2004 JAGUAR XJ trunk

6 - 10 Roadside Emergency
!WARNING:
1. Do not attempt to lift the vehicle unless the jack head is fully
engaged in the jacking point.
2. Ensure that the parkbrake is applied.
Place the jack squarely beneath the
appropriate jacking point. Ensure that the
jack head is fully engaged. Carefully raise
the vehicle by turning the handle.
Stop jacking the vehicle when the tyre
just clears the ground. Minimum tyre lift
gives maximum vehicle stability.
Remove the wheel nuts and the wheel.
Centre badge
When changing the alloy road wheels,
transfer the centre badge to the
replacement wheel. Using the plastic
tipped end of the wheel nut wrench
handle from the inside of the wheel, push
the centre badge from its housing.
Push the centre badge into the
replacement wheel. Fitting the spare wheel
Fit the spare wheel and loosely secure
with the wheel nuts.
Using the wheel nut wrench, lightly
tighten the wheel nuts
alternately using
the sequence shown in the illustration.
Lower the jack and ti ghten the wheel nuts
alternately, DO NOT OVER TIGHTEN.
At the earliest opportunity have the
wheel nuts tightened with a torque
wrench to 92 lb.ft (125 Nm).
This torque must not be exceeded. Stowing the equipment
Stow the replaced road wheel in the
trunk.
Check that the locking ring is unscrewed
fully so that it is as close as possible to the
handle of the wheel retainer. This is to
ensure that the wheel retainer can be
fitted correctly.
Locate the wheel retainer into its mating
thread in the trunk floor and tighten it
fully, then tighten the locking ring
clockwise to secure the wheel.
Seepage6-8.
Stow the jacking equipment.
Close the trunk floor panel.
!WARNING:
When a temporary spare wheel is
fitted, drive with caution and replace
with the specified wheel and tyre as
soon as possible.

Roadside Emergency 6 - 13
Towing Eye
A screw-in towing eye is provided in the
trunk with the jack and can be fitted to
the front or rear of the vehicle.
The towing eye has a left-hand thread
and must be turned in an anti-clockwise
direction when fitting.
Caution:
1. The towing eye is not suitable for ‘solid bar’ towing.
2. Care must be taken to avoid damaging the bumpers and front
apron. Front tow point
The front tow point is located behind a
plastic cover (shown
above) on the left-
hand side of the vehicle, as viewed from
the front.
To remove the cover, unclip the top edge,
pivot down and unclip the bottom edge.
Screw the towing ey e into the vehicle,
right up to the shoulder, turning anti-
clockwise.
To refit the cover (towing eye removed)
first clip the lower edge to the bumper
aperture, pivot up and press the top edge
into position. Rear tow point
!WARNING:
Avoid body contact with a hot
exhaust pipe when fitting the eye to
the rear towing point.
The rear tow point is alongside the left-
hand exhaust pipe.
Screw the towing eye into the vehicle,
right up to the shoulder, turning anti-
clockwise.

Roadside Emergency 6 - 19
Rear light assembly – bulb renewal
On the rear light assemblies, only the direction indicator,
reverse and fog bulbs are replaceable. The stop/tail lamps
consist of arrays of LED lights which can only be renewed by a
Jaguar Retailer if they fail to operate.
Ensure that the lights and ig nition switch are OFF before
removing any bulbs.
Open the trunk and secure the floor panel in the open position.
See page 6 - 4.
Rotate fastener ( A) a quarter turn and remove. Pull back the
side carpet trim to access the rear of the light assembly.
The bulb positions are:
1. Reverse light, type P21W.
2. Direction indicator, type PY21W.
3. Fog light, type P21W.
Rotate the bulb/connector and wi thdraw it from the assembly.
Remove the faulty bulb and fit a new one of the correct type,
as illustrated on the bulb holder. It is essential to fit the correct
type.
Reposition the bulb/connector and turn it to secure.
Carefully refit the side carpet trim. Fit fastener ( A) and rotate a
quarter turn.
Close the trun k floor panel.

Roadside Emergency 6 - 21
Fuses and Fuse Boxes
Do not fit a new fuse if the wiring is
damaged; contact a Jaguar Retailer.
After renewing a fuse have the circuit
checked by a Jaguar Retailer.
Two types of fuses are fitted in the fuse
boxes, ATO type and Midi type.
Spare fuses and a special tool for
removing and replacing fuses are located
on a removable panel clipped to the rear
of the trunk ( A).
Use only the spare fuses supplied. If a
spare fuse is used, renew it with a Jaguar
approved fuse of the same amperage
rating.
Checking and Renewing a
Blown Fuse
Make sure the new fuse is the correct
rating (amperage).
Fuses are colour coded according to the
amperage and the rating is also marked
on each fuse.
Caution: When a fuse box lid is
removed, take care to protect the box
from moisture, and refit the lid at the
earliest opportunity. ATO-fuse replacement
Push the tool on to the suspect ATO fuse
and withdraw the fuse. If the wire in the
fuse is broken, the fuse has blown.
Fit a new fuse using the tool.
Midi fuse replacement
(not shown)
Unscrew the two nuts and remove the
fuse. Note that the fuse is supplied
directly from the battery +ve; take care
not to short a spanner or other metal tool
to the chassis when removing the nuts.!WARNING:
1. Do not fit a fuse of a different amperage from that removed.
The electrical circuits may
become overloaded with the
subsequent possibility of a fire.
2. No attempt should be made to repair a fuse that has blown as this
may cause a fire hazard or serious
damage elsewhere in the
electrical circuit.

6 - 22 Roadside Emergency
Fuse Box Locations
There are three separate fuse boxes fitted
to the vehicle, each one containing fuses
protecting a different group of circuits.
Engine compartment fuse box
The fuse box is located in the engine
compartment on the right-hand side
adjacent to the windscreen wash
reservoir.
Remove the fuse box lid by pressing the
spring catch and lifting.
When refitting, press the fuse box lid in
the area of the retaining lugs until the lid
engages. Cabin fuse box
The cabin fuse box is located behind the
right-hand side trim panel in the footwell.
To access the fuse box, pull out the
bottom of the trim panel (arrowed), slide
the panel down slightly and remove.
Trunk fuse box
A fuse box is located in the trunk,
situated behind the battery.
Open the trunk floor panel to gain access
to the fuse box.
Remove the fuse box lid by pulling the
retaining clips and pulling the lid
upwards.
Reposition the lid and press down until
the retaining clips engage.
Replace the floor panel.

Roadside Emergency 6 - 23
Fuse Positions
A – Trunk fuse box
B – Cabin fuse box
C – Engine compartment fuse box

6 - 26 Roadside Emergency
Cabin fuse boxFuse No Fuse
Type Rating
(amps) Colour
Circuit
F1 ATO 10A Red Climate control unit, fan, screen heaters and wiper relay coils, smog sensor
F2 ATO 5A Tan Radiator fan controller, cruise control switch, adaptive cruise control
F3 ATO 5A Tan Rear outer seat, electrochromic mirror, driver seat heater, electric parkbrake, left and right-hand HID lamps levelling, left and right-hand seat belt switches
F4 ATO 5A Tan Instrument cluster
F5 – F6 Not used
F7 ATO 5A Tan Cigar lighter, sunroof module, electric park brake switch illumination, accessory relays (trunk fuse box)
F8 ATO 5A Tan Instrument cluster
F9 ATO 10A Red Left-hand direction indicator and repeater
F10 ATO 5A Tan Glove compartm ent door motor and lamps
F11 ATO 5A Tan Radio muting (engine start), ignition feed
F12 ATO 10A Red Front electronic module (FEM), passenger mirror
F13 ATO 20A Yellow Rear electronic module (REM), door locks
F14 ATO 10A Red Courtesy light, footwell lamps, rain sensor, FEM
F15 ATO 5A Tan ECM, FEM, instrument cluster air bag fa ult lamp, instrument cluster ignition (run/start)
F16 ATO 5A Tan Diagnostic connector

Roadside Emergency 6 - 29
Trunk fuse boxFuse No Fuse
Type Rating
(amps) Colour
Circuit
F1 – F4 Not used
F5 ATO 40A Orange Right-hand front seat
F6 ATO 10A Red Accessory connector
F7 ATO 40A Orange Front blower motor
F8 ATO 10A Red Heater circuit water pump
F9 ATO 25A Natural Rear seat motors
F10 Not used
F11 ATO 5A Tan Rear footwell lamps, grab handle lamps
F12 ATO 10A Red Air suspension
F13 ATO 20A Yellow REM, rear seat heaters
F14 Not used
F15 ATO 5A Tan Right-hand rear light cluster
F16 ATO 10A Red Trunk lights, driver seat switch pack, rear switch seat pack
F17 ATO 10A Red Left-hand rear fog and reversing lamps
F18 ATO 10A Red Number plate lamps, side marker lamps
F19 ATO 30A Green Heated rear window