Page 257 of 376
257 Practical hints
What to do if …
Where will I find ...?
Unlocking/locking in an emergency
Opening/closing in an emergency
Replacing bulbs
Replacing wiper blades
Flat tire
Battery
Jump starting
Towing the vehicle
Fuses 
     
        
        Page 258 of 376

258 Practical hintsWhat to do if …
What to do if …Lamps in instrument clusterGeneral information:
If a bulb in the instrument cluster fails to 
come on during the bulb self-check when turning the SmartKey in the starter switch 
to position2, have it checked and replaced 
if necessary.Problem
Possible cause
Suggested solution
-
The yellow ABS malfunction 
indicator lamp comes on while 
driving.
The ABS has detected a malfunction and has 
switched off. The BAS and the ESP are also 
switched off (see messages in display).
The brake system is still functioning normally 
but without the ABS available.
Continue driving with added caution. 
Wheels may lock during hard braking, 
reducing steering capability. 
Have the system checked at an autho-
rized Mercedes-Benz Center as soon 
as possible.
Failure to follow these instructions 
increases the risk of an accident.
Read and observe messages in the 
display (
page 264).
The charging voltage has fallen below ten 
volts. The ABS has switched off.
When the voltage is above this value 
again, the ABS is operational again.
If necessary, have the generator 
(alternator) and battery checked. 
     
        
        Page 268 of 376
268 Practical hintsWhat to do if …Symbol messagesDisplay symbol
Display message
Possible cause
Possible solution
-
ABS SYSTEM
VISIT WORKSHOP!
The ABS has detected a malfunction and 
has switched off. The ESP and the BAS 
are also deactivated.
The brake system is still functioning 
normally but without the ABS available.
Continue driving with added caution. 
Wheels may lock during hard braking, 
reducing steering capability.
Have the system checked at an 
authorized Mercedes-Benz Center as 
soon as possible.
Failure to follow these instructions 
increases the risk of an accident.
DISPLAY MALFUNCTION
VISIT WORKSHOP!
The ABS or the ABS display is 
malfunctioning.
Continue driving with added caution. 
Wheels may lock during hard braking, 
reducing steering capability.
Have the system checked at an 
authorized Mercedes-Benz Center as 
soon as possible.
Failure to follow these instructions 
increases the risk of an accident. 
     
        
        Page 282 of 376

282 Practical hintsWhat to do if …Display symbol
Display message
Possible cause
Possible solution
1
RESTRAINT SYSTEM
DRIVE TO WORKSHOP!
The system is malfunctioning.
Drive with added caution to the 
nearest authorized Mercedes-Benz 
Center.
_
STEERING WHEEL ADJ.
LOCK!
The steering column is not properly 
locked.
Lock steering column (
page 38).
STEERING OIL
VISIT WORKSHOP!
The steering gear oil level is too low. 
There is a danger of steering gear 
damage.
Have the system checked by an 
authorized Mercedes-Benz Center.
Warning!
G
In the event a malfunction of the SRS is indi-
cated as outlined above, the SRS may not be 
operational. For your safety, we strongly 
recommend that you visit an authorized 
Mercedes-Benz Center immediately to have 
the system checked; otherwise the SRS may  
not be activated when needed in an 
accident, which could result in serious or 
fatal injury, or it might deploy unexpectedly 
and unnecessarily which could also result in 
injury.
Warning!
G
If the level of steering gear oil in reservoir is 
too low, the steering power assistance could 
fail. Much greater effort will then be needed 
to turn the steering wheel.
Do not add steering oil without checking the 
steering system.
Do not drive the vehicle. Have the system 
checked at your authorized Mercedes-Benz 
Center as soon as possible. 
     
        
        Page 285 of 376
285 Practical hints
Where will I find ...?
Spare wheel
The spare wheel is located under the trunk 
floor.
Removing the spare wheel
Lift trunk floor and engage handle in 
the upper edge of the trunk.
1Spare wheel
2Storage tray with vehicle tool kit
3Mounting screw for spare wheel/cover 
for vehicle tools
Turn the mounting screw3 counter-
clockwise.
Remove the spare wheel1.Storing the spare wheel
Place spare wheel1 in wheel well.
Turn mounting screw3 clockwise to 
its stop to secure the spare wheel.
Lower the trunk floor before closing the 
trunk lid.
Vehicle tool kit
The vehicle tool kit and air pump are stored 
in the wheel well below the trunk floor.
1Vehicle jack
2Air pump
3Alignment bolt
4Wheel wrench
5Towing eye bolt
6Spare wheel bolts 
     
        
        Page 286 of 376

286 Practical hintsWhere will I find ...?Vehicle jack
Remove the vehicle jack from the spare 
wheel well under the trunk floor.
Push the crank handle up.
Turn the crank handle clockwise until it 
engages (operational position).
Before storing the vehicle jack in its com-
partment:
It should be fully collapsed.
The handle must be folded in (storage 
position).
Warning!
G
The jack is designed exclusively for jacking 
up the vehicle at the jack take-up brackets 
built into both sides of the vehicle. To help 
avoid personal injury, use the jack only to lift 
the vehicle during a wheel change. Never 
get beneath the vehicle while it is supported 
by the jack. Keep hands and feet away from 
the area under the lifted vehicle. Always 
firmly set parking brake and block wheels 
before raising vehicle with jack.
Do not disengage parking brake while the 
vehicle is raised. Be certain that the jack is 
always vertical (plumb line) when in use, es-
pecially on hills. Always try to use the jack 
on level surface. make sure the jack arm is 
fully seated in the jack take-up bracket. Al-
ways lower the vehicle onto sufficient ca-
pacity jack stands before working under the 
vehicle. 
     
        
        Page 288 of 376
288 Practical hintsUnlocking/locking in an emergency
Unlocking/locking in an emergencyUnlocking the vehicle
If you are unable to unlock the vehicle with 
the SmartKey, open the driver’s door using 
the mechanical key.
The passenger door cannot be unlocked 
manually.
1Mechanical key locking tab
2Mechanical key
Move locking tab1 in direction of ar-
row and slide the mechanical key2 
out of the housing.Unlocking the driver’s door
3Unlocking
4Locking
Unlock the door with the mechanical 
key. To do so, push the mechanical key 
in the lock until it stops and turn it to 
the left.
iUnlocking your vehicle with the me-
chanical key will trigger the anti-theft 
alarm system. To cancel the alarm, do 
one of the following:
Press buttonŒ or ‹ on the 
SmartKey. 
Insert the SmartKey in the starter 
switch.  
     
        
        Page 289 of 376
289 Practical hints
Unlocking/locking in an emergency
Unlocking the trunk lid
If you are unable to unlock the trunk lid 
with the SmartKey, you can use the emer-
gency release on the inside of the trunk lid 
to unlock it. 
1Cover
2Release lever
3Rear bench seat backrest
Fold backrest3 forward.
Remove cover1 from the trim on the 
trunk lid.
Push release lever2 all the way to the 
right.
Open the trunk lid.
Locking the vehicle
If you are unable to lock the vehicle with 
the SmartKey, lock it with the mechanical 
key as follows:
Close the passenger door and the trunk 
lid.
Press the central locking switch in the 
cockpit (
page 88).
Check to see whether the locking knob 
on the passenger door is down. If nec-
essary push it down manually.
Lock the driver’s door with the me-
chanical key.
!The trunk lid swings open upwards au-
tomatically. Always make sure there is 
sufficient overhead clearance. A mini-
mum height clearance of 6.92 ft 
(2.11 m) is required to open the trunk 
lid.