2004 JAGUAR XJ Fuse boxes

Roadside Emergency
Inertia Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 3
Trunk Underfloor Access . . . . . . . . . . . . . . . . . . 6 - 4
Emergency Starting . . . . . . . . . . . . . . . . . . . . . . . 6 - 4
Wheel Changing and Jacking . . . . . . . . . . . . . . . . 6 - 6
Vehicle Recovery . . . . . . . . . . . . . . . . . . . . . . . 6 - 11
Bulb Renewal . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 14
Fire Extinguisher . . . . . . . . . . . . . . . . . . . . . . . . 6 - 20
Fuses and Fuse Boxes . . . . . . . . . . . . . . . . . . . . 6 - 21

Roadside Emergency 6 - 21
Fuses and Fuse Boxes
Do not fit a new fuse if the wiring is
damaged; contact a Jaguar Retailer.
After renewing a fuse have the circuit
checked by a Jaguar Retailer.
Two types of fuses are fitted in the fuse
boxes, ATO type and Midi type.
Spare fuses and a special tool for
removing and replacing fuses are located
on a removable panel clipped to the rear
of the trunk ( A).
Use only the spare fuses supplied. If a
spare fuse is used, renew it with a Jaguar
approved fuse of the same amperage
rating.
Checking and Renewing a
Blown Fuse
Make sure the new fuse is the correct
rating (amperage).
Fuses are colour coded according to the
amperage and the rating is also marked
on each fuse.
Caution: When a fuse box lid is
removed, take care to protect the box
from moisture, and refit the lid at the
earliest opportunity. ATO-fuse replacement
Push the tool on to the suspect ATO fuse
and withdraw the fuse. If the wire in the
fuse is broken, the fuse has blown.
Fit a new fuse using the tool.
Midi fuse replacement
(not shown)
Unscrew the two nuts and remove the
fuse. Note that the fuse is supplied
directly from the battery +ve; take care
not to short a spanner or other metal tool
to the chassis when removing the nuts.!WARNING:
1. Do not fit a fuse of a different amperage from that removed.
The electrical circuits may
become overloaded with the
subsequent possibility of a fire.
2. No attempt should be made to repair a fuse that has blown as this
may cause a fire hazard or serious
damage elsewhere in the
electrical circuit.

6 - 22 Roadside Emergency
Fuse Box Locations
There are three separate fuse boxes fitted
to the vehicle, each one containing fuses
protecting a different group of circuits.
Engine compartment fuse box
The fuse box is located in the engine
compartment on the right-hand side
adjacent to the windscreen wash
reservoir.
Remove the fuse box lid by pressing the
spring catch and lifting.
When refitting, press the fuse box lid in
the area of the retaining lugs until the lid
engages. Cabin fuse box
The cabin fuse box is located behind the
right-hand side trim panel in the footwell.
To access the fuse box, pull out the
bottom of the trim panel (arrowed), slide
the panel down slightly and remove.
Trunk fuse box
A fuse box is located in the trunk,
situated behind the battery.
Open the trunk floor panel to gain access
to the fuse box.
Remove the fuse box lid by pulling the
retaining clips and pulling the lid
upwards.
Reposition the lid and press down until
the retaining clips engage.
Replace the floor panel.

7-24 Maintenance
Cleaning the rear screen
To avoid damaging the heating and radio
elements when cleaning the inside of the
rear screen use only a soft damp cloth or
chamois leather. Do not use solvents or
sharp objects to clean the glass.
Polishing paintwork and brightwork
For maximum protection against road
dust, salts, industrial fall-out etc., it is
recommended that the vehicle is polished
regularly using Jaguar Polish and a
Polishing Cloth.
Note:The vehicle’s brightwork should be
cleaned in the same way as the paintwork:
Chrome polish or other abrasive cleaners
must not be used. Paint chips
Scratches and chips should be touched in
before weathering action begins. Inspect
the paintwork imme
diately after the
vehicle has been washed.
Underhood cleaning
Underhood cleaning using high pressure
hoses or steam cleaners should be done
by a Jaguar Retailer. Indiscriminate use of
cleaning equipment could damage or
contaminate the electronic control
modules and fuse boxes.Care of Alloy Road Wheels
The alloy road wheels are covered with a
protective anti-corrosion coating.
To prevent corrosion it is essential that
this coating is not damaged.
When removing or fitting tyres always
advise the tyre fitte r to treat the alloy
wheels with great care and to only use
equipment with spigot or stud hole
clamping. The equipment must not have
any moving parts which contact the
wheel, and tyre levers must not be used.
Wash the wheels with soap and water at
two week intervals to avoid an
accumulation of particles which could
become embedded in the wheel surface.
In salty conditions the wheels should be
cleaned weekly.

Index
Dimmer switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 25
Direction indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 26
Door window operation . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 29
Dynamic stability control (DSC) . . . . . . . . . . . . . . . . . . . . 4 - 46
E
Earth points . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 25
Electrical accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 25
Electronic road toll systems . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9
Emergency brake assist . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 48
Emergency starting
– using jump leads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 4
Engine
– anti-freeze . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 11
– block heater . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 11
– coolant level check . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 11
– oil level check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 6
– temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 4
Entry/exit mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 7
Exterior care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 23
Exterior lighting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 23
FFire extinguisher . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 20
First aid kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 61
Floor mat retention . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 10
Foreign travel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 61
Front and rear park distance control . . . . . . . . . . . . . . . . 4 - 36
Fuel and refuelling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 63
– catalytic converters . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 68
– filler flap manual release . . . . . . . . . . . . . . . . . . . . . . . 4 - 66
– fuel economy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 65
– level gauge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 3
– requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 64
– tank capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 65
– tank filling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 63
– unleaded fuel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 66
Fuses and fuse boxes
– cabin fuse box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 26
– checking and renewing a blown fuse . . . . . . . . . . . . . . 6 - 21
– engine compartment fuse box . . . . . . . . . . . . . . . . . . . 6 - 24
– fuse box locations . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 22
– fuse positions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 23
– trunk fuse box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 29
G