2004 MAZDA MODEL MPV ECU

7-7
In Case of an Emergency
Flat Tire
Form No. 8S06-EA-03H
8. Rotate the small lever on top of the
retaining plate and pull the retaining
plate out from the center hole of the tire.
To secure the spare tire
1. Place the tire with the outer side facing
upward, rotate the small lever on top of
the retaining plate and slide the
retaining plate through the center hole
of the tire.
Rotate the small lever into place.2. Raise the spare tire slowly in reverse
order of removal.
NOTE
A flat tire which has been removed
from the vehicle for repair cannot be
carried in the spare tire carrier. Secure
the flat tire with the tire clamp and
wing nut in the luggage compartment
(page 7-12).
Retaining
plate
Retaining
plate
Retaining
plate
Lever
Spare tire
Carrier Placement for the Specialized
Temporary Spare Tire:
Placing the specialized temporary
spare tire in the spare tire carrier
wrong side up or using any tire other
than the small temporary spare tire
designed for use with this vehicle is
dangerous. It will result in poor
attachment and insufficient ground
clearance in the spare tire carrier and
the danger of the tire falling off. This
could result in someone being badly
injured or even killed.
Place the specialized temporary spare
tire in the spare tire carrier correctly.
Applying excessive lateral force while
the spare tire lever is attached may
result in damage to the socket.
NOTE
Unless the cable is rolled up
completely, the spare tire lever cannot
be removed from the socket.
WARNING
CAUTION
J16R_8S06-EA-03H_Edition1.book Page 7 Wednesday, July 9, 2003 4:19 PM

7-13
In Case of an Emergency
Flat Tire
Form No. 8S06-EA-03H
4. Turn the lug wrench counterclockwise
and lower the vehicle. Use the lug
wrench to tighten the nuts in the order
shown.
If you’re unsure of how tight the nuts
should be, have them inspected at an
Authorized Mazda Dealer.
Nut tightening torque:
5. Put the flat tire in the special vinyl bag
and tie it at the top.
N·m (kgf·m, ft·lbf)108—147
(11—15, 80—108)
Loose Lug Nuts:
Improperly or loosely tightened lug
nuts are dangerous. The wheel could
wobble or come off. This could result
in loss of vehicle control and cause a
serious accident. Always securely and
correctly tighten the lug nuts.
Metric Studs and Lug Nuts:
Because the wheel studs and lug nuts
on your Mazda have metric threads,
using a non-metric nut is dangerous.
On a metric stud, it would not secure
the wheel and would damage the stud,
which could cause the wheel to slip
off and cause an accident. Be sure to
reinstall the same nuts you removed
or replace them with metric nuts of
the same configuration.
Incorrect Tire Air Pressure:
Driving on tires with incorrect air
pressure is dangerous. Tires with
incorrect pressure could affect
handling and result in an accident.
Don’t drive with any tires that have
incorrect air pressure. When you
check the regular tires’ air pressure,
check the spare tire, too.
WARNING
J16R_8S06-EA-03H_Edition1.book Page 13 Wednesday, July 9, 2003 4:19 PM

7-14
In Case of an Emergency
Flat Tire
Form No. 8S06-EA-03H
6. With the tire facing outward, punch a
hole through the vinyl bag and the
center hole, using the flat tire securing
bolt.
7. Lift the anchor clip on the back of
third-row seat.8. Install the flat tire with the tire securing
bolt hooked in the anchor clip as shown
below.
9. Secure the flat tire with the tire clamp
and wing nut as shown below.
Have the damaged tire repaired or
replaced as soon as possible.
Flat tire securing bolt
NOTE
•If the tire rattles even through the
wing nut is tightened, reverse the
tire clamp and retighten the wing
nut.
•To prevent the jack and tool from
rattling, store them properly.
Tire clamp
Wing nut
J16R_8S06-EA-03H_Edition1.book Page 14 Wednesday, July 9, 2003 4:19 PM

8-11
Maintenance and Care
Owner Maintenance
Form No. 8S06-EA-03H

Changing Engine Oil and Filter
Change engine oil and filter according to
Scheduled Maintenance (page 8-3).
Please act responsibly—protect the
environment and take used oil to a
recycling facility. Ask your dealer or a
service station for information.
Changing engine oil
1. Warm up the engine for a few minutes
and turn it off. Remove the oil-filler
cap.2. Remove the drain plug and drain the oil
into a suitable container.
3. Replace the plug tightly after the oil
has thoroughly drained.
4. Fill the engine with new oil to the
MAX mark on the dipstick.
5. Securely reinstall the oil-filler cap.
6. Start the engine and inspect around the
drain plug for leaks.
7. Turn it off and wait 5 minutes for the
oil to return to the oil pan.
Check the oil level and fill to the MAX
mark if necessary.
Oil capacity (General reference only,
refer to Specifications section for
capacities.)
Handling Used Engine Oil:
Continuous contact with used engine
oil is dangerous. It could cause skin
cancer. Always wash with soap and
water immediately after changing oil
and filter.
Remove any oil splatter from the
exhaust manifold, the exhaust pipe and
the shield. Oil left on these areas will
smoke when the engine is running.
Checking or Changing Engine Oil:
Hot engine oil is dangerous. If the
engine has been running, the engine
oil becomes very hot. You could be
seriously burned. Don’t check or
change the engine oil when the
engine is hot.
WARNING
CAUTION
WARNING
NOTE
•The indicated engine oil capacities
are for general reference purposes
only. When adding or changing oil,
verify the engine oil level with the
oil dipstick.
•Use only specified engine oil (page
10-4).
Tighten
Loosen
Front
Drain plug
J16R_8S06-EA-03H_Edition1.book Page 11 Wednesday, July 9, 2003 4:19 PM

8-26
Maintenance and Care
Owner Maintenance
Form No. 8S06-EA-03H

Battery Maintenance
To get the best service from a battery:
•Keep it securely mounted.
•Keep the top clean and dry.
•Keep terminals and connections clean,
tight, and coated with petroleum jelly
or terminal grease.
•Rinse off spilled electrolyte
immediately with a solution of water
and baking soda.
•If the vehicle will not be used for an
extended time, disconnect the battery
cables.

Inspecting Electrolyte Level
A low level of electrolyte fluid will cause
the battery to discharge quickly.
Inspect the electrolyte level at least once a
week. If it’s low, remove the cap and add
enough distilled water to bring the level
between the upper and lower level
(illustration).
Don’t overfill.

Examine the specific gravity of the
electrolyte with a hydrometer, especially
during cold weather. If it’s low, recharge
the battery.
Upper level
Lower level
J16R_8S06-EA-03H_Edition1.book Page 26 Wednesday, July 9, 2003 4:19 PM

8-36
Maintenance and Care
Owner Maintenance
Form No. 8S06-EA-03H
License plate lights
1. Slide the unit as shown in the figure to
remove it.
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order
of removal.

Replacing Interior Light Bulbs
Overhead light/Map lights
1. Wrap a small flathead screwdriver with
a soft cloth to prevent damage to the
lens and remove the lens by carefully
prying on the edge of the lens with the
screwdriver.
2. Disconnect the bulb by pulling it out.
NOTE
An unsecured high-mount brake light
will allow water to leak into the
vehicle. Make sure the high-mount
brake light is tightly fastened to the
vehicle and if water still leaks, consult
an Authorized Mazda Dealer.
Edge
Without sunroof, with overhead console
Edge
Without either sunroof or overhead
console
J16R_8S06-EA-03H_Edition1.book Page 36 Wednesday, July 9, 2003 4:19 PM

11-2
Form No. 8S06-EA-03H
Index
A
Accessory Socket ............................. 6-52
Add-On Non-Genuine Parts and
Accessories
...................................... 9-13
Air Bag Systems
.............................. 2-56
Air Filter
.......................................... 8-19
Antenna
............................................ 6-14
Anti-Lock Brake System (ABS)
........ 5-7
Warning light
.............................. 5-8
Appearance Care
.............................. 8-43
Ashtray
............................................. 6-45
Audio System
................................... 6-14
Audio control switch
................ 6-38
Audio set
................................... 6-21
Operating tips for
audio system
............................. 6-14
Safety certification
.................... 6-40
Automatic Transaxle
Driving tips
............................... 5-13
Fluid
.......................................... 8-16
Overdrive
.................................. 5-12
Shift-lock override
.................... 5-12
Shift-lock system
...................... 5-11
Transaxle ranges
....................... 5-10
B
Battery
Emergency starting
................... 7-17
Maintenance
............................. 8-24
Specifications
........................... 10-4
Beep Sounds
Ignition key reminder
............... 5-33
Lights-on reminder
................... 5-33
Power sliding door beep
........... 5-33
Seat belt warning beep
.............. 5-33
Before Starting the Engine
................. 4-6
After getting in
........................... 4-6
Before getting in
......................... 4-6
B
Body Lubrication ............................. 8-19
Bottle Holder
.................................... 6-48
Brake
Fluid
.......................................... 8-15
Brakes
Anti-lock brake system (ABS)
....5-7
Foot brake
................................... 5-4
Pad wear indicator
...................... 5-8
Parking brake
.............................. 5-5
Warning light
.............................. 5-6
Break-In Period
.................................. 4-7
Bulb Replacement
............................ 8-31
C
Capacities ......................................... 10-5
Carbon Monoxide
.............................. 4-5
Cargo Securing Loops
...................... 6-51
Catalytic Converter
............................ 4-3
Cell Phones
...................................... 9-14
Child Restraint
Child restraint precautions
........ 2-41
Installing child-restraint
systems
...................................... 2-45
LATCH child-restraint
systems
...................................... 2-53
Child Safety Locks for Rear
Doors
................................................ 3-12
Cigarette Lighter
.............................. 6-44
Climate Control System
.....................6-2
Gas specifications
..................... 10-5
Courtesy Lights
................................ 6-44
Cruise Control
.................................. 5-14
Cup Holder
....................................... 6-46
Customer Assistance
.......................... 9-2
J16R_8S06-EA-03H_Edition1.book Page 2 Wednesday, July 9, 2003 4:19 PM

11-4
Index
Form No. 8S06-EA-03H
H
Hazard Warning Flasher .................. 5-39
Hazardous Driving
............................. 4-8
Headlights
Control
...................................... 5-34
Flashing
.................................... 5-34
High-low beam
......................... 5-34
On reminder
.............................. 5-34
Hood Release
................................... 3-24
Horn
................................................. 5-39
I
Ignition
Keys
............................................ 3-2
Switch
......................................... 5-2
Illuminated Entry System
................ 6-42
Immobilizer System
......................... 3-28
Indicator Lights
................................ 5-24
Cruise Main
.............................. 5-32
Cruise set
.................................. 5-32
Headlight high-beam
................ 5-31
O/D OFF
................................... 5-31
Security
..................................... 5-30
Shift position
............................ 5-31
TCS
........................................... 5-31
TCS OFF
.................................. 5-32
Turn-signal/hazard warning
...... 5-32
Instrument Cluster
........................... 5-20
Interior Care
..................................... 8-48
Interior Lights
.................................. 6-42
J
Jump-Starting ................................... 7-18
K
Keyless Entry System ........................ 3-3
Keys
................................................... 3-2
L
Label Information ............................ 10-2
Lane-Change Signals
....................... 5-35
Liftgate
............................................. 3-18
Light Bulbs
Replacement
.............................. 8-31
Specifications
............................ 10-6
Lighter
.............................................. 6-44
Lighting Control
............................... 5-34
Lubricant Quality
............................. 10-4
Luggage Compartment Light
........... 6-44
M
Maintenance
Introduction
................................. 8-2
Owner maintenance
precautions
.................................. 8-8
Owner maintenance schedule
..... 8-7
Scheduled
.................................... 8-3
Map Lights
....................................... 6-43
Meters and Gauges
........................... 5-20
Mirrors
Outside mirrors
......................... 3-33
Rearview mirror
........................ 3-34
Money-Saving Suggestions
................ 4-7
J16R_8S06-EA-03H_Edition1.book Page 4 Wednesday, July 9, 2003 4:19 PM