2004 MERCEDES-BENZ CLK CABRIOLET Dash board

39
Getting started
Driving
6 Select either first or reverse gear.
6 Slowly release the clutch pedal and
carefully depress the accelerator.
! Change gear in good time. Make sure that
the enginespe eddoes notreach thered area in
the rev cou nter. There is otherwise a danger of
engine dam age.
Do not allow the wheels tospin, ifpossible. You
could otherwise damage the dri vetrain. Automatic
transmission*
i You can only move the selector lever tothe
re quired position by depressing the brake pedal.
Only then isthe selector lever lock disabled.
6 Depress the brake pedal and keep it in
this posi tion.
The selector lever lock is released.
6 Release the parking brake.
6 Move the selector lever to position D
or R.
i Wait for the shi ftprocess to complete
before pulling away.
6 Release the brake pedal.
6 Carefully depress the accelerator
pe dal.
i After a cold start, the automatic transmi s-
sion will shift at a higher engine spe ed. This helps
th e catalytic converter toreach its operati ng
te mperature more quickly. Dipped-
beam headlamps
The light switch is located on the dash-
board between the steering wheel and the
driver's door.
Light switch
1 Lights off
2 Dipped-beam headlamps on G
Risk of accident Do not shift down unle
ss the current driving
sp eed is within the permiss ible range for the
gear to be selected.
Do not change down for additio nal engine
braking ona slippery road surface. The drive
wheels could then lose their grip and the
vehi cle could skid. Youc ould lose control of
the vehicle and cause an acc iden t. Switching on the headlamps
P 82.10-2889-31 neu209en_d2.
boo Seite 39Diens tag, 25 .Mai 2004 7:26 19

54 Safety
Occupant safety
Your vehicleisequipped with the follo wing
airbags:
! Driver's front airbag accommodated in
the steering wheel housing
! Front-passenger fron tairbag above the
glove compartment
! Sidebags (Coupé)
! in the middle of the doors
! in the rear sidewall
! Head /thorax airba gs(Cabriolet)
! in the outer sides of the front seats
! in the rear sidewall
! Windowbags (Coupé)
!along the roof frame betw een the
front and rear doors Airbag
deploym ent
The airbag inflates in milliseconds. The
1 warning lamp lights up. i
Ifth e airba gsare triggered, you will hear a
bang and asmall amount ofdust may also be
released. This bang will not damage your hearing
and the dust does not constitu te ahealth hazard.
Airbag inflation slows down and restricts
the mo vement of the vehicle occupant.
If a vehicle occupant comes into contact
with an airbag which has been triggered,
the airbag will release some hot gas. This
feature is designed to reduce the force act-
ing on the occupant's head and ch est.
These airbags are theref orein a depress u-
rised state follo wing the accident. !
Do not lean forwards , e.g. over the pad-
ded boss of the steering wheel, particu-
la rly while the vehicle is in motion.
! Do not put your feet on the dashboard.
! Only hold the steering wheel by the rim.
This allows the airbag to inflate fully.
If you hold the ins ideo f the steering
wheel, you could be injured if the airbag
is triggered.
! Do not lean on the doo rsfrom inside the
vehicle.
! Donot place any objects onthe airba gs
or between the airbags and the vehicle's
oc cupants.
! Donot ha nganyha rd obje cts, e.g. coat
hangers ,on the grab handles or coat
hook s.
Because of the high speed at which airbags
have to inflate, it is not possib leto rule out
entire lythe risk of injurie scaused by an
inflating airbag. 209en_d2.boo Seite
54Diens tag, 25 .Mai 2004 7:26 19

100 Controls in detail
Light
ing
You will find information about switching
on the headlamps and indicating a turn in
the "Getting started" section ( =page 39).
For reasons of safety, Mercedes-Benz rec-
ommends that you also drive with the
lights on during the day. Legal and optional
additional requirements may impose varia-
tions in certain countries. In these coun-
tries, the dipped-beam headlamps are
switched on when the ignition is switched
on. In countries in which there is no legal
requirement to use constant headlamp
mode, this setting can be altered using the
operating system ( =pa ge 122).
i If you travel to countr ies where they drive on
the opposite side of the road to that inthe coun-
try where the vehicle is registe red, the asymmet-
rical dipped-beam headlamps may dazzle on-
co ming traffic .H ave your head lampsswitche dto
symmetrical dipped beam or partially masked for
drivi nginthe secou ntrie s (=
page 259). Informa-
tion on this can be obtai ned from any Merced es-
Benz Service Centre. The light switch is on the dashboard
next
to the steering whee l.
M Lights off
U Automatic light control
C Side lamps, licence plate and
instrument lighting on
B Dipped-beam or main-beam head-
lamps on
ˆ Right-hand parking lamp on
‚ Left-hand pa rking lamp on i
Awa rning signal sou nds if you remove the
key from the ignition lock and open the driver's
door while the side lamps ordipped-bea mhead-
lamps are switched on.
TheSwitch off lights!message appears in
the multi-function display. Constant headlamp mode
Constant headlamp mode can be set using
the operating system (
=pag e122) . This
does not apply to countries inwhich there
is a lega lrequirement to use constant
hea dlam pmod e.
6 Turn the light switch to M.
The dipped-beam headl amps, side
lamps and licence plate lighting light up
automatical lywhen the engine is run-
ning. Automatic headlamp feature
The side lamps, dipp
ed-beam headlamps
and licence plate lighting are switched on
automatically when ambient light falls
below a predetermined level. Lighting Light swi
tch P 82
.10-2890-31 209en_d2.boo Seite
100 Dienstag, 25. Mai 2004 7:26 19

102 Controls in detail
Light
ing
i Vehicle models with xenon hea dlamps *do
not feature this thumbwheel, as the headlamp
range is adjusted automatically.
You can only adjust the headlamp range
while the engine is running.
The thumbwheel is located on the dash-
board between the steeri ngwheel and the
driver's door.
1 Thumbwheel 6
Turn the thumbwheel to the setting
required.
The combination switch is located on the
left of the steering wheel.
1 Main-beam headlamps
2 Headlamp flasher Switching
onthe main-beam head- lamps
6
Make sure that the dipped-beam head-
lamps are switched on.
6 Push the combination switch towards
1.
The B main-beam head lamps sym-
bol on the right of the instrume ntclus-
ter lights up. Headlamp fl
ashe r
6 Pull the combination switch briefly
towards 2. Head
lamp range control P
82.10-2888-31 neu Position
0 One or both front seats
occu
pied 1 All seats occupied and
/or
boot loaded 2 Not required
3 Not required
Combi
nation switch P 54.25-3854-31 neu209en_d2.boo Seite
102 Dienstag, 25. Mai 2004 7:26 19

150 Controls in detail
Good visibility
Foldin
gthe exteri ormirro rsin/o ut automatically
If this function
isactivated inthe operating
system ( =page 130):
! the exterior mirrors fol din automati-
cally as soon as you lock the vehicle
from the outside
! the exterior mirrors fol dout again auto-
matically as soon as you unlock the
vehicle and then open the driver's or
passenger door
i The mirrors do not fold outif they have been
fold edin manuall y. Parking aid*
To make parking easier, the exterior mirror
on the front-passenger side moves into the
parking position as soon as you engage
reverse gear.
This makes it possible for you
to observe the kerb on the front-passenger
side.
You can only make use of this parking aid
if the parking position for the exterior mir-
ror on the front-passenger side has been
stored using the memory function*
( = pag e98). The buttons are located on the dashboard
between the steering wheel and the
driver's door.
1 Right-hand mirror
2 Left-hand mirror
6 Make sure that the ignition is switched
on.
6 Make sure that theMirror adjustment
pa rking aid
function in theConven-
ie nce
submenu is switched on
(
= pa ge 130). P88.70-2142-31209en_d2.boo Seite
150 Dienstag, 25. Mai 2004 7:26 19

385
Practical advice
Fuses
The electrical fuses in your vehicle inter-
rupt the power supply to the equipment in
the event of a malfunction. This prevents
damage to the rest of the on-board
electri cs.
The following are available for changing
fuses ( =page 385):
! Fuse allocation chart
! Spare fuses
! Fuse extractor !
Only use fuses wi th thespec ifie d amperage
fo r the system inques tion, and which have been
ap proved for Mercede s-Be nz.Electrical parts or
sys tems could otherwise bedamaged.
Do not attempt to repair or bridge faul tyfuses.
Have the cause traced and recti fied at a qualified
specialist workshop, e.g. a Mercedes-Benz Serv-
ic e Centre.
The electrical fuses are located in different
fus eboxes:
! Main fuse box onthe left of the dash-
boa rd (
=page 386).
! Fuse box in the engine compartment
on the left (
=page 386).
! Fuse box in the boot on the left
(
= page 387). Fuse allocation chart
The fuse allocation chart is located in the
cover of the main fuse box on the dash-
board (
=page 386) .The amperage of the
fuses is also given there. Spare fuses
Spare fuses can be found in the vehicle
tool kit (=
page 276). Fuse extractor
Coupé
The fuse extractor can be found in the cov-
er of the fuse box
inthe boot (
=page 387).
Cabriolet
The fuse extractor can be found in the ve-
hicle tool kit ( =pa ge 276). Fuses
G
Riskof fire Only use fuses with the speci
fied amperage
for the system in question, and which have
be en approved for Mercedes-Be nz.Other-
wise, a short-circuit could occur, which
could cause afire. Changing fuses209en_d2.boo Seite
385 Dienstag, 25. Mai 2004 7:26 19

386 Practical advice
Fuses
The main fuse box is located behind the
light switch on the dashboard.
1 Cover Opening
6
Open the driver's door.
6 Insert a screwdri ver, or a similar tool
(arrow ).
6 Prise off cover 1with a sc rewdriver or
a similar implement.
6 Pull cover 1outwards. Closing
6
Hook on cover 1at the front.
6 Fold in cover 1until it engages.
The fuse box islocated in the engine com-
partment on the left-hand side. Opening
2 Cover
3 Rotary catch
4 Retainer 6
Turn rotary catches 3onequarter
turn ant i-cl ockwise.
6 Lift cover 2at the back, guide it side-
ways out of retainer 4and remove it
for wa rds.
5 Fuse box cover
6 Clamps Main fuse box
P 54
.15-2328-31 neu Fus
eboxinthe engine compartment P 54.15-2326-31 neu P 54.15-2325-31 neu209en_d2.boo Seite
386 Dienstag, 25. Mai 2004 7:26 19