning and indicator lamps 231
Door control panel 28
Door entry lamps 125
Door handle 28
Door unlock
With Tele Aid 264
Doors
Message in display 331
Opening from inside vehicle 97
Opening from outside 89, 94
Downhill driving
Cruise control 227
Downshifting
Manual shift program mode
(CLK 55 AMG) 165
One-touch gearshifting 158
Steering wheel gearshift
control (CLK 55 AMG) 162
Drinking and driving 273Driving
General instructions 40, 273
Hydroplaning 277
In winter 279
Problems 51
Safety systems 76
Through standing water 280
Traveling abroad 280
With Distronic* 238
Driving instructions 273
Driving off 275
Driving safety systems
ABS 77
BAS 78
ESP 79
Driving system
Parktronic* 241
Driving systems 226
Cruise control 226
Distronic* 229
Driving safety systems 76E
Easy-entry/exit feature 109
Activating 150
Interrupting movement 150
Electrical fuses 394
Electrical system
Technical data 407
Electronic Stability Program see ESP
Emergency call system* 257
Emergency calls
Initiating an emergency call 260
Telephone* 208
With Tele Aid* 258
Emergency operation
(Limp Home Mode) 166
Emergency operations
Closing soft top 355
Closing soft top with
add. locking mechanism 364
Closing soft top without
add. locking mechanism 357
Locking the vehicle 349
Remote door unlock 264
Unlocking the vehicle 348
Emergency tensioning device see ETD
ProCarManuals.com

439 Index
Instrument cluster 22, 126, 421
Cleaning 309
Coolant temperature indicator 127
Illumination 126
Lamps in 312–318
Multifunction display 129
Outside temperature indicator 128
Selecting language 143
Instruments and controls see Cockpit
Interior lighting 124
Activating automatic control 124
Deactivating automatic control 125
Delayed switch-off 148
Manual operation 125
Interior rear view mirror
Adjusting 38
Interior storage spaces 250
Armrest 251
Glove box 250
Parcel net 253
Storage bags 252
J
Jack 343, 345
Jump starting 388K
Key, mechanical 348
Key, SmartKey with KEYLESS-GO*
Changing the batteries 351
Key-dependency memory
Settings 151
KEYLESS-GO* 421
Activating ignition with 33
Closing side windows 96
Closing soft top 96
Closing windows with 214
Factory setting 94
Global locking 94
Global unlocking 94
Important notes 92
Locking the vehicle 95
Messages in display 334
Remote controls 91
Starting the engine 44
Turning off the engine 55
Unlocking with 32
Unlocking, trunk lid 96
Kickdown 163, 421
Kilometers/miles in speedometer 142
Km/h or mph in speedometer 142L
Labels, identification 400
Lamp bulbs, exterior 372
Lamp sensor
Messages in display 336
Lamps, exterior
Front 373
Light sensor 336
Messages in display 335–338
Rear 373
Lamps, indicator and warning
ABS 312
Battery (SmartKey) 89, 94
Brakes 313
Center console 319
CHECK ENGINE 314
Coolant 315, 328
Distance warning 316
Distronic* 231, 237
Engine diagnostics 314
ESP 316, 317
Fuel reserve 317
Instrument cluster 312–318
PASS. AIRBAG OFF 63, 319
Roll bar 317
Seat belts 318
ProCarManuals.com