2004 JEEP LIBERTY wheel alignment

NShifting Procedure....................230
mTrac-LokŸ Rear Axle Ð If Equipped.........231
mParking Brake.........................232
mAnti-Lock Brake System Ð If Equipped.......234
mOn-Road Driving Tips...................236
mOff-Road Driving Tips...................236
NWhen To Use 4L Or 4 Lo (Low) Range......236
NIn Snow, Mud And Sand................237
NHill Climbing........................237
NTraction Downhill.....................238
NAfter Driving Off-Road.................238
mTire Safety Information...................239
NTire Markings........................239NTire Identification Number (TIN)..........243
NTire Loading And Tire Pressure...........244
mTires Ð General Information...............248
NTire Inflation Pressures.................249
NHigh Speed Operation.................250
NRadial-Ply Tires......................251
NTire Spinning........................251
NTread Wear Indicators..................252
NReplacement Tires.....................252
NAlignment And Balance.................253
mTire Pressure Monitor System Ð If Equipped . . . 254
NTire Pressure Monitor System Tire/Wheel
Rotation And Sensor Replacement
Ð If Equipped.......................256
208 STARTING AND OPERATING

NOTE:Shifting into or out of 4L is possible with the
vehicle completely stopped, however difficulty may oc-
cur due to the mating clutch teeth not being properly
aligned. Several attempts may be required for clutch
teeth alignment and shift completion to occur. The pre-
ferred method is with the vehicle rolling 2 to 3 mph (3 to
5 km/h). Avoid attempting to engage or disengage 4L
with the vehicle moving faster than 2 to 3 mph (3 to 5
km/h).
Selec-TracTOperating Information/Precautions Ð
If Equipped
The Selec-Tracttransfer case provides 5 mode positions -
normal 2-wheel drive mode, part-time 4-wheel drive
high range, full-time 4-wheel drive high range, neutral,
and 4-wheel drive low range.
This transfer case is equipped with an inter-axle differ-
ential which allows driving the vehicle in the 4 FULL
TIME position at all times on any given road surfaceincluding dry hard surfaced roads. The 4 FULL TIME
mode allows the front and rear wheels to rotate at
different speeds which eliminates driveline binding and
component wear that is normally associated with driving
the vehicle in the 4 PART TIME position on dry hard
surfaced roads. This feature provides the safety, security,
and convenience of operating in 4±wheel drive at all
times regardless of road conditions.
When additional traction is required the 4 PART TIME
and 4LO positions can be used to lock the front and rear
driveshafts together through the transfer case inter-axle
differential and force the front and rear driveshafts to
rotate at the same speed. This is accomplished by simply
moving the shift lever to these positions. The 4 PART
TIME and 4LO positions are intended for loose, slippery
road surfaces only. Driving in the 4 PART TIME and 4LO
positions on dry hard surfaced roads may cause in-
creased tire wear and damage to driveline components.
226 STARTING AND OPERATING

rearward into 4LO. In 4 FULL TIME, there is a neutral
stop to prevent shifting into N (Neutral) by accident.
NOTE:Pausing in transfer case N (Neutral) in vehicles
equipped with an automatic transmission may require
shutting the engine OFF to avoid gear clash while
completing the shift. If difficulty occurs, shift transmis-
sion to N (Neutral), hold foot on brake, and turn engine
OFF. Make shift to desired mode.
NOTE:Shifting into or out of 4LO is possible with the
vehicle completely stopped, however difficulty may oc-
cur due to the mating clutch teeth not being properly
aligned. Several attempts may be required for clutch
teeth alignment and shift completion to occur. The pre-
ferred method is with the vehicle rolling 2 to 3 mph (3 to
5 km/h). Avoid attempting to engage or disengage 4LO
with the vehicle moving faster than 2 to 3 mph (3 to 5
km/h).TRAC-LOKŸ REAR AXLE Ð IF EQUIPPED
The optional Trac-LokŸ rear axle provides a constant
driving force to both rear wheels and reduces wheel spin
caused by the loss of traction at one driving wheel. If
traction differs between the two rear wheels, the differ-
ential automatically proportions the usable torque by
providing more torque to the wheel that has traction.
Trac-LokŸ is especially helpful during slippery driving
conditions. With both rear wheels on a slippery surface, a
slight application of the accelerator will supply maxi-
mum traction. When starting with only one rear wheel on
an excessively slippery surface, slight application of the
parking brake may be necessary to gain maximum trac-
tion.
STARTING AND OPERATING 231
5

WARNING!
²Do not use a tire, wheel size or rating other than that
specified for your vehicle. Some combinations of unap-
proved tires and wheels may change suspension dimen-
sions and performance characteristics, resulting in
changes to steering, handling, and braking of your
vehicle. This can cause unpredictable handling and
stress to steering and suspension components. You
could lose control and have an accident resulting in
serious injury or death. Use only the tire and wheel
sizes with load ratings approved for your vehicle.
²Never use a tire smaller than the minimum tire size
listed on your vehicle's tire label. Using a smaller tire
could result in tire overloading and failure. You could
lose control and have an accident.
²Failure to equip your vehicle with tires having adequate
speed capability can result in sudden tire failure and
loss of vehicle control.
²Overloading your tires is dangerous. Overloading can
cause tire failure. Use tires of the recommended load
capacity for your vehicle - never overload them.
CAUTION!
Replacing original tires with tires of a different size
may result in false speedometer and odometer read-
ings. Check with your dealer before replacing tires
with a different size.
Alignment and Balance
The suspension components of your vehicle should be
inspected and aligned when needed, to obtain maximum
tire tread life.
Poor suspension alignment may result in:
²reduced tread life;
²uneven tire wear, such as feathering and one-sided
wear;
²vehicle pull to the right or to the left.
STARTING AND OPERATING 253
5

Tires may also cause the vehicle to pull left or right.
Alignment will not correct this problem. See your dealer
for proper diagnosis of the problem.
Improper alignment will not normally cause vehicle
vibration, which may be a result of tire and wheel
out-of-balance. Proper balancing will reduce vibration
and avoid tire cupping and spotty wear.
TIRE PRESSURE MONITOR SYSTEM Ð IF
EQUIPPED
The Tire Pressure Monitor System (TPM) monitors the
pressure in all 4 road tires and the full size spare. The
TPM system uses wireless technology to monitor tire
pressure levels. Sensors, mounted to each wheel as part
of the valve stem, transmit tire pressure readings to a
receiver located in the overhead console. The tire pres-
sure status is shown in the Electronic Vehicle Information
Center (EVIC) display. Refer to ªOverhead Consoleº inSection 3 for more information. The TPM system func-
tions even when the EVIC is not set on the tire pressure
display screen.
The TPM system informs you of a low or high tire
pressure condition. If this occurs, correct your tire infla-
tion pressure as soon as possible, and inspect all of your
tires. Be sure to use a high quality gauge when adjusting
pressure. The TPM system is designed to monitor your
tire pressure but will not function as a tire pressure
gauge. There will be a delay between the instant you
adjust the air pressure in a tire and when the system
updates the display. The TPM system is not intended to
provide you with notification of rapid air loss.
254 STARTING AND OPERATING

Steering
Power.............................. 300
Wheel Lock........................... 17
Wheel, Tilt........................... 107
Steering Wheel Mounted Sound System
Controls............................. 194
Storage............................... 324
Storage, Vehicle......................... 324
Storing Your Vehicle...................... 324
Sun Roof.............................. 130
Sunroof Maintenance..................... 132
Supplemental Restraint System - Airbag........ 46
Swing Gate, Rear......................... 29
Tachometer............................ 151
Tape Player............................ 178
Temperature Gauge, Engine Coolant.......... 153
Tether Anchor, Child Restraint............... 62
Theft System Arming...................... 28Theft System Disarming.................... 28
Tie Down Hooks, Cargo................... 138
Tilt Steering Column..................... 107
Timing Belt............................ 297
Tire and Loading Information Placard......... 244
Tire Identification Number (TIN)............. 243
Tire Markings.......................... 239
Tire Safety Information.................... 239
Tires ................................. 248
Air Pressure.......................... 249
Alignment and Balance.................. 253
Chains.............................. 257
Changing.........................274,275
Flat Changing........................ 274
General Information.................... 248
High Speed.......................... 250
Inflation Pressures..................... 249
Jacking............................. 276
Load Capacity.....................244,245
372 INDEX

Unleaded Gasoline....................... 259
Upholstery Care........................ 317
Vacuum/Vapor Harnesses................. 307
Vanity Mirrors........................... 78
Variance, Compass....................... 123
Vehicle Identification Number................ 7
Vehicle Loading......................... 245
Vehicle Modifications/Alterations.............. 8
Vehicle Storage......................... 324
Vinyl Trim............................. 317
Warning Flasher, Hazard.................. 272
Warning Lights (Instrument Cluster Description) . 151
Warnings and Cautions..................... 7
Warranty Information..................... 351Washer, Adding Fluid..................... 204
Washers, Windshield..................105,302
Washing Vehicle......................... 316
Waxing and Polishing..................... 316
Wheel Alignment and Balance............... 253
Wheel Mounting........................ 277
Wheel Nut Torque....................... 278
Wind Buffeting.......................... 34
Window Fogging........................ 203
Windows.............................. 32
Power............................... 32
Windshield Washers...................... 105
Fluid............................... 302
Windshield Wiper Blades.................. 301
Windshield Wipers....................... 106
Wipers, Intermittent...................... 107
374 INDEX