2004 MERCEDES-BENZ C320 4MATIC WAGON wheel alignment

301 Practical hints
Where will I find ...?
3Vehicle tool kit
The following is included:

Towing eye bolt


Wheel wrench


Alignment bolt


Vehicle jack


Wheel bolts


Special fuse puller


Spare fusesVehicle jackThe vehicle jack is located in the storage
compartment behind the left trim panel.
Storage position
Remove vehicle jack from its
compartment.

Push crank handle up.
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface. Make sure the jack arm is
fully seated in the jack take-up bracket. Al-
ways lower the vehicle onto sufficient ca-
pacity jackstands before working under the
vehicle.

320 Practical hintsFlat tireThe jack take-up brackets are located
directly behind the front wheel housings
and in front of the rear wheel housings.
1Jack
2Take-up bracket
Place jack1 on firm ground.

Position jack1 under take-up
bracket2 so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an
incline.

Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while
vehicle is raised.Removing the wheel
1Alignment bolt

Unscrew upper-most wheel bolt and
remove.

Replace this wheel bolt with alignment
bolt1 supplied in the tool kit.

Remove the remaining bolts.

Remove the wheel.
Warning!
G
The jack is intended only for lifting the
vehicle briefly for wheel changes. It is not
suited for performing maintenance work
under the vehicle.

Never start the engine when the vehicle
is raised.


Never lie down under the raised vehicle.
!Do not place wheel bolts in sand or dirt.
This could result in damage to the bolts
and wheel hub threads.

321 Practical hints
Flat tire
Mounting the new wheel
1Wheel bolt for light alloy rims
2Wheel bolt for Minispare wheel or other
steel rims (located in vehicle tool kit)
Clean contact surfaces of wheel and
wheel hub.

Guide Minispare wheel onto alignment
bolt and push it on.

Insert wheel bolts and tighten them
slightly.
!Wheel bolts2 must be used when
mounting the Minispare wheel or other
steel rims. The use of any wheel bolts
other than wheel bolts2 for the
Minispare wheel or other steel rims will
physically damage the vehicle’s
brakes.
!To avoid paint damage, place wheel flat
against hub and hold it there while
installing first wheel bolt.Warning!
G
Always replace wheel bolts that are
damaged or rusted.
Never apply oil or grease to wheel bolts.
Damaged wheel hub threads should be
repaired immediately. Do not continue to
drive under these circumstances! Contact
an authorized Mercedes-Benz Center or call
Roadside Assistance.
Incorrect wheel bolts or improperly tight-
ened wheel bolts can cause the wheel to
come off. This could cause an accident.
Make sure to use the correct mounting
bolts.

322 Practical hintsFlat tire
Unscrew the alignment bolt, install last
wheel bolt and tighten slightly.Lowering the vehicle

Lower vehicle by turning crank
counterclockwise until vehicle is
resting fully on its own weight.

Remove the jack.
1 - 5Wheel bolts

Tighten the five wheel bolts evenly,
following the diagonal sequence
illustrated (1to5), until all bolts are
tight. Observe a tightening torque
of 80 lb-ft (110 Nm).Before storing the jack, it should be fully
collapsed, with handle folded in (storage
position) (
page 301).

Store the jack and the other vehicle
tools in the storage compartment be-
hind the left trim panel (
page 301).

Store the wheel cover (Canada only)
and the damaged wheel in the cargo
compartment.
Warning!
G
Only use genuine equipment
Mercedes-Benz wheel bolts. Other wheel
bolts may come loose.
Do not tighten the wheel bolts when the
vehicle is raised. Otherwise the vehicle
could tip over.
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque
of 80 lb-ft (110 Nm).

357 Technical terms
ABS
(A
ntilock B
rake S
ystem)
Prevents the wheels from locking up
during braking so that the vehicle can
continue to be steered.
Alignment bolt
Metal pin with thread. The centering
pin is an aid used when changing a tire
to align the wheel with the wheel hub.
BabySmart
TM1
airbag deactivation
system
This system detects if a special system
compatible child restraint seat is
installed on the front passenger seat.
The system will automatically deacti-
vate the passenger front airbag when
such a seat is properly installed
(PASS. AIRBAG OFF indicator lamp
located in the center console comes
on). See your authorized
Mercedes-Benz Center for availability.BabySmart
TM compatible child seats
Special restraint system for children.
The sensor system for the passenger
seat prevents deployment of the
passenger front airbag if a
BabySmartTM compatible child seat is
installed.
BAS
(B
rake A
ssist S
ystem)
System for potentially reducing braking
distances in emergency braking
situations. The system is activated
when it senses an emergency based on
how fast the brake is applied.
Bi-Xenon headlamps*
Headlamps which use an electric arc as
the light source and produce a more
intense light than filament headlamps.
Bi-Xenon headlamps produce low
beam and high beam.CAC
(C
ustomer A
ssistance C
enter)
Mercedes-Benz customer service
center, which can help you with any
questions about your vehicle and
provide assistance in the event of a
breakdown.
CAN system
(C
ontroller A
rea N
etwork)
Data bus network serving to control
vehicle functions such as door locking
or windshield wiping depending on
vehicle settings and/or ambient
conditions.
Cockpit
All instruments, switches, buttons and
indicator/warning lamps in the
passenger compartment needed for
vehicle operation and monitoring.
1BabySmart
TM is a trademark of Siemens
Automotive Corp.

364 Index
Seats 32, 33
Steering column height 38
Steering column length 38
Steering wheel 36
Air conditioning (cooling)
Turning off 156, 166
Turning on 156, 166
Air conditioning refrigerant 348
Air distribution
Adjusting 153, 162
Air pressure see Tire inflation pressure
Air recirculation mode 154, 163
Activating 154, 163
Deactivating 155, 164
Air vents, rear passenger compartment
Adjustable 157, 168
Air volume
Adjusting 153, 162Airbags 57
BabySmart
TM deactivation
system 68
Children 58
Front 61
Passenger 61
Side impact 62
Window curtain 62
Alarm
Audible 73, 81
Canceling 81
Visual 80
Alarm system
Anti-theft 80
Alignment bolt 357
Alignment bolt (vehicle tool kit) 320
Anticorrosion/antifreeze 353
Antiglare
Automatic 146
Manual 146
Antilock brake system (ABS) 357Anti-theft alarm system
Arming 80
Canceling alarm 81
Disarming 81
Anti-theft systems 80
Anti-theft alarm system* 80
Immobilizer 80
Tow-away alarm 81
Aquaplaning see Hydroplaning
Armrest
Storage compartment in front of 217
Storage spaces 218
Ashtray 219
ATF (automatic transmission fluid) 256
AUDIO menu 116
Selecting radio station 117
Audio system 169
Audio and telephone, operation 169
Button and soft key operation 172
Cassette operation 182
CD operation 185
Operating and display elements 170

390 IndexVehicle battery 324
Vehicle care 267
Cloth upholstery 272
Cup holder 271
Engine cleaning 269
Gear selector lever 271
Hard plastic trim items 271
Headlamps 269
Instrument cluster 270
Leather upholstery 271
Light alloy wheels 270
MB Tex upholstery 272
Ornamental moldings 269
Paintwork 268
Plastic and rubber parts 272
Power washer 268
Seat belts 271
Side markers 269
Steering wheel 271Tail lamps 269
Tar stains 268
Turn signals 269
Upholstery 271
Vehicle washing 269
Window cleaning 270
Wiper blades 270
Wood trims 272
Vehicle identification number (VIN) 338
Vehicle jack 301
Vehicle lighting
Checking 251
Vehicle tool kit 300
Alignment bolt 301
Spare fuses 301
Special fuse puller 301
Towing eye bolt 301
Vehicle jack 301
Wheel bolts 301
Wheel wrench 301Vehicle washing 269
Ventilated storage compartment 156
Ventilation
Storage compartment 156
VIN (Vehicle Identification Number) 361
VIN (vehicle identification number) 338
Viscosity
Engine oil 358
Voice control system*
Hands-free microphone 27
W
Warning sounds
Drivers seat belts 62
Parking brake 45
Warranty coverage 337
Washer fluid see Windshield washer fluid
Washing the vehicle 267
Wear pattern (tires) 262
Weights 345