2004 JEEP WRANGLER Owners Manual

Tuck the top between the 2 bow and the 3 bow as it folds. 14. Tuck the top between the 2 bow and the header.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 89
3

15. After the top is folded down, ensure that the drip rail
retainers are tucked in inward as shown. This is to avoid
unnecessary wear to the fabric.16. After the top is folded down, the check straps must
be wrapped around the header. This will keep them from
hanging and flapping outside the vehicle.
90 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Putting Up The Soft Top
NOTE:
Be sure the wire harness is not attached to the
soft top bows before you lift the top.
1. Slide Sunrider sleeve towards header to cover Sun-
rider link (Unlimited Models Only).
2. Begin working from the rear of the vehicle, with the
tailgate open. Lift the plastic header (with latches) up and
over the sport bar. As the header reaches the top, locate
the 2 bow and push it up and over the sport bar.3. Move to the side of the vehicle and pull the side bow
forward and down. Be sure the check straps are not
tangled around the 2 bow. You will see the 3 bow rise
from the rear of the vehicle.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 91
3

4. Unclip and move the sun visor to the side. 5. Open the header latches and engage the hook on each
side into the windshield slot.
92 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

6. Guide side bows down into bracket on door rails.
Make sure door rail Sunrider pins engage into bracket on
side bows (Unlimited Models Only).
7. Grasp the drip rail retainer and untuck them from the
door frame.
NOTE:Do not tuck the drip rails into the door frame at
this time.8. Move to the rear of the vehicle and gently pull the sail
panels over the 3 bow. Let them hang down over the
sport bar.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 93
3

9. Tuck the sail panel retainer into the bodyside retainer.
Begin working from the rear tailgate opening and work
to the corner.NOTE:This may be difficult to do the first time. If
difficulty is experienced with fabric tension, place your
hand on top of the 3 bow and push down to help tuck in
the sail panels.
94 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

10. To install the quarter windows, affix the rear corner
of the window temporarily. Now, zip the zipper only
about 1 inch (2.5 cm).At this time it is necessary to tuck
in the door frame retainer.11. After the door frame retainer has been completely
tucked in, finish zipping in the window. Then affix the
Velcrotflaps around the window.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 95
3

12. Tuck the bottom retainers on the quarter window into
the bodyside retainer, beginning from the rear and work-
ing to the front of the vehicle. Repeat this step for the
other side.13. Zip in rear window beginning from the left using
both zipper ends. Leave one zipper end at the start.
96 UNDERSTANDING THE FEATURES OF YOUR VEHICLE