236 Controls in detail
Featuresi
The distanc erequire dbe tween theportab le
garage door remot econtrol and the rear-view
mi rror depends on your garage door opening sys-
tem.
6 Keep one of the transmitter buttons
on the garage door remote control
pressed until indicator lamp 1flashes
rapi dly.
Pro gramming was successful ifindica-
to rla mp 1flashes rapidly.
If indicator lamp 1goes out after
approximately 20 seconds and did not
begin to flash rapidly:
6 Release the transmitter buttons on
the int egrate d and por tablere mote
controls.
6 Repeat the programming procedure
and alter the distance between the
po rtable garage doo rre mote con-
trol and the rear-view mirror.
6 Release the transm itter buttons on the
int egrated and portable remote con-
trols. i
If the garage door syst emworks with a roll-
ing code , youmust synchronise the remote con-
trol in the rear-view mirror with the garage door
syste m'sreceiver after you have programm ed
th ei ntegrated remote control.
You will find further information inthe operati ng
instructions for the garage door opening system,
e.g. the sections on "Sy nchronising the transmit-
ter" or "Regis tering a new transmitter". Opening
/closing the garage door
Once programmed, the integrated remote
control assumes the function of the garage
do or syste m's remote control. Please read
the Operating Instructions for the garage
doo rsystem.
6 Switch on the ignition.
6 Press the transmitter button in the
rear-view mirro rwhich you have pro-
grammed to operate this garage door.
Garage door system with a fixed code:
Indicator lamp 1lights up continu-
ously. Garage door system with a rolling code:
Indicator lamp
1flashes briefly and
then lights up for approximately two
seconds. This is repeated for up to
20 seconds.
i The transm itter transmits a signal for as long
as thetran sm itter button is pres sed.After ama x-
imum of 20 seconds the transmission is stopped
and indicator lamp 1flash es. Press the tra ns-
mitter button again if necessary. Cl
earing the re mote contr olmemory
6 Switch on the ignition.
6 Press and hold transmitter buttons 2
and 4for about 20 seconds until indi-
cator lamp 1flashes rapidly.
The memory is cleared.
i Clear the remote control memory before
selling the vehi cle. 209en_d2.boo Seite
236 Dienstag, 25. Mai 2004 7:26 19
