UNIT REPAIR (JR405E) 7A4-83
Torque: 5.5 N
m (48 Ib
in)
Remove the holding fixture from the transmission case.
RTW47ASH001001
23.Speed sensor and turbine sensor
Apply ATF to the new O-rings and install them the speed
sensor (2) and the turbine sensor (3).
Install the speed sensor and the turbine sensor. Tighten
the bolt to the specified torque.
Torque: 6 N
m (52 Ib
in)
24.Torque converter
Pour the new ATF into the torque converter.
Shake the torque converter to thoroughly clean the
inside.
Drain the ATF from the torque converter.
Pour the new ATF into the torque converter.
NOTE:
If significant amounts of foreign material (clutch facing,
metallic fragments, etc.) are found in the automatic
transmission at time of disassembly, the existing torque
converter must be replaced with a new one.
RTW47ASH000901
Install the torque converter.
Measure the torque converter end play (A).
If the measured value is greater than the specified
minimum, the torque converter is correctly installed.
Torque converter end pay (Minimum): 67 mm (2.64
in)
